1994 CHEVROLET CAMARO brake

Downloaded from www.Manualslib.com manuals search engine Problems on the Road
I I
I
Rear Towing Hook-Ups
Attach T-hook chains in front of rear
wheels
in bottom of frame rail on both
sides.
NOTICE:
Do not attach winch cables or "J"
hooks to suspension components
when using car carrier equipment.
Always use T-hooks inserted
in the
T-hook slots.
NOTICE:
Do not tow with sling-type equip-
ment or rear bumper valance will be
damaged.
Use wheel lift or car carrier equip-
ment. Additional ramping may be
required for car carrier equipment.
Use safety chains and wheel straps. 4ttach
a separate
safety chain around
jutboard end
of the rear axle.
NOTICE:
Take care not to damage the brake
pipes and cables.
. . .156

Downloaded from www.Manualslib.com manuals search engine Problems on the Road
3. Shut the engine off and replace the
pressure cap. Be sure the arrows on
the cap line up like this. 10. Then fill the coolant recovery tank
For
a complete drain, flush and refill,
see your Chevrolet dealer or a Chevrolet
Camaro Service Manual.
To purchase a
service manual, see “Service
Publications’’ in the Index.
to
the proper level.
If Q Tire Goes Flat
It’s unusual for a tire to “blow out” while
you’re driving, especially if you maintain
your tires properly. If air goes out of a
tire, it’s much more likely to leak out
slowly. But if
you should ever have a
“blowout,’’ here are a few tips about what
to expect and what to do:
If a front tire fails, the flat tire will create
a drag that pulls the vehicle toward that
side. Take your foot off the accelerator
pedal and grip the steering wheel firmly.
Steer to maintain lane position, then
gently brake to a stop well out of the
traffic lane.
A rear blowout, particularly on a curve,
acts much like
a skid and may require the
same correction you’d use in a skid. In
any rear blowout, remove your foot from
the accelerator pedal. Get the vehicle
under control by steering the way
you
want the vehicle to go. It may be very
bumpy and noisy, but you can still steer.
Gently brake to
a stop, well off the road
if possible.
If your tire goes flat,
the next section
shows how to use your jacking equipment
to change a flat tire safely.
. . ,166

Downloaded from www.Manualslib.com manuals search engine Here you will find information
about the care of your
Chevrolet
. This part begins with
service and fuel information.
and then
it shows how to check
important fluid and lubricant
levels
. There is also technical
information about your vehicle.
and a section devoted to its
appearance care
.
Part 0
Service & Appearance Care
Service .........................................................
Fuel ...........................................................
Checking Things under the Hood ....................................
HoodRelease ..................................................
EngineOil ....................................................
Aircleaner ...................................................
Automatic Transmission Fluid .....................................
Manual Transmission Fluid .......................................
Hydraulic Clutch ...............................................
RearAxle .....................................................
Enginecoolant ................................................
Power Steering Fluid ............................................
Windshield Washer Fluid .........................................
Brake Master Cylinder ...........................................
Battery .......................................................
Bulb Replacement ................................................
LoadingYourVehicle .............................................
Tires ...........................................................
Appearancecare .................................................
Appearance Care and Maintenance Materials ...........................
Vehicle Identification Number (VIN) .................................
Service Parts Identification Label ....................................
Add-on Electrical Equipment .......................................
Fuses and Circuit Breakers .........................................
Replacement Bulbs ...............................................
Capacities and Specifications .......................................
180
181
184
184
187 191
194
196
197
197
198
200
201
202
204
205
212
214
220
226
227
227
227
227
231
232
179 ...

Downloaded from www.Manualslib.com manuals search engine When you open the hood you'll see:
1. Battery
2. Engine Coolant Reservoir
3. Engine Oil Dipstick
4. Automatic Transmission Dipstick
5. Air Cleaner (if equipped)
3.4L L32 (Code S
6. Oil Fill Cap
7. Brake Fluid Reservoir
8. Power Steering Reservoir
9. Windshield Washer Reservoir
10. Engine Fan
11. Clutch Fluid Reservoir (if equipped)
L
185 ...

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
5.7L LT1 (Code P)
Vhen you open the hood you’ll see:
1. Battery
2. Engine Coolant Reservoir
3. Engine Oil Dipstick
4. Automatic Transmission Dipstick
5. Air Cleaner
(if equipped)
6. Oil Fill Cap
7. Brake Fluid Reservoir
8. Power Steering Reservoir
9. Windshield Washer Reservoir
10. Engine Fans
11. Clutch Fluid Reservoir (if equipped) Before
closing the hood, be sure all the
filler
caps are on.
Then just pull the hood down and close
it firmly.
. . .186

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
Automatic Transmission FIuid
When to Check and Change:
A good time to check your automatic
transmission fluid level is when the
engine oil is changed. Refer to the
Maintenance Schedule to determine when
to change your fluid. See “Scheduled
Maintenance Services” in the Index.
How to Check:
Because this operation can be a little
difficult, you may choose to have this
done at a Chevrolet dealership Service
Department.
If
you do it yourself, be sure to follow all
the instructions here, or
you could get a
false reading on the dipstick.
NOTICE:
Too much or too little fluid can dam-
age your transmission.
Too much can
mean that some of the fluid could
come out and fall on hot engine parts
or exhaust system, starting a fire. Be
sure to get an accurate reading if you
check your transmission fluid.
. . ,194
Wait at least 30 minutes before checking
the transmission fluid level
if you have
been driving:
When outside temperatures are above
90°F (32°C).
0 At high speed for quite a while.
0 In heavy traffic - especially in hot
weather.
While pulling a trailer.
To get the right reading, the fluid should
be at normal operating temperature,
which is 180°F to
200°F (82°C to 93°C).
To check transmission fluid hot: Get
the vehicle warmed up
by driving
about
15 miles (24 km) when outside
temperatures are above 50°F (10°C). If
it’s colder than
50°F (lO”C), drive the
vehicle
in “D” (Third Gear) until the
engine temperature gage moves and then
remains steady for ten minutes. Then
follow the hot check procedures.
To check transmission fluid cold: A cold
check is made after the vehicle has been
sitting for eight hours or more with the
engine off and is used only as a reference.
Let the engine run at idle for five minutes
if outside temperatures are 50°F
( 10°C)
or more. If it’s colder than 50°F (lO”C),
you may have to idle the engine longer. Should the fluid level
be
low during a
cold check, you must perform a hot check
before adding fluid This will give you a
more accurate reading
of the fluid level.
To check the fluid hot or cold:
Park your vehicle on a level place.
With the parking brake applied, place
With your foot on the brake pedal,
the shift lever
in
“P’ (Park).
move the shift lever through each gear
range, pausing for about three seconds in each range. Then, position the shift
lever in
“F’” (Park).
minutes or more.
Let the engine run at idle for three

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
NOTICE:
0
0
0
0
When using concentrated washer
fluid, follow the manufacturer’s
instructions for adding water.
Don’t mix water with
ready-to-use washer fluid. Water
can cause the solution
to freeze
and damage your washer fluid
tank and other parts of the washer
system. Also, water doesn’t clean
as well as washer fluid.
Fill your washer fluid tank only
314 full when it’s very cold. This
allows for expansion, which could
damage the tank
if it is completely
full.
Don’t use radiator antifreeze in
your windshield washer.
It can
damage your washer system and
paint.
r
#
-
I
E
fi
T
fl
g
g
n
li
b
1€
Yi
si
Y
u
3rake Masfer Cylinder
‘our brake master cylinder is here. It is
dled with DOT-3 brake fluid.
‘here are only two reasons why the brake
luid level
in your master cylinder might
o down. The first is that the brake fluid
oes down to an acceptable level during
ormal brake lining wear. When new
nings
are put in, the fluid level goes
ack
up. The other reason is that fluid is
:aking
out of the brake system. If it is,
ou should have your brake system fixed,
mce a leak means that sooner or later
our brakes won’t work well, or won’t
lork at all.
So, it isn’t a good idea to “top off’ your
brake fluid. Adding brake fluid won’t
correct a leak. If you add fluid when your
linings are worn, then you’ll have too
much fluid when you get new brake
linings.
You should add (or remove)
brake fluid, as necessary, only when work
is done on the brake hydraulic system.
Refer to the Maintenance Schedule to
determine when to check your brake
fluid. See “Periodic Maintenance
Inspections” in the Index.
. . .1u1

Downloaded from www.Manualslib.com manuals search engine To Check Brake Fluid:
You can check the brake fluid without
taking off the cap. Just look at the brake
fluid reservoir. The fluid level should be
above the plastic seam
in the reservoir.
If it isn’t, have your brake system
checked to see
if there is a leak.
After work is done on the brake hydraulic
system, make sure the level
is above the
plastic seam, near the base of the filler
neck.
What to Add:
When you do need brake fluid, use only
DOT-3 brake fluid
- such as Delco-
Supreme 1 l@ (GM Part No. 1052535).
Use new brake fluid from a sealed container
only, and always clean the brakt
fluid reservoir cap before removing it.
NOTICE:
0 Don’t let someone put in the
wrong kind
of fluid. For example,
just a few drops
of mineral-based
oil, such as engine oil, in your
brake system can damage brake
system parts
so badly that they’ll
have to be replaced.
0 Brake fluid can damage paint, so
be careful not to spill brake fluid
on your vehicle.
If you do, wash it
off immediately. See ”Appearance
Care”
in the Index.
Brake Wear
Unless you have the four-wheel disc
brake option, your Chevrolet has front
disc brakes and rear drum brakes.
Disc brake pads have built-in wear
indicators that make
a high-pitched
warning sound when the brake pads are
worn and new pads are needed. The
sound may come and go or be heard all
the time your vehicle is moving (except when
you are
pushing on the brake pedal
firmly).
A CAUTION:
The brake wear warning sound
means that sooner or later your
brakes won’t work well. That could
lead to an accident. When you hear
the brake wear warning sound, have
your vehicle serviced.
NOTICE:
Continuing to drive with worn-out
brake pads could result in costly
brake repair.
Some driving conditions or climates may
cause
a brake squeal when the brakes are
first applied or lightly applied. This does
not mean something is wrong
with your
brakes.
203. I