1992 HONDA PRELUDE Owners Manual

Lights

Replacing a Rear License
Bulb

1. Remove the two screws and remove the license light assem-

bly.
2. Remove the lens from the rubber
seal and the metal
cover.
3. Pull the bulb straight out of its
socket. Push the new bulb in
until it bottoms in
the socket.4. Turn on the parking lights and
check that the new bulb is

working.

5. Reinstall the cover and the lens.
Put the license light assembly in
place. Reinstall the two screws
and tighten them securely.
Replacing
Interior and Trunk
Light Bulbs

1. Remove the lens by carefully

prying on the edge of the lens in
the middle with a fingernail file
or a small flat-tip screwdriver.
Do not pry on the edge of the
housing around the lens.

CONTINUED

Maintenance

INTERIOR
LIGH
TProCarManuals.comMain Menu Table of Contents s t

Lights

2. Remove the bulb by pulling it straight out of its metal tabs.
3. Push the new bulb into the metal tabs. Snap the lens back in place.

Maintenance

TRUNK LIGHTProCarManuals.comMain Menu Table of Contents s t

Storing Your Car
If you need to park your car for an
extended period (more than 1
month), there are several things
you should do to prepare it for
storage. Proper preparation helps
prevent deterioration and makes it
easier to get your car back on the
road. It is best to store your car indoors if at all possible. Fill the gas tank.
Change the engine oil and filter

(see page 137).

Wash and dry the exterior
completely.
Clean the interior. Make sure the
carpeting, floor mats, etc. are
completely dry.
Leave the parking brake off. Put
the transmission in Reverse (5-
speed) or Park (automatic). Block the rear wheels.
If the car is to be stored for a
longer period, it should be
supported on jackstands so the
tires are off the ground.
Leave one window open slightly
(if the car is being stored indoors).
Disconnect the battery.
Cover the car with a "breathable" car cover, one made
from a porous material such as
cotton. Nonporous materials,
such as plastic sheeting, trap
moisture which can damage the
paint. If possible, run the engine for a
while periodically (preferably once a month). If you store your car for 12 months
or longer, have your Honda dealer
perform the inspections called for
in the 24 months/48,000 km (30,000
miles) maintenance schedule as
soon as you take it out of storage
(see page 133). The replacements
called for in the maintenance
schedule are not needed unless the
car has actually reached that time or mileage.

MaintenanceProCarManuals.comMain Menu Table of Contents s t

Appearance Care

Regular cleaning and polishing of
your Honda helps to keep it "new"
looking. This section gives you
hints on how to clean and preserve
your car's appearance: the paint,
brightwork, wheels and interior. Also included are several things
you can do to help prevent corro-

sion.

Exterior Care................................ 176 Washing..................................... 176
Waxing....................................... 177
Aluminum Wheels................... 177
Paint Touch-up......................... 178
Interior Care.................................. 179 Carpeting................................... 179
Fabric........................................ 179

Vinyl........................................... 179

Seat Belts.................................. 179

Windows..................................... 180

Air Fresheners.......................... 180
Corrosion Protection................... 180
Body Repairs................................. 181
Appearance CareProCarManuals.comMain Menu s t

Exterior Care

Washing
Frequent washing helps preserve
your car's beauty. Dirt and grit can
scratch the paint, while tree sap
and bird droppings can perma-
nently ruin the finish.
Wash your car in a shady area, not
in direct sunlight. If the car is
parked in the sun, move it into the
shade and let the exterior cool
down before you start.
Chemical solvents and strong
cleaners can damage the paint,
metal and plastic on your car. Only
use the solvents and cleaners
recommended in this Owner's
Manual.
Rinse the car thoroughly with
cool water to remove loose dirt.
Fill a bucket with cool water.
Mix in a mild detergent, such as
dishwashing liquid or a product
made especially for car washing.
Wash the car, using the water and detergent solution and a soft-bristle brush, sponge or soft cloth.
Start at
the top and work your
way down. Rinse frequently.
Check the body for road tar, tree
sap, etc. Remove these stains
with tar remover or turpentine.
Rinse it off immediately so it
does not harm the finish. Remem-
ber to re-wax these areas, even if the rest of the car does not need
waxing. When you have washed and
rinsed the whole exterior, dry it
with a chamois or soft towel.
Letting it air-dry will cause
dulling and water spots.
As you dry the car, inspect it for
chips and scratches that could allow corrosion to start. Repair
them with touch-up paint (see page
178).

Appearance Care

NOTICEProCarManuals.comMain Menu Table of Contents s t

Exterior Care

Waxing

Always wash and dry the whole car
before waxing it. You should wax your car, including the metal trim,
whenever water sits on the surface in large patches. It should form into
beads or droplets after waxing.
You should use a quality liquid orpaste wax. Apply it according to
the instructions on the container. In
general, there are two types of products:
Waxes — A wax coats the finish and protects it from damage by
exposure to sunlight, air pollution,
etc. You should use a wax on yourHonda when it is new.
Polishes — Polishes and cleaner/
waxes can restore the shine to
paint that has oxidized and lost
some of its shine. They normally
contain mild abrasives and solvents
that remove the top
layer of the
finish. You should use a polish on
your Honda if the finish does not
have its original shine after using a
wax.
Cleaning tar, insects, etc.
with
removers also takes off the wax.
Remember to re-wax those areas,
even if the rest of the car does not

need waxing.
Aluminum
Wheel
s

Clean your Honda's aluminum alloy
wheels as you do the rest of the exterior. Wash them with the same
solution, and rinse them thoroughly.
The wheels have a protective clear-
coat that keeps the aluminum from
corroding and tarnishing. Using
harsh chemicals, including some
commercial wheel cleaners, or stiff
brushes can damage this clear-coat.
Only use a mild detergent and soft
brush or sponge to clean the wheels.

Appearance CareProCarManuals.comMain Menu Table of Contents s t

Exterior Care

Paint Touch-up

Your dealer has touch-up paint to match your car's color. The color
code is printed on a sticker on the
driver's door jamb. Take this code
to your dealer so you are sure to
get the correct color.
Inspect your car for chipped or
scratched paint every time you
wash it. Repair it as soon as possible to prevent corrosion. Use
the touch-up paint on small chips and scratches. More extensive
damage should be repaired by a

professional.
Examine the chip or scratch closely
before repairing it. If it does not go
down to bare metal, clean it with
soap and water and apply the
touch-up paint. If it does go to the
metal, apply a coat of primer first.
After this dries, apply the touch-up paint. Build up the paint in the
damaged area to the level of the
surrounding paint. Several thin
coats of paint are better than one
thick coat.

Appearance Care
TOUCH-UP
PAINTProCarManuals.comMain Menu Table of Contents s t

Interior Care

Carpeting

Vacuum the carpeting frequentlyto remove dirt. Ground-in dirt will
make the carpet wear
out faster.
Periodically shampoo the carpet to
keep it looking new. Use one of the
foam-type carpet cleaners on the
market. Follow the instructions
that come with the cleaner, apply-
ing it with a sponge or soft brush.
Keep the carpeting as dry as possi-
ble by not adding water to the foam.

Fabric

Vacuum dirt and dust out of the material frequently. For general
cleaning, use a solution of mild soap and lukewarm water, letting it air
dry. To clean off stubborn spots,
use a commercially-available fabric
cleaner. Test it on a hidden area of
the fabric first, to make sure it does
not bleach or stain the fabric.
Follow the instructions that come
with the cleaner.
Vinyl

Remove dirt and dust with a
vacuum cleaner. Wipe the vinyl
with a soft cloth dampened in a solution of mild soap and water.
Use the same solution with a soft-
bristle brush on more difficult spots.
You can also use commercially- available spray or foam-type vinyl

cleaners.

Seat Belts

If your seat belts get dirty, you can
use a soft brush to clean them with
a mixture of mild soap and warm
water. Do not use bleach, dye, or
cleaning solvents. They can
weaken the belt material. Let the
belts air-dry before you use the car. Dirt build-up in the metal loops of
the seat belt anchors can cause the
belts to retract slowly. Wipe the inside of the loops with a clean
cloth dampened in isopropyl alcohol.

Appearance Care

METAL LOOPProCarManuals.comMain Menu Table of Contents s t