ON±VEHICLE INSPECTION
CHECK IDLE±UP
SR0FZ±04
1. WARM UP ENGINE
2. TURN AIR CONDITIONER SWITCH OFF
3. CHECK IDLE±UP
(a) Fully turn the steering wheel.
(b) Check that the engine rpm decreases when the air controlvalve hose is pinched.
(c) Check that the engine rpm increases when the air control valve hose is released.
FLUID LEVEL CHECK
SR0G0±03
1. KEEP VEHICLE LEVEL
2. BOOST FLUID TEMPERATUREWith the engine idling at 1,000 rpm or less, turn the steering
wheel from lock to lock several times to boost fluid tempera-
ture.
Fluid temperature:
805C (176 5F)
3. STOP ENGINE
4. CHECK FOR FOAMING OR EMULSIFICATION
HINT: Foaming and emulsification indicate either the exis-
tence of air in the system or that the fluid level is too low.
5. CHECK FLUID LEVEL IN OIL RESERVOIR Check the fluid level and add fluid if necessary.
Fluid:
ATF DEXRON
[ II
HINT: Check that the fluid level is within the HOT LEVEL of
the dipstick of the reservoir cap. If the fluid is cold, check that
it is within the COLD LEVEL of the dipstick.
±
STEERING POWER STEERINGSR±113
WhereEverybodyKnowsYourName
POWER STEERING SYSTEM BLEEDING
SR0G2±04
1. CHECK FLUID LEVEL IN OIL RESERVOIRCheck the fluid level and add fluid if necessary.
Fluid:
ATF DEXRON
[ II
HINT: Check that the fluid level is within the HOT LEVEL of
the dipstick of the reservoir cap. If the fluid is cold, check that
it is within the COLD LEVEL of the dipstick.
2. START ENGINE AND TURN STEERING WHEEL FROM LOCK TO LOCK 3 OR 4 TIMES
With the engine speed below 1,000 rpm, turn the steering
wheel to left or right full lock and keep it there for 2±3 se-
conds, then turn the wheel to the opposite full lock and keep
it there for 2±3 seconds.
3. CHECK THAT FLUID IN OIL RESERVOIR IS NOT FOAMY OR CLOUDY AND DOES NOT RISE OVER MAXIMUM
WHEN ENGINE IS STOPPED
Measure the fluid level with the engine running. Stop the en-
gine and measure the fluid level.
Maximum rise:
5 mm (0.20 in.)
If a problem is found, repeat fluid replacement on page
SR±114. Rep air the PS if the problem persists.
OIL PRESSURE CHECK
SR0G3±03
1. CONNECT PRESSURE GAUGE
(a) Using SST, disconnect the pressure line joint.SC 400:
SST 09631±22020
±
STEERING POWER STEERINGSR±115
WhereEverybodyKnowsYourName
