1990 VOLVO 240 ESP

Volvo 1990 240 Model

All tail lamp bulbs are replaced from inside of trunk.
1 Unscrew and remove tail lamp inside cover. Note that inside cover is h\
ooked at the upper edge. Lift
the lower end out up and unhook upper edge.
2 Turn bulb holder approx 3,8" (1 cm) counterclockwise and remove it. \

3 Depress bulb n bulb holder turn it slightly counterclockwise and remov\
e it.
4 Install a new bulb Install bulb holder in tail lamp.
NOTE: One of the bulb holder tabs is wider and fits only in correspondin\
g
recess.

Turn bulb holder clockwise. Check that bulb lights Replace tail lamp ins\
ide cover.


Power
Power
Bulbs CP W Socket US Bulb
No
1 Rear fog light 32 21 Ba 15s 1156
2 Back-up light 32 21 Ba 15s 1156
file:///K|/ownersdocs/1990/1990_240/90240_16.htm (3 of 10)12/30/2006 8\
:25:10 AM

Volvo 1990 240 Model
cloth.
CAUTION: It is particularly important to wash the car frequently in the \
winter time, to prevent
corrosion, when salt has been used on the roads. Also wash off the dirt \
on the underside (Wheel
housings and fenders etc.)
WARNING: When the car is driven immediately after being washed, carefull\
y apply the brakes
several times in order to remove any moisture from the brake linings.
pg. 87 Washing, Cleaning, Anti-rust treatment
Automatic washing - simple and quick

An automatic wash is a simple and quick way to clean your car, but it is\
worth remembering that it can
never be as thorough as when you yourself go over the car with sponge an\
d water. Keeping the
underbody clean is most important, especially in the winter. Some automa\
tic washers do not have
facilities for washing the underbody.
Before driving into an automatic wash, make sure that side view mirrors,\
auxiliary lamps, etc., are
secure, otherwise there is risk of the machine dislodging them. You shou\
ld also lower the antenna.
We recommend that you do not wash your car in an automatic wash during t\
he first six months (because
the paint will not have hardened sufficiently).

Bird droppings /Tree sap

Remove from paintwork as soon as possible. Otherwise the finish may be p\
ermanently damaged.

Chromed parts

Chromium-plated and anodized parts should be washed with clean water as \
soon as they become dirty.
This is particularly important if you drive on gravel roads or on roads \
where salt is used during the
winter. After the car has been washed, apply wax or an anti-rust prepara\
tion.
Stains on chrome trim can be removed with commercially available chrome \
cleaner. Do not use abrasive
compounds or steel wool.
file:///K|/ownersdocs/1990/1990_240/90240_18.htm (2 of 8)12/30/2006 8:\
25:11 AM

Volvo 1990 240 Model
The floor mats should be vacuumed or brushed clean regularly, especially\
during the winter when they
should be taken out for drying.
Spots on textile mats can be removed with a mild detergent.

Anti-rust treatment

Your Volvo has been rust protected at the factory. On external surfaces \
a heavy coat of wear resistant
material has been used, while on the internal surfaces a lighter rust in\
hibitor is used.
The rust protection should be inspected regularly by your authorized Vol\
vo dealer. Consult the Volvo
Protection Limited Warranty found in your Warranty Information Booklet f\
or additional terms and
conditions.

For further information, see section titled "What causes rust" or see yo\
ur Volvo dealer. pg. 88 Paint touch-up
Paint touch-up

Paint damage requires immediate attention to avoid rusting. Make it a ha\
bit to check the finish regularly,
for instance when washing the car. Touch-up if necessary.

Paint repairs require special equipment and skill. Contact your Volvo de\
aler for any extensive damages.

Minor scratches can be repaired by using Volvo touch-up paint.
Note: When ordering touch-up paint from your Volvo dealer, use the paint\
code indicated on the
service label. The label is located on the wheel housing in the engine c\
ompartment.

Minor stone chips and scratches

Material:
Primer-can
Paint-can or touch-up bottle
file:///K|/ownersdocs/1990/1990_240/90240_18.htm (4 of 8)12/30/2006 8:\
25:11 AM

Volvo 1990 240 Model
Possible cause Correction
Spark plugs
fouled. Drive the vehicle in a lower gear and keep the engine rpm higher for a f\
ew miles
in order to remove carbon deposit on the spark plugs. If this procedure \
is not
effective, clean or replace the spark plugs.
pg. 96 Label information
The Vehicle Identification Number should always be quoted in all corresp\
ondence concerning your
vehicle with the dealer and when ordering parts.

1 Vehicle Identification Number (VIN)
VIN plate is located on top left surface of dash. The VIN is also stampe\
d on the right hand door pillar.

2 Vehicle Emission Control Information
Your Volvo is designed to meet all applicable safety and emissions stand\
ards. Evidence of this can be
verified from the certification label on the left wheel valance. For fur\
ther information regarding these
regulations, please consult your Volvo dealer.

3 Model Plate
Vehicle Identification Number (VIN). Codes for color and upholstery et\
c. This plate is located on right
wheel valance.

4 Loads, Capacities, and Tire Pressures

5 Federal Motor Vehicle Safety Standards
(FMVSS) specifications (USA) and Ministry of Transport (CMVSS) Sta\
ndards (Canada)
This label is located on rear facing side of the driver's front door.

file:///K|/ownersdocs/1990/1990_240/90240_19.htm (6 of 7)12/30/2006 8:\
25:13 AM