1990 MAZDA 232 clutch

t .-
1
CLUTCH UNIT H
REMOVAL I fNSTALLATION
l Remove the clutch release cylinder with the clutch pipe connected.
- Do not remove the pilot bearing if not necessary.
f . Remove in the order shown in the figure, referring to Removal Note.
2. Instal! in the reverse order of removal, referring to Installation Note.
-761 BP SOHC
,E+--l BP DOHC TURBO
-; (MORI Wl-llTE TA No.2 OR
B EQUIVALENT ORGANIC
MOLYBDENUM GREASE)
1. Clutch release cylinder
2. Transaxle
Service ~......-...tl.*I.*-......*,,.**..l....... Section J3
3. Bout
4. Release bearing
5. Clutch release fork
6. Clutch cover
Removal Note _....._._._.-..._....___.._. page H-20
lnstaflation Note .._.......-..._.. . .._..._. page H-21 7. Clutch disc
Removal Note . . . . . . . .._...
Installation Note.. . . . . . . . . .
8. Pilot bearing
Removal Note . . . . . . . . . .._.
1 nstatlation Note.. . . . . __ . _.
9. Flywheel
Removal Note . . . . . . . . . . . . .
Installation Note . . . . . . . . . . . *..*.
w....
*.*..
-....
. . . . .
. . . . ..*.a.*.
page H-20
.,..I.._ page H-21
.**-. ..- page H-20
.,..... -
page H-21
. ..*.-.- page H-20
_...a-.. page H-20
H-19

C1UTCf-f UNtT
9MUOHX-032
I
03UOf-lX-028
I
93GOHX-729
I
i
Removal Note
Clutch cover and disc
1. Install the SST.
2. Loosen each bolt one turn at a time in a crisscross pattern
until spring tension is released. Then remove the ciutch cov-
er and disc.
Pilot bearing
1. Remove the pilot bearing with the
SST if necessary.
Flywheel
Note
l After removing the flywheel, inspect for oil leakage
past the crankshaft rear oil seal.
If necessary, replace the oil seal.
1. Hold the flywheel with the SST.
2. Remove the flywheel.
Instalfation Note
Flywheel
1 -Wipe the bolts clean and apply sealant to the bolt threads.
2. Install the flywheel and SST.
3. Tighten the bolts evenly and gradually in the pattern shown.
Tightening torque:
96403 Nmm (9.8-10.5 m-kg, 71-76 ft.lb)
PiIot bearing
Note
l Install the pilot bearing ftush with the flywheeL
I_ Install the new bearing with the SST.
03UOHX-030
H-20

CLUTCW UNIT
Clutch disc
1. Clean the clutch disc splines and main drive gear spIines;
then apply organic molybdenum grease.
2. Hold
the clutch disc in position with the SST.
Clutch cover
1. Install the SST.
2. Align the
dowel holes with the flywheel dowels.
3. Tighten the
botts evenly and gradually in the pattern shown.
Tightening torque:
18-26 N-m (1.8-2.7 m-kg, 13-20 ft-lb)
EWOHX-040
Ii-21