Page 49 of 77
INSTRUMENT
These parts are made of plastlc, so do not use excessive force and be careful not to damage them
Remove griller by raising pawls umg flatbladed
screwdrwer
Removal. Instrument mmbinatlon wttch instrument comblnatlon [When removtng combination mfner. rwltch
First remove nut securing instrument comblnatlon swltch
basement, then remove lnitrurnent combmatlon swltch
(Instrument combmation witches are secured at hooks and basements 1
BF-49
Page 50 of 77
SEAT
When removing or installing the seat trim, carefully handle it to keep dirt out and avoid damage
Front Driver Seat
MANUAL SEAT
26-36 (2 7.3 7,20 -27)
26 - 36 (2 7.3.7,20 - 271
P
vm 16 -21 (1.6-2 1,12- 151
I
9 1 . 11 8 1093- 1 2.6 7.871
rm
N rn Ikg-rn, ft-lbl
Grease UP points (Do not apply toe much grease as It wlll drtp 1 5
SBF388B
BF-50
Page 51 of 77
SEAT
Front Driver Seat (Cont'd)
Air diagram
AN make
tl if hose mnnemon IS disconnected, apply sealant to hoseconnection to prevent air leakage [@ portion onlv) Install each valve ~n Its proper PoSltlOn
[Yellow marking)
Onewav valve
@ sealant portion
SBF392B
BF-51
Page 52 of 77
SEAT
Front Driver Seat (Cont'd)
POWER SEAT
12 151
SBF3878
BF-52
Page 53 of 77
t IGNITION SWITCH I ON or START
IGNITION RELAY 35M
Big;
(For power window and
CIRCUIT
BREAKER
power seat)
To engine room harness L (Ground1
!
t B
,,-CIRCUIT BREAKER
M [ I
r CIRCUIT BREAKER SEAT SWITCH ~~ (Seat Ilfter. sllde. reclining and
thigh support1
Seat cushion ground
- CIRCUIT BREAKER
in harness
LD m ll W (D W m
SEAT BACK SWITCH
RTR AIR PUMP MOTOR
Seat cushion ground
IRiI
CIRCUIT BREAKER Seat curhian ground -
Page 54 of 77
SEAT
Front Driver Seat (Cont'd)
Air diagram
Lumbar support
Thigh support switch
e
If hose connection 1s disconnected, apply sealant to hose
connection to prevent air leakage I@ portion only) Be sure air pump 1s free from dust. foreign substance, etc
Install safety valve in Its proper direction
Air pump operates only when each swjtch IS turned ON
@ Sealant portion
SBF394B
BF-54
Page 55 of 77
SEAT
Front Assist Seat
Basically, this seat is the same as manual type front driver seat 2 + 2 seater model differs from manual
type front
seat in that walk-in mechanism has been added to it Refer to the description on manual
type driver
seat except for walk-in mechanism
WALK-IN MECHANISM
Release lever
a
Release wire assembly
Release wire adjustment Push down reclining device lever so there IS no play, then adlust the release wire
Releare wme assembly
TO (Seat release back lever frame) Mw
Walk-on wve adjustment When assembling, make sure - there 1s no play left SBF47OB
BF-55
Page 56 of 77
SEAT
Rear Seat
Striker eat back hinge
N rn (kg-m. ft-lbl
SBF395B
BF-56
