Downloaded from www.Manualslib.com manuals search engine If the tires are other than standard load range (or load range B for metric size
tires). the
load range will appear after the tire size stated on the Tire Placard.
Inflation Pressure
The Cold inflation pressures listed on the Tire Placard provide for the best
balance of fuel economy. tire life. riding comfort. and vehicle handling under
normal driving conditions.
These pressures
should be used for all vehicle loading conditions. except When towing a trailer. See. "Trailer Towing in "Belore Driving Your Monte
Carlo." Section 1 of this manuaL
Incorrect tire inflation pressures can. have adverse effects on tire. lije and
vehicle performance. Too low an air preS$urecaul>eS incre
f~lure,. It can result in tire overloading, abnormal tire wear, adverse vehicle handling. and reduced fuel~nomy .. Too high an air pressure can result in
abnormal wear. harsh ride. an.d can increase the chance of damage from road
hazards.
LUGGAGE/CARGO LOAD CAPACITY
Maximum Luggage Compartment Load
Coupe 72 Kilograms (160 Pounds)
"'"~~\"'_"~"""_'","",' NOTICE: Total combined weight of luggage _compartment 16ad •. ·.luggage rack load (when equipped). trailer tongue load and passengers must not exceed the vehicle capacity
weight (shown on the Tire Placard located on the left front door).
· ·' .L' Check tire inflation pressures at least monthly (this includes the spare tire) and whenever your _ vehicle is serviced. When -possible, check tire inflation pressures when'the tires are "cold."
1. The "cold" ttr~inflation pressure is the tire pressure when a vehicle has
not been driven more than one mile. (1.6 kilometers) after Sitting for three
hours or more. This is the most accurate setting.
2. It is normal for tire pressures to increase 30 to 60 kilopascals (4 to 8
pounds per square inch) or more when the tires become hot from driving. If you must set inflation pressures when the tires are not "cold," add 30
kilopascals
(4 pounds per square inch) to the recommended cold pressures on the Tire Placard.
3. For sustained driving at speeds of 75 mph to 85 mph (120 km/h to
140 km/h), in countries where such speeds are allowed by law, cold
inflation
pressures must be increased 20 kPa (3 psi) above the cold
inflation pressures stated on the tire placard up to the maximum for
each load range as listed in the Chart below. Sustained speeds of 75 mph to 85 mph (120 km/h to 140km/h) ar!! not allow!!d when the 20
kPa (3 psi) adjustment Would require the pressures of either the front or
the rear tiles to be greater than the maximum pressure for each load
range listed on the chart below. For speeds faster than 85 mph (140 km/h) follow Caution at th!! beginning of this "tire" section.
5-12
Downloaded from www.Manualslib.com manuals search engine When replacing tires with those not having a TPC Spec. No., you should use
the same size,
load range, and constructiontype (bias, bias-bened, or radial)
as the original tires on your
vehicle . Although ~ is not generaly recommended ,
some alpha-size and metric-size tires can be interchanged. (For size
equivalency, contact your Chevrolet
dealer or a tire dealer) . A different size or
type of tire may affect ride,
handling, speedometer /odometer calibration,
vehicle ground clearance , and tire or tire chain clearance to the body or
chassis .
II replacing only a single tire, it should be paired on the same axle with the least worn tire of the other three.
UNIFORM TIRE QUALITY GRADING
The following information relates to the tire grading system developed by the
National Highway Traffic Safety' Adminlslration which will grade tires by
treadwear, traction and temperature performance.
TREADWEAR
The treadwear grade is a comparative rating based on the wear rate of the tire
when tested under
controlled conditions on a specified government test
course . For example, the tire graded 150 would wear one and a haij (1-1/2)
times as well on the government course as a tire graded 100. The relative
performance of tires depends upon the. actual conditions of their _ use , however ,
and may depart significanlly from the norm due to variations in driving habits , service practices and. differences in road characteristics and climate.
TRACTION -A, B,C
. T~~tr~ction grades, from highest to lowest are: A, B, and C. They represent
the ' fiie'sability to stop on wet pavement as measured under controlled
conditions on specified government test surfaces of asphalt and concrete . A
tire marked C may have poor traction performance .
Warning: Thetr.ction grade assigned to this tire is based on braking (straight-ahead) traction tests and· doellnot include cornerillg (turning) tractlon.
TEMPERATURE -A, B, C
The ·temperature grades are A (the highest), B, andC, representing the tire's
resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditio 'ns on a specified indoor laboratory test wheel.
Sustained 'high temperature can cause the material of the tire to degenerate
and reduce tire
life, and excessive temperature can lead to sudden tire failure .
The grade C corresponds to a level of performance which all passenger car
tires must meet under the Federat Motor Vehicle Safety Standard No.
109 . Grades B and A represent higher levels of performance on the laboratory test
wheel than the minimum required by law.
Warning: The
temperature grade for Ihis tire is established for a tire that
is properly inflated and not overloaded. Excessive speed, underinllaiion, or excessive loading, either separately or in combination, can cause heat
buildup and possible lire failure.
5-16
