2023 HYUNDAI I20 open bonnet
[x] Cancel search: open bonnetPage 117 of 649
4-22
Instrument cluster
Shift to N to start engine
(for smart key system and
Automatic transmission/Dual clutch
transmission)
This warning message is displayed if
you try to start the engine with the shift
button not in the N (Neutral) position.
i Information
< R X F D Q V W D U W W K H H Q J L Q H Z L W K W K H V K L I W
O H Y H U L Q W K H 1 1 H X W U D O S R V L W L R Q
Check BRAKE SWITCH fuse (for
smart key system and Automatic
transmission/Dual clutch
transmission)
This warning message is displayed if the
brake switch fuse is disconnected.
You need to replace the fuse with a new
one. If that is not possible, you can start
the engine by pressing the Engine Start/
Stop button for 10 seconds in the ACC
position.
Door, Bonnet, Tailgate open
indicator
OBC3040012
This warning is displayed if any door
or bonnet or tailgate is left open. The
warning will indicate which door is open
in the display.
CAUTION
Before driving the vehicle, you should
confirm that the door/bonnet/tailgate
is fully closed. Also, check there is no
door/bonnet/tailgate open warning
light or message displayed on the
instrument cluster.
Page 145 of 649
5-4
Convenient features
ACCESSING YOUR VEHICLE
Remote key (if equipped)
OIB034040
Your HYUNDAI uses a remote key, which
you can use to lock or unlock a door
(and tailgate) and even start the engine.
(1) Door Lock
(2) Door Unlock
(3) Tailgate Unlock
Locking
To lock :
1. Close all doors, engine bonnet and
tailgate.
2. Press the Door Lock button (1) on the
remote key.
3. The doors will lock. The hazard
warning lights will blink once. Also,
the outside rearview mirror will fold,
if the User Settings mode on the LCD
display. For more details, refer to “LCD
Display” in chapter 4.
4. Make sure the doors are locked by
checking the position of the door lock
button inside the vehicle.
WARNING
Do not leave the keys in your
vehicle with unsupervised children.
Unattended children could place the
key in the ignition switch and may
operate power windows or other
controls, or even make the vehicle
move, which could result in serious
injury or death.
Unlocking
To unlock:
1. Press the Door Unlock button (2) on
the remote key.
2. The doors will unlock. The hazard
warning lights will blink two times.
Also, the outside rearview mirror will
unfold, if the User Settings mode on
the LCD display. For more details,
refer to “LCD Display” in chapter 4.
i Information
After unlocking the doors, the doors will
lock automatically after 30 seconds unless
a door is opened.
Tailgate unlocking
To unlock:
1. Press the Tailgate Unlock button (3)
on the remote key for more than one
second.
2. The hazard warning lights will blink
two times. Once the tailgate is opened
and then closed, the tailgate will lock
automatically.
i Information
Page 160 of 649
5-19
05
This system helps to protect your vehicle
and valuables. The horn will sound and
the hazard warning lights will blink
continuously if any of the following
occur:
- One of the doors is opened without
using the remote key or smart key.
- The tailgate is opened without using
the remote key or smart key.
- The engine bonnet is opened.
The alarm continues for 30 seconds,
then the system resets. To turn off the
alarm, unlock the doors with the remote
key or smart key.
The Theft Alarm System automatically
sets 30 seconds after you lock the doors
and the tailgate. For the system to
activate, you must lock the doors and
the tailgate from outside the vehicle
with the remote key or smart key or by
pressing the button on the outside of the
door handles with the smart key in your
possession.
The hazard warning lights will blink and
the chime will sound once to indicate
the system is armed.
Once the security system is set, opening
any door, the tailgate, or the bonnet
without using the remote key or smart
key will cause the alarm to activate.
The Theft Alarm System will not set if the
bonnet, the tailgate, or any door is not
fully closed. If the system will not set,
check the bonnet, the tailgate, or the
doors are fully closed.
Do not attempt to alter this system or
add other devices to it.i Information
Page 177 of 649
5-36
Convenient features
Bonnet
Opening the bonnet
OBC3N051010AU
1. Park the vehicle and set the parking
brake.
2. Pull the release lever to unlatch the
bonnet. The bonnet should pop up
slightly.
OBC3050023
3. Go to the front of the vehicle, raise the
bonnet slightly, push the secondary
latch up (1) inside of the bonnet centre
and lift the bonnet (2).
OBC3N050012
4. Pull out the support rod from the
bonnet.
5. Hold the bonnet opened with the
support rod.
WARNING
Support rod
[ After driving, the engine
compartment and support rod will be
hot. Grasp the support rod in the area
wrapped in plastic to prevent burns.
[ The support rod must be inserted
completely into the hole provided
whenever you inspect the engine
compartment. This will prevent the
bonnet from falling and possibly
injuring you.
BONNET
Page 178 of 649
5-37
05
Closing the bonnet
1. Before closing the bonnet, check the
following:
[ $ O O I L O O H U F D S V L Q H Q J L Q H F R P S D U W P H Q W
must be correctly installed.
[ * O R Y H V U D J V R U D Q \ R W K H U
combustible materials must
be removed from the engine
compartment.
2. Return the support rod to its clip
location for preventing it from rattling.
3. Lower the bonnet halfway (lifted
approximately 30cm from the closed
position) and push down to securely
lock in place. Then double check to be
sure the bonnet is secure.
If the bonnet can be raised slightly, it
is not securely locked. Open it again
and close it with more force.
WARNING
[ Before closing the bonnet, ensure
all obstructions are removed from
around the bonnet opening.
[ Always double check to be sure
that the bonnet is firmly latched
before driving away. Check there
is no bonnet open warning light or
message displayed on the instrument
cluster. Driving with the bonnet
opened may cause a total loss of
visibility, which might result in an
accident.
[ Do not move the vehicle with the
bonnet in the raised position, as
vision is obstructed, which might
result in an accident, and the bonnet
could fall or be damaged.
Tailgate
Opening the tailgate
OBC3050025
[ 7 K H W D L O J D W H L V O R F N H G R U X Q O R F N H G
when all doors are locked or unlocked
with the remote key, smart key or
central door lock/unlock switch.
[ , I X Q O R F N H G W K H W D L O J D W H F D Q E H
opened by pulling up the tailgate
outside handle.
i Information
, Q F R O G D Q G Z H W F O L P D W H V G R R U O R F N D Q G
door mechanisms may not work properly
G X H W R I U H H ] L Q J F R Q G L W L R Q V
WARNING
The tailgate swings upward. Make
sure no objects or people are near the
rear of the vehicle when opening the
tailgate.
Page 320 of 649
6-47
06
Auto stop
OBC3060009
7 R V W R S W K H H Q J L Q H L Q L G O H V W R S P R G H
H [ F H S W 9 0 + ( 9
Manual Transmission/Intelligent
Manual Transmission
1. Decrease the vehicle speed to less
than 3 mph (5 km/h).
2. Shift into N (Neutral) position.
3. Release the clutch pedal.
Automatic Transmission/Dual Clutch
Transmission
1. Decrease the vehicle speed to 0 mph
(0 km/h).
2. Press the brake pedal.
The engine will stop and the green AUTO
STOP indicator (
) on the instrument
cluster will illuminate.
NOTICE
[ 9 H K L F O H Z K L F K L V H T X L S S H G Z L W K
manual transmission or intelligent
manual transmission must reach
a speed of at least 5 mph (8 km/h)
since last idle stop and vehicle
which is equipped with automatic
transmission or dual clutch
transmission must reach a speed of
at least 3 mph (5 km/h) since last idle
stop.
[ , I \ R X X Q I D V W H Q W K H V H D W E H O W R U R S H Q
the driver’s door (engine bonnet), ISG
system will be deactivated.
7 R V W R S W K H H Q J L Q H L Q L G O H V W R S P R G H
I R U 9 0 + ( 9
Manual Transmission/Intelligent
Manual Transmission
Three versions of idle stop are available
for MHEV which is equipped with
manual transmission or intelligent
manual transmission.
- Conventional Idle STOP
[ ' H F U H D V H W K H Y H K L F O H V S H H G W R O H V V
than 4 mph (7 km/h).
[ 6 K L I W L Q W R 1 1 H X W U D O S R V L W L R Q
[ 5 H O H D V H W K H F O X W F K S H G D O
- Extended Idle STOP
[ ' H S U H V V W K H E U D N H S H G D O
[ ' H S U H V V W K H F O X W F K S H G D O
- During Sailing Mode
You can keep engine off status from
sailing to standstill by pressing clutch
and brake pedal nearly at the same time.
NOTICE
1. If last gear position was the 1st, ISG
STOP will not be activated.
2. Vehicle which is equipped with
manual transmission or intelligent
manual transmission must reach
a speed of at least 5 mph (8 km/h)
since last idle stop.
3. During ISG STOP status, you can shift
into N(Neutral) position and release
clutch pedal, then ISG STOP status
will remain as STOP.
4. Extended Idle STOP operates even
over 4 mph (7km/h) if it meets the
speed requirement in each gear
position. (example: Extended Idle
STOP operates even at the 3rd speed,
24 mph (40km/h)).
5. If you unfasten the seat belt or open
the driver’s door (engine bonnet), ISG
system will be deactivated.
Page 321 of 649
6-48
Driving your vehicle
Automatic Transmission/Dual Clutch
Transmission
- Conventional Idle STOP
[ ' H F U H D V H W K H Y H K L F O H V S H H G W R P S K
(0 km/h).
[ 3 U H V V W K H E U D N H S H G D O
- Extended Idle STOP
[ ' H F U H D V H W K H Y H K L F O H V S H H G O H V V W K D Q
15 mph (25 km/h).
[ 3 U H V V W K H E U D N H S H G D O
- During Sailing Mode
You can keep engine off status from
sailing to standstill by pressing brake
pedal below 24 mph (40 km/h).
NOTICE
Vehicle which is equipped automatic
transmission or dual clutch
transmission must reach a speed of at
least 18 mph (30 km/h) for Extended
Idle STOP or 3 mph (5 km/h) for
Conventional Idle STOP since last idle
stop.
- If you unfasten the seat belt or open
the driver’s door (engine bonnet)
in auto stop mode at standstill, ISG
system will be deactivated.
Auto start
To restart the engine from idle stop
mode (except 48V MHEV)
Manual transmission vehicle/ Intelligent
Manual Transmission
Vehicle which is equipped with manual
transmission or intelligent manual
transmission is available two version of
restart.
- Conventional restart
Press the clutch pedal when the shift
lever is in the N (Neutral) position.
- Late restart (if equipped)
1. Depress the clutch pedal
2. Engage the gear
3. Release the brake pedal
NOTICE
1. Late restart function is only operated
when it is on a level ground and the
vehicle is stable.
2. To start the engine when the brake
pedal is not pressed or gear is already
engaged, press the brake pedal first
and press on the clutch pedal for
safety.
3. To turn on the engine without vehicle
movement with the brake pedal
pressed (only with Late Restart),
[ 3 U H V V D Q G U H O H D V H W K H F O X W F K S H G D O
[ 3 U H V V W K H F O X W F K S H G D O D J D L Q
immediately
4. After the engine stall, If you operate
as below the engine will start.
[ 5 H O H D V H W K H F O X W F K S H G D O D I W H U W K H
engine completely stop
[ ' H S U H V V W K H F O X W F K S H G D O
Page 524 of 649
8-9
08
If your temperature gauge indicates
overheating, you experience a loss of
power, or hear loud pinging or knocking,
the engine may be overheating. If this
happens, you should:
1. Pull off the road and stop as soon as it
is safe to do so.
2. Place the shift lever in P (Park, for
automatic transmission/dual clutch
transmission vehicle) or neutral (for
manual transmission/dual clutch
transmission vehicle) and set the
parking brake. If the air conditioning is
ON, turn it OFF.
3. If engine coolant is running out under
the vehicle or steam is coming out
from the bonnet, stop the engine. Do
not open the bonnet until the coolant
has stopped running or the steaming
has stopped. If there is no visible
loss of engine coolant and no steam,
leave the engine running and check
to be sure the engine cooling fan is
operating. If the fan is not running,
turn the engine off.
WARNING
Whilst the engine is
running, keep hands,
clothing and tools away
from the moving parts such
as the cooling fan and drive
belt to prevent serious
injury.4. Check for coolant leaking from the
radiator, hoses or under the vehicle. (If
the air conditioning had been in use, it
is normal for cold water to be draining
from it when you stop.)
5. If engine coolant is leaking out, stop
the engine immediately and we
recommend that you call a HYUNDAI
authorised repairer for assistance.
WARNING
NEVER remove the radiator
cap or the drain plug whilst
the engine and radiator are
hot. Hot coolant and steam
may blow out under
pressure, causing serious injury.
Turn the engine off and wait until the
engine cools down. Use extreme care
when removing the radiator cap. Wrap
a thick towel around it, and turn it
counterclockwise slowly to the first
stop. Step back whilst the pressure
is released from the cooling system.
When you are sure all the pressure
has been released, press down on the
cap, using a thick towel, and continue
turning counterclockwise to remove it.
IF THE ENGINE OVERHEATS