2023 HYUNDAI I20 heating

4-6
Instrument cluster
Engine Coolant Temperature Gauge
„3.5-Inch
OBC3040007/OBC3040008
„10.25-Inch
This gauge indicates the temperature
of the engine coolant when the ignition
switch is in the ON position.
NOTICE
If the gauge pointer moves beyond the
normal range area toward the “130”
position, it indicates overheating that
may damage the engine.
Do not continue driving with an
overheated engine. If your vehicle
overheats, refer to “If the Engine
Overheats” in chapter 8.
WARNING
Never remove the radiator cap or
reservoir cap when the engine is hot.
The engine coolant is under pressure
and could cause severe burns. Wait
until the engine is cool before adding
coolant to the reservoir.
Fuel Gauge
„3.5-Inch
OBC3040009/OCN7040011L
„10.25-Inch
This gauge indicates the approximate
amount of fuel remaining in the fuel
tank.
i Information

4-24
Instrument cluster
Low engine oil (if equipped)
This warning message is displayed when
the engine oil level should be checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as required.
Slowly pour the recommended oil little
by little into a funnel.
Use only the specified engine oil. (Refer
to "Recommended lubricants and
capacities" section in chapter 2.)
Do not overfill the engine oil. Make sure
the oil level is not above F (Full) mark on
the dipstick.
NOTICE
If the message is displayed
continuously after adding the engine
oil and travelling approximately 31~
62 mile (50~100 km) after the engine
warms up, we recommend that the
system be checked by a HYUNDAI
authorised repairer.
Engine has overheated
(if equipped)
This warning message is displayed
when the engine coolant temperature
is above 120°C (248°F). This means that
the engine is overheated and may be
damaged.
If your vehicle is overheated, refer to
“Overheating” section in chapter 8.
Check headlight (if equipped)
This warning message is displayed if the
headlamps are not operating properly.
In addition, if a specific lamp(turn signal
lamp etc.) is not operating properly, the
warning message according to a specific
lamp (turn signal lamp etc.) is displayed.
A corresponding bulb may need to be
replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check brake light (if equipped)
This warning message is displayed if the
stop lamps are not operating properly. A
lamp may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check Active Air Flap system (if
equipped)
This message is displayed in the
following situations:
- There is a malfunction with the
actuator flap
- There is a malfunction with the
actuator air flap controller
- The air flap does not open
When all of the above conditions are
fixed, the warning will disappear.

5
Wipers and washers ...................................................................................... 5-54Windscreen wipers .................................................................................................. 5-54
Windscreen washers ............................................................................................... 5-55
Rear window wiper and washer switch ................................................................. 5-56
Manual climate control system .................................................................... 5-57Heating and air conditioning .................................................................................. 5-58
System operation .................................................................................................... 5-62
System maintenance .............................................................................................. 5-64
Automatic climate control system ...............................................................5-66Automatic heating and air conditioning ................................................................ 5-67
Manual heating and air conditioning ..................................................................... 5-68
System operation ..................................................................................................... 5-72
System maintenance ............................................................................................... 5-75
Windscreen defrosting and defogging ......................................................... 5-77Manual climate control system ............................................................................... 5-77
Automatic climate control system ..........................................................................5-78
Auto defogging system (only for automatic climate control system) ..................5-79
Defroster .................................................................................................................. 5-80
Storage compartment .................................................................................. 5-82Centre console storage ........................................................................................... 5-82
Glove box ................................................................................................................. 5-83
Interior features ............................................................................................ 5-84Ashtray ..................................................................................................................... 5-84
Cup holder ............................................................................................................... 5-84
Sliding armrest ........................................................................................................ 5-85
Sunvisor ................................................................................................................... 5-85
Power outlet ............................................................................................................ 5-86
USB charger ............................................................................................................. 5-87
Wireless mobile phone charging system ............................................................... 5-87
Clock ........................................................................................................................ 5-90
Coat hook ................................................................................................................. 5-90
Floor mat anchor(s) .................................................................................................. 5-91
Luggage net (holder) ............................................................................................... 5-92
Cargo area cover ..................................................................................................... 5-92

5-58
Convenient features
Heating and air conditioning
1. Start the engine.
2. Set the mode to the desired position.
To improve the effectiveness of heating and cooling :
- Heating:
- Cooling:
3. Set the temperature control to the desired position.
4. Set the air intake control to Fresh mode.
5. Set the fan speed control to the desired speed.
6. If air conditioning is desired, turn the air conditioning system on.
Mode selection
OBC3050102R

5-62
Convenient features
System operation
Ventilation
1. Select the Face Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
Heating
1. Select the Floor Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
5. If desired, turn the air conditioning ON
with the temperature control knob set
to heat in order to dehumidify the air
before it enters into the cabin.
If the windscreen fogs up, select the
Floor & Defrost
mode or press the
Front Defrost mode.
2SHUDWLRQ7LSV

[ 7RNHHSGXVWRUXQSOHDVDQWIXPHV
from entering the vehicle through the
ventilation system, temporarily set the
air intake control to the recirculation
mode. Be sure to return the control
to fresh mode position when the
irritation has passed to keep fresh air
in the vehicle. This will help keep the
driver alert and comfortable.

[ 7RSUHYHQWLQWHULRUIRJRQWKH
windscreen, set the air intake control
to fresh mode and fan speed to
the desired position, turn on the
air conditioning system, and adjust
the temperature control to desired
temperature.
Air conditioning
HYUNDAI Air Conditioning Systems are
filled with R-134a or R1234yf refrigerant.
1. Start the engine.
2. Push the air conditioning button.
3. Select the Face Level
mode.
4. Set the air intake control to
Recirculation mode temporarily to
allow the cabin to cool quickly. When
the desired temperature in the cabin
is reached, change the air intake
control back to Fresh mode.
5. Adjust the fan speed control and
temperature control to maintain
maximum comfort.
i Information
OBC3050052
<RXUYHKLFOHLVILOOHGZLWK5DRU
5\IDFFRUGLQJWRWKHUHJXODWLRQLQ
your country at the time of production.
<RXFDQILQGRXWZKLFKDLUFRQGLWLRQLQJ
refrigerant is applied to your vehicle on
the label located inside of the bonnet.

5-64
Convenient features
System maintenance
Climate control air filter
OIK047401L
[A] : Outside air, [B] : Recirculated air
[C] : Climate control air filter, [D] : Blower
[E] : Evaporator core, [F] : Heater core
This filter is installed behind the glove
box. It filters the dust or other pollutants
that enter the vehicle through the
heating and air conditioning system.
We recommend that the climate control
air filter be replaced by a HYUNDAI
authorised repairer according to the
maintenance schedule. If the vehicle is
being driven in severe conditions such
as dusty or rough roads, more frequent
climate control filter inspections and
changes are required.
If the air flow rate suddenly decreases,
we recommend the system be checked
at a HYUNDAI authorised repairer.
i Information

5-67
05
Automatic heating and air
conditioning
OBC3050110R
1. Press the AUTO button.
The modes, fan speeds, air intake and
air-conditioning will be controlled
automatically according to the
temperature setting you select.
OBC3050111R
2. Push the temperature control switch
to set the desired temperature. If
the temperature is set to the lowest
setting (Lo), the air conditioning
system will operate continuously.

[ 7RWXUQWKHDXWRPDWLFRSHUDWLRQRII
select any button of the following:
- Mode selection button
- Front windscreen defroster button
(Press the button one more time
to deselect the front windscreen
GHIURVWHUIXQFWLRQ7KH
S$872
TVLJQ
will illuminate on the information
screen once again.) - Fan speed control toggle switch
The selected function will be
controlled manually whilst other
functions operate automatically.

[ )RU\RXUFRQYHQLHQFHXVHWKH$872
button and set the temperature to
22°C (72°F).
OAI3059112I
i Information
1HYHUSODFHDQ\WKLQJQHDUWKHVHQVRUWR
ensure better control of the heating and
cooling system.

5-68
Convenient features
Manual heating and air conditioning
The heating and cooling system can be controlled manually by pushing buttons other
than the AUTO button. In this case, the system works sequentially according to the
order of buttons selected. When pressing any button except the AUTO button whilst
using automatic operation, the functions not selected will be controlled automatically.
1. Start the engine.
2. Set the mode to the desired position.
To improve the effectiveness of heating and cooling, select the mode according to
the following:
- Heating :
- Cooling :
3. Set the temperature control to the desired position.
4. Set the air intake control to fresh mode.
5. Set the fan speed control to the desired speed.
6. If air conditioning is desired, turn the air conditioning system on.
7. Press the AUTO button in order to convert to full automatic control of the system.
Mode selection
OBC3050102R