9-31
09
% D W W H U \ F D S D F L W \ O D E H O
OBC3090062
„ Example
❈ The actual battery label in the vehicle
may differ from the illustration.
1. AGM50L-DIN : The HYUNDAI model
name of battery
2. 12V : The nominal voltage
3. 50Ah (20HR) : The nominal capacity
(in Ampere hours)
4. RC 80 : The nominal reserve capacity
(in min.)
5. CCA 560A : Cold-test current in
amperes by SAE/EN
% D W W H U \ U H F K D U J L Q J
Your vehicle has a maintenance-free,
calcium-based battery.
[ , I W K H E D W W H U \ E H F R P H V G L V F K D U J H G
over a short time (for example, the
headlights or interior lights were on
whilst the vehicle was not in use),
recharge it by slow charging (trickle)
for 10 hours.
[ , I W K H E D W W H U \ J U D G X D O O \ G L V F K D U J H V
because of high electrical load whilst
the vehicle is being used, recharge it
at 20-30A for two hours.
WARNING
When recharging the battery, observe
the following precautions:
[ % H I R U H S H U I R U P L Q J P D L Q W H Q D Q F H R U
recharging the battery, turn off all
accessories and stop the engine.
[ Do not allow cigarettes, sparks, or
flame near the battery.
[ Wear eye protection when checking
the battery during charging.
[ The battery must be removed from
the vehicle and placed in an area with
good ventilation.
[ Watch the battery during charging,
and stop or reduce the charging
rate if the battery cells begin
gassing (boiling) violently or if the
temperature of the electrolyte of any
cell exceeds 49°C (120°F).
[ The negative battery cable must be
removed first and installed last when
the battery is disconnected.
[ Disconnect the battery charger in the
following order.
1. Turn off the main battery charger
switch.
2. Unhook the negative clamp from
the negative battery terminal.
3. Unhook the positive clamp from
the positive battery terminal.
9-42
Maintenance
OTA070039
„ Blade type
NormalBlown
„ Cartridge type
„ Multi fuse
NormalBlown
NormalBlown
A vehicle’s electrical system is protected
from electrical overload damage by
fuses.
This vehicle has 2 (or 3) fuse panels, one
located in the driver’s side panel bolster,
the other in the engine compartment.
If any of your vehicle’s lights,
accessories, or controls do not work,
check the appropriate circuit fuse. If a
fuse has blown, the element inside the
fuse will be melted or broken.
If the electrical system does not work,
first check the driver’s side fuse panel.
Before replacing a blown fuse, turn the
engine and all switches off, and then
disconnect the negative battery cable.
Always replace a blown fuse with one of
the same rating.
If the replacement fuse blows, this
indicates an electrical problem. Avoid
using the system involved and we
recommend that all inspect a HYUNDAI
authorised repairer.
i Information
7 K U H H N L Q G V R I I X V H V D U H X V H G E O D G H W \ S H
I R U O R Z H U D P S H U D J H U D W L Q J V F D U W U L G J H
W \ S H D Q G P X O W L I X V H I R U K L J K H U D P S H U D J H
U D W L Q J V
WARNING
NEVER replace a fuse with anything but
another fuse of the same rating.
[ A higher capacity fuse could cause
damage and possibly cause a fire.
[ Do not install a wire or aluminium
foil instead of the proper fuse -
even as a temporary repair. It may
cause extensive wiring damage and
possibly a fire.
NOTICE
Do not use a screwdriver or any other
metal object to remove fuses because
it may cause a short circuit and damage
the system.
FUSES
