2022 YAMAHA KODIAK 700 Owners Manual

Page 145 of 174

YAMAHA KODIAK 700 2022  Owners Manual 9-50
9
Rear brake lever
EBU28833Checking and lubricating the brake 
pedalThe operation of the brake pedal should be
checked before each ride, and the pedal pivot
should be lubricated if necessary.TIPT

Page 146 of 174

YAMAHA KODIAK 700 2022  Owners Manual 9-51
9
EBU25024Checking the stabilizer bushesThe stabilizer bushes must be checked for cracks
or damage at the intervals specified in the periodic
maintenance chart.
Have a Yamaha dealer replace the s

Page 147 of 174

YAMAHA KODIAK 700 2022  Owners Manual 9-52
9
TIPFor parts equipped with a grease nipple, use a
grease gun. EBU25096Lubricating the steering shaftThe steering shaft must be lubricated by a
Yamaha dealer at the intervals specified in the pe

Page 148 of 174

YAMAHA KODIAK 700 2022  Owners Manual 9-53
9
TIPFor parts equipped with a grease nipple, use a
grease gun. EBU2904FBatteryThis model is equipped with a 12-volt VRLA
(valve-regulated lead-acid) battery. There is no
need to check the electr

Page 149 of 174

YAMAHA KODIAK 700 2022  Owners Manual 9-54
9
3. Remove the battery holding plate by remov-
ing the nuts.
4. Disconnect the negative battery lead first, then the positive battery lead by removing
their bolt.  NOTICE: When removing the bat-

Page 150 of 174

YAMAHA KODIAK 700 2022  Owners Manual 9-55
9
NOTICEECB00622Never attempt to open the battery or remove
the battery cell seals, as this would permanent-
ly damage the battery. To charge the battery
Confirm the recommended charging rate

Page 151 of 174

YAMAHA KODIAK 700 2022  Owners Manual 9-56
9
3. Install the battery holding plate by installing
the nuts.
4. Install the front carrier by installing the bolts and tightening them to the specified torques. 5. Install the panel.
TIP
Make

Page 152 of 174

YAMAHA KODIAK 700 2022  Owners Manual 9-57
9YFM700FWB YFM700FWBD
If an electrical problem is suspected, check the
fuse and replace it if necessary as follows.
NOTICEECB00641To prevent accidental short-circuiting, turn off
the main switch