2022 VOLKSWAGEN ID.5 Page 31

x
Damage to the v ehicle or to the high-
voltage battery could lead to a leak of
toxic gases or fluids, either immediately
or at a later time. These emitted gases
could also potentially cause a fire. Do
not inhale these gases.
x Never touch the fluids that leak from the
high-voltage battery.
x In the event of a fire, move away from
the hazard area and call the fire service.
x Always inform any attending fire and
emergency services that the vehicle is
fitted with a high-voltage battery. NOTICE
After an accident, or after the underside of
the v
ehicle has struck an obstacle, the high-
voltage battery must be checked by appropri-
ately qualified and trained experts. Warning signs for the high-
v

oltage system Please refer to , and at the start
of the chapter on page 273.
Where can warning signs be located?
The f

ollowing components may be marked
with the illustrated warning signs

If and when
V ehicle toolkit Introduction to the topic
Observ
e any country-specific legislation
when securing your vehicle in the event of
a breakdown. Stowage
Please refer to at the start of the chap-
ter on page 292.
The v

ehicle toolkit may be located in various
positions in the luggage compartment:

x
Do not use fuel, nail v arnish remover, paint
thinner or similar products to clean the
windows. Wax deposits on the windscreen and
rear window could cause the wiper
blades to rub. Remo

ve wax residue using
a special cleaning product or cleaning cloths. Exterior lighting
Introduction to the topic
Bef

ore changing a bulb, check whether a bulb
or LED light unit has failed. You can normally
change bulbs yourself. If the exterior lighting
is realised using LED technology, depending
on model and vehicle equipment, it is not
possible for you to change the LED light units
or individual LEDs yourself. If individual LEDs
fail, this may be an indication that more LEDs
are on the point of failure. In this case, have
the LED light units checked and renewed if
necessary at a qualified workshop.
It may be illegal to drive with faulty exterior
lights.
Additional bulb specifications
Some bulbs might have factory specifications
that differ from standard bulbs. The designa-
tion is inscribed on the bulb, either on the
glass part or on the base. NOTICE
Damage to the electrical system can be
caused by water entering the system if the
rubber co

ver or plastic covers on the head-
light housing are not properly mounted after
a bulb has been changed. Checklist “Information on
changing bulbs”
Please refer to and at the start of
the chapter on page 295.
Checklist 295
11A012720AB

Fuses in the bonnet space
Please refer to and at the start of
the chapter on page 296. Fig. 160
In the bonnet space: fuse bo x with
plastic grippers.
Opening the fuse box in the bonnet space

x
If the power supply of the towed v ehicle
fails, stop towing immediately and seek
expert assistance. NOTICE
Towing with a tow-rope or tow-bar can dam-
age the v
ehicle.
x Tow the vehicle carefully with a tow-rope
or tow-bar.
x If possible, have the broken-down vehicle
transported by a breakdown truck. NOTICE
When pushing the vehicle by hand, the tail
light clusters, side spoilers on the rear win-
dow and large panels can be damaged and
the rear spoiler may become detached.
x When pushing the v

ehicle by hand, do not
press on the tail light clusters, side spoilers
on the rear window, large panels and the
rear spoiler. NOTICE
The vehicle can be damaged, e.g. the vehicle
paintwork, when remo
ving and fitting the
cover and towing eye.
x Remove and install the cover and the tow-
ing eye carefully so as to avoid damage to
the vehicle. NOTICE
Use of a towing eye that is not suitable for
the v
ehicle can damage the vehicle.
x Always use the towing eye supplied in the
vehicle toolkit of your vehicle or a towing
eye that is suitable for the vehicle for tow-
ing. Notes on towing
Please refer to and at the start of
the chapter on page 304.
It is still possible to activ

ate the turn signals
in a vehicle that is being towed, even if the
hazard warning lights are switched on. To do
this, operate the turn signal and main beam
lever in the required direction while the igni-
tion is switched on. The hazard warning lights
will not flash while the turn signal is being
used. The hazard warning lights will start
flashing again automatically as soon as the
turn signal and main beam lever is moved
back to the neutral position.
In which situations may the vehicle not be
towed?
In the following situations, the vehicle may
not be towed for a long distance on its own
tyres:

port company, that your vehicle is electrically
driv
en. Towing
Please refer to and at the start of
the chapter on page 304.
Preparations

Fitting the towing eye at
front
Please refer to and at the start of
the chapter on page 304. Fig. 169
In the front bumper on the right: re-
mo ving the cover. . Use a suitable
object to screw the towing eye fully and
securely into the mounting.

WARNING
Insufficient anti-freeze in the cooling sys-
tem of the v ehicle can cause the electric
drive to break down and thereby cause se-
rious injuries.
x The amount of correct coolant additive
used must be sufficient for the lowest
ambient temperature that you expect
the vehicle to be exposed to.
x Coolant can freeze at extremely cold
outside temperatures, causing the vehi-
cle to break down. Vehicle occupants
with inadequate winter clothing could
then freeze to death as the heating will
also no longer function. NOTICE
Never mix genuine coolant additives with
other coolants that ha
ve not been approved
by Volkswagen.
x If the liquid in the coolant expansion tank
is not pink (colouring results from mixing
the purple coolant additive with distilled
water) but for example brown instead of
purple, the suitable coolant has been
mixed with an unsuitable coolant additive.
The coolant must be changed as soon as
possible if this is the case. Failure to ob-
serve this warning can result in serious
malfunctions or damage to the electric
drive and cooling system. Coolant and coolant additives can pol-
lute the en

vironment. Spilt service flu-
ids must be collected and disposed of proper-
ly and with respect for the environment. Checking the coolant level
and refilling coolant
Please refer to , and on page 309
and at the start of the chapter on page
315. Fig. 179
Under the bonnet: markings on the
coolant e
xpansion tank. .
3.

Open the bonnet