2022 TOYOTA GR86 engine oil

143
4
4-2. Driving procedures
Driving
3 Check that “ACCESSORY” is
displayed on the meters and
press the engine switch shortly
and firmly.
4 Check that “ACCESSORY” or
“IGNITION ON” on the meters
are off.
*: If equipped
*1: To improve fuel efficiency and
reduce noise, shift t he shift lever to D
for normal driving.
*2: Any gear range can be fixed when
driving in Manual mode.
■To protect the automatic transmis-
sion
If the automatic transmission fluid tem- perature is high, “Transmission Oil Tem-
perature Check Owner's Manual” will be
displayed on the multi-information dis- play and the vehicle will go into trans-
mission protection mode automatically.
Have the vehicle inspected by any authorized Toyota retailer or Toyota
NOTICE
■To prevent battery discharge
Do not stop the engine when the shift lever is in a position other than P. If
the engine is stopped in another shift
lever position, the engine switch will not be turned off but instead be
turned to ACC mode. If the vehicle is
left in ACC, battery discharge may occur.
Automatic transmission*
Select the shift position
depending on your purpose
and situation.
Shift position purpose and
functions
Shift posi-
tionObjective or function
PParking the vehicle/start-
ing the engine
RReversing
N
Neutral
(Condition in which the
power is not transmitted)
D
Normal driving*1
Temporary manual mode
driving ( P.145)
MManual mode driving*2
( P.146)

1464-2. Driving procedures
near-fully, depressed.
●When the shift lever is shifted to a
position other than D.
●When the “+” paddle shift switch is
operated for a certain amount of time
continuously
■Downshifting restriction warning buzzer
If downshifting operations are performed
at a vehicle speed by which downshifting is not possible (when
downshifting will cause the engine
speed to enter the red zone), a buzzer will sound to warn the driver that
downshifting cannot be performed.
To enter manual mode, shift the
shift lever to the M position.
When the Gear Shift Indicator is on,
gears can be selected by operating
the shift lever or paddle shift
switches, allowing you to drive in
the gear of your choosing.
The Gear Shift Indicator display is a
guide to help the driver achieve
improved fuel economy and
reduced exhaust emissions within
limits of engine performance.
Even if upshifting operations are per-
formed, if vehicle speed is too low for
the requested gear, the gear will not
change.
Upshift indicator
Downshift indicator
1 Upshifting (+)
2 Downshifting (-)
Each time the shift lever or paddle shift
switches are operated, the gear
changes up or down one gear and the
selected gear, “1” through “6”, will be
set.
The selected gear, from M1 to M6, will
be fixed and displayed on the meter.
When in manual mo de, the gear will
not change unless the shift lever or
paddle shift switches are operated.
However, even when in the manual
mode, the gears will be automati-
cally changed in the following situa-
tion:
 When vehicle speed drops
(downshift only).
 When engine oil temperature is
high and engine speed rises
close to the red zone.
WA R N I N G
■To prevent incorrect operation
Do not attach items such as accesso- ries to the paddle shift switches.
Doing so may unintentionally move
the paddle shift switches.
Manual mode driving
A

1684-5. EyeSight
NOTICE
●Under the conditions listed below, it
will become more difficult for the
system to detect the vehicle in front, motorcycles, bicycles, pedestrians
and obstacles on the road, and lane
markers. Also, EyeSight may tem- porarily stop operating. However,
the temporary stop will be canceled
once these conditions have
improved and the vehicle is driven for a short period of time.
• Bad weather (for example heavy
rain, a blizzard or thick fog). In par- ticular, the system is more likely to
temporarily stop operating when
there is an oil film adhering to the windshield, a glass coating has
been applied, or poorly performing
wipers are used.
• Strong light is coming from the front
(sunlight or headlight beams of oncoming traffic, etc.).
• The windshield washer is in use.
• Raindrops, water drops, or dirt on
the windshield are not wiped off suf- ficiently.
• The windshield has become fogged, scratched or smeared, or
snow, dirt ,dust or frost has adhered
to it, or it is otherwise affected. These will reduce the stereo cam-
era’s field of view. Also, light is
reflecting off the dirt, etc.
• The vehicle is tilted at an extreme
angle due to loaded cargo or other factors.
• Visibility is poor due to sand, smoke or water vapor blowing in the wind,
or the front vision is obscured due
to water splashes, snow, dirt or dust stir up generated by the vehicle in
front or oncoming traffic.
• The stereo camera’s field of view is
obstructed.
• Through the entrance or exit of a tunnel
• The rear aspect of the vehicle in front is low, small or irregular (for
example a low bed trailer, etc.).
• The obstacle is a fence, a wall or a
shutter, etc. with a uniform pattern
(a striped pattern, brick, etc.) or with no pattern in front.
• The obstacle is a wall or door made of glass or a mirror in front.
• Driving at night or in a tunnel when there is a vehicle in front that does
not have its taillights on
• Driving through a banner or flag,
low branches on a tree or thick/tall
vegetation
• On steep uphill or downhill grades
• The stereo camera is obstructed by
a hand, etc. (If even one of the
lenses is obstructed, the system does not operate properly.)
• It is completely dark and no objects are detected.
• The area around the vehicle has a uniform color (such as when com-
pletely covered in snow, etc.).
• Accurate detection is not possible
due to reflections in the windshield.
●Under the conditions listed below,
EyeSight may temporarily stop
operating. If this occurs, EyeSight will resume operating when the
conditions improve.
• The temperature inside the vehicle
is high, such as after the vehicle was left in bright sunshine, or the
temperature inside the vehicle is
low, such as after the vehicle was left in an extremely cold environ-
ment.
• Immediately after the engine starts

2604-7. Driving tips
4-7.Driving tips
Use fluids that are appropriate to
the prevailing out side tempera-
tures.
• Engine oil
• Engine coolant
• Washer fluid
 Have a service technician
inspect the condition of the bat-
tery.
 Have the vehicle fitted with four
snow tires or purchase a set of
tire chains for the rear tires.
Make sure to install 4 tires that are of
the specified size, and that all 4 tires
are the same size, same maker, same
brand and tread pattern. Also, make
sure to use tire chains that match the
size of the tires.
Winter driving tips
Carry out the necessary prepa-
rations and inspections before
driving the vehicle in winter.
Always drive the vehicle in a
manner appropriate to the pre-
vailing weather conditions.
Preparation for winter
WA R N I N G
■Driving with snow tires
Observe the following precautions to
reduce the risk of accidents.
Failure to do so may result in a loss of vehicle control and cause death or
serious injury.
●Use tires of the specified size, and that are the same size, same
maker, same brand and tread pat-
tern.
●Maintain the recommended level of
air pressure.
●Do not drive at speeds in excess of
the speed limit or the speed limit specified for the snow tires being
used.
●Use snow tires on a ll, not just some
wheels.
■Driving with tire chains
●When any of the tires are punc-
tured, you can seal the tire tempo- rarily. However, do not use the tire
chain on a sealed tire. If any of the
rear tires are punctured although it is required to use tire chains, con-
tact any authorized Toyota dealer or
repairer, or another duly qualified and equipped professional.
●Observe the following precautions to reduce the risk of accidents.
Failure to do so may result in the
vehicle being unable to be driven safely, and may cause death or
serious injury.
• Do not drive in excess of the speed limit specified for the tire chains
being used, or 30 km/h (19 mph),
whichever is lower.
• Avoid driving on bumpy road sur-
faces or over potholes.
• Avoid sudden acceleration, abrupt
steering, sudden braking and shift- ing operations that cause sudden
engine braking.
• Slow down sufficiently before enter- ing a curve to ensure that vehicle
control is maintained.

283
6
6-1. Maintenance and care
Maintenance and care
• Do not scrub or polish the wheels
using a brush or dry cloth • Do not use any wheel coatings or
abrasive detergents
■Brake pads and calipers
Rust may form if the vehicle is parked with wet brake pads or disc rotors, caus-
ing them to stick. Before parking the
vehicle after it is washed, drive slowly and apply the brakes several times to
dry the parts.
■Bumpers
Do not scrub with abrasive cleaners.
■Plated portions
If dirt cannot be removed, clean the
parts as follows:
●Use a soft cloth dampened with an
approximately 5% solution of neutral
detergent and water to clean the dirt off.
●Wipe the surface with a dry, soft cloth to remove any remaining moisture.
●To remove oily deposits, use alcohol wet wipes or a similar product.
WA R N I N G
■When washing the vehicle
Do not apply water to the inside of the
engine compartment. Doing so may cause the electrical components, etc.
to catch fire.
■Precautions regarding the
exhaust pipes
Exhaust gasses cause the exhaust pipes and rear bumper diffusers to
become quite hot.
When washing the vehicle, be careful not to touch the pipes and diffusers
until they have cooled sufficiently, as
touching hot exhaust pipes and rear bumper diffusers can cause burns.
■Precaution regarding the rear bumper
If the paint of the rear bumper is
chipped or scratched, the following systems may not func tion correctly. If
this occurs, consult any authorized
Toyota retailer or Toyota authorized repairer, or any reliable repairer.
●BSD/RCTA (if equipped)
●RAB (if equipped)
NOTICE
■To prevent paint deterioration
and corrosion on the body and components (aluminum wheels,
etc.)
●Wash the vehicle immediately in the following cases:
• After driving near the sea coast
• After driving on salted roads
• If coal tar or tree sap is present on the paint surface
• If dead insects, in sect droppings or bird droppings are present on the
paint surface
• After driving in an area contami-
nated with soot, oily smoke, mine
dust, iron powder or chemical sub- stances
• If the vehicle becomes heavily soiled with dust or mud
• If liquids such as benzene and gas- oline are spilled on the paint sur-
face
●If the paint is chipped or scratched,
have it repaired immediately.
●To prevent the wheels from corrod-
ing, remove any dirt and store in a
place with low humidity when stor- ing the wheels.

291
6
6-3. Do-it-yourself maintenance
Maintenance and care
6-3.Do-it-yourself maintenance
Do-it-yourself ser vice
precautions
If you perform maintenance by
yourself, be sure to follow the
correct procedure as given in
these sections.
Maintenance
ItemsParts and tools
Battery condition
( P.298)
•Warm water
• Baking soda
•Grease
• Conventional
wrench (for termi-
nal clamp bolts)
• Distilled water
Engine coolant
level( P.297)
• “TOYOTA Genu-
ine 50/50
Pre-mixed Super
Long Life Coolant
BLUE” or a similar
high quality ethyl-
ene glycol-based
non-silicate,
non-amine,
non-nitrite and
non-borate cool-
ant with long-life
hybrid organic acid
technology.
• Funnel (used only
for adding coolant)
Engine oil level
( P.295)
• “Toyota Genuine
Motor Oil” or equiv-
alent
• Rag or paper towel
• Funnel (used only
for adding engine
oil)
Fuses ( P.319)
• Fuse with same
amperage rating
as original
Light bulbs
( P.321)
• Bulb with same
number and watt-
age rating as origi-
nal
• Phillips-head
screwdriver
• Flathead screw-
driver
Radiator and
condenser
( P.298)

Tire inflation
pressure
( P.312)
• Tire pressure
gauge
• Compressed air
source
Washer fluid
( P.300)
• Water or washer
fluid containing
antifreeze (for win-
ter use)
• Funnel (used only
for adding water or
washer fluid)
WA R N I N G
The engine compartment contains
many mechanisms and fluids that may move suddenly, become hot, or
become electrically energized. To
avoid death or serious injury, observe the following precautions.
ItemsParts and tools

2926-3. Do-it-yourself maintenance
WA R N I N G
■When working on the engine
compartment
●Keep hands, clothing and tools away from the moving fans and
engine drive belt.
●Be careful not to touch the engine,
radiator, exhaust manifold, etc. right
after driving as they may be hot. Oil
and other fluids may also be hot.
●Do not leave anything that may
burn easily, such as paper and rags, in the engine compartment.
●Do not smoke, cause sparks or expose an open flame to fuel or the
battery. Fuel and battery fumes are
flammable.
●Be extremely cautious when work-
ing on the battery. It contains poi- sonous and corrosive sulfuric acid.
●Take care because brake fluid can harm your hands or eyes and dam-
age painted surfaces. If fluid gets
on your hands or in your eyes, flush the affected area with clean water
immediately.
If you still experience discomfort, con- sult a doctor.
■When working near the electric cooling fans or radiator grille
Be sure the engine switch is off.
With the engine switch in ON, the electric cooling fans may automati-
cally start to run if the air conditioning
is on and/or the coolant temperature is high. (P.298)
■Safety glasses
Wear safety glasses to prevent flying
or falling material, fluid spray, etc.
from getting in your eyes.
NOTICE
■If you remove the air cleaner fil-
ter
Driving with the air cleaner filter removed may cause excessive
engine wear due to dirt in the air.
■If the fluid level is low or high
It is normal for the brake fluid level to
go down slightly as the brake pads
wear or when the fluid level in the accumulator is high.
If the reservoir needs frequent refill-
ing, it may indicate a serious problem.

295
6
6-3. Do-it-yourself maintenance
Maintenance and care
Fuse boxes ( P.319)
Battery ( P.298)
Engine oil level dipstick ( P.295)
Engine oil filler cap ( P.295)
Washer fluid tank ( P.300)
Electric cooling fans
Condenser ( P.298)
Radiator ( P.298)
Engine coolant reservoir ( P. 2 9 7 )
For right-hand drive vehicles:
The battery is located on the opposite side of the engine compartment.
With the engine at operating tem-
perature and turned off, check the
oil level on the dipstick.
Engine compartment
Components
A
C
D
Checking and adding the
engine oil