Page 275 of 663

3-179
Convenience features
3
Surround View Monitor Auto Onfunction will operate when the fol-
lowing conditions are satisfied:
- With ‘Driver Assistance →
Parking Safety → Surround View
Monitor Auto On’ selected from
the Settings menu, the front park-
ing assist view screen is dis-
played when Parking Distance
Warning warns the driver while
driving in D (Drive).Off conditions
Press the Parking/View button (1) again, the image will turn off.
When vehicle speed is above 9 mph (15 km/h) with the gear in D
(Drive), Surround View Monitor will
turn off and the screen will change
back to the previous infotainment
system screen. Although you drive
below 9 mph (15 km/h) again,
Surround View Monitor will not turn
on.
Press one of the infotainment sys- tem button (3), the screen will
change to the infotainment system
screen.
Shift the gear to P (Park), the image will turn off.
Rear view
The rear image is displayed on the
screen when the gear is in P (Park)
to assist in parking. The rear view
has a top view/rear view/side view.
Operating conditions
Shift the gear to R (Reverse), theimage will appear on the screen.
Press the Parking/View button (1) while the gear is in P (Park), the
image will appear on the screen.
Off conditions
The image cannot be turned offwhen the gear is in R (Reverse).
Shift the gear from R (Reverse) to P (Park), the image will turn off.
Press the Parking/View button (1) again while the gear is in P (Park)
with the image on the screen.
Page 277 of 663

3-181
Convenience features
3
Information
When Rear View while Driving is on,
it stays on while driving regardless of
vehicle speed.
When Rear View while Driving is on
while backing up, the screen changes
to the rear view.
i
Always keep the camera lens
clean. If the lens is covered
with foreign material, it may
adversely affect camera per-
formance and Surround View
Monitor may not operate nor-
mally. However, do not use
chemical solvents such as
strong detergents containing
high alkaline or volatile organ-
ic solvents (gasoline, ace-
tone, etc.). This may damage
the camera lens.
ALWAYS look around your
vehicle to make sure there are
no objects or obstacles
before moving the vehicle.
What you see on the screen
may differ from the actual
vehicle’s location.
The image shown on the
screen may differ from the
actual distance of the object.
Make sure to directly check
the vehicle's surroundings for
safety.
Surround View Monitor is
designed to be used on a flat
surface. Therefore, if used on
roads with different heights
such as curbs and speed
bumps, the image in the
screen my not look correct.
WARNING
Page 279 of 663

3-183
Convenience features
3
Blind-Spot View Monitor oper-
ation
Operating switch
Turn signal lever
Blind-Spot View Monitor will turn on
and off when the turn signal is turned
on and off.
Blind-Spot View Monitor
Operating conditions
When the left or right side turn signal
turns on, the image in that direction
is displayed on the instrument clus-
ter.
Off conditions
When the turn signal turns off, theimage on the instrument cluster
will turn off.
When the hazard warning flasher is on, Blind-Spot View Monitor will
turn off, regardless of the turn sig-
nal status.
When other important warning is displayed on the instrument clus-
ter, Blind-Spot View Monitor may
turn off.
Blind-Spot View Monitor mal-
function
When Blind-Spot View Monitor is not
working properly, or the cluster dis-
play flickers, or the camera image
does not display normally, have the
vehicle inspected by an authorized
HYUNDAI dealer.
OIG046417
The image shown on the clus-
ter may differ from the actual
distance of the object. Make
sure to directly check the
vehicle's surroundings for
safety.
Always keep the camera lens
clean. If the lens is covered
with foreign material, it may
adversely affect camera per-
formance and Blind- Spot
View Monitor may not operate
normally.
WARNING
Page 284 of 663

3-188
Convenience Features
Fan speed control (1)
Turn the knob to the right to increase
the fan speed and airflow. Turn the
knob to the left to decrease fan
speed and airflow.
Setting the fan speed control knob to
the "0" position turns off the fan.
Operating the fan speed when the
ignition switch is in the ON posi-
tion could cause the battery to
discharge. Operate the fan speed
when the engine is running.
Air conditioning (3)
Push the A/C button to turn the sys-
tem on (indicator light will illuminate)
and off.
Rear climate control button
If you press the rear climate control
button, rear passengers can control
the rear climate system.
NOTICE
Continued use of the climate
control system operation in
Recirculation mode for a pro-
longed period of time may
cause drowsiness to the
occupants in the cabin. This
may lead to loss of vehicle
control which may lead to an
accident.
Continued use of the climate
control system operation in
Recirculation mode with the
A/C OFF may allow humidity
to increase inside the cabin.
This may cause condensation
to accumulate on the wind-
shield and obscure visibility.
Do not sleep in your vehicle or
remain parked in your vehicle
with the windows up and
either the heater or the air
conditioning ON for pro-
longed periods of time. Doing
so may increase the levels of
carbon dioxide in the cabin
which may lead to serious
injury or death.
WARNING
OLX2048327L
Page 291 of 663

3-195
Convenience Features
3
Air Conditioning refrigerant label
You can find out which air condition-
ing refrigerant is applied to your vehi-
cle on the label located in front of
engine compartment.Each symbol and specification on
the air conditioning refrigerant label
is represented as below:
1. Classification of refrigerant
2. Amount of refrigerant
3. Classification of compressor lubri-
cant
4. Caution
5. Flammable refrigerant
6. To require registered technician to service air conditioning system
Vehicles equipped with R-1234yf
Since the refrigerant
is operated at very
high pressure, the air
conditioning system
should only be serv-
iced by trained and certified
technicians. It is important that
the correct type and amount of
oil and refrigerant are used.
All refrigerants should be
reclaimed with proper equip-
ment.
Venting refrigerants directly to
the atmosphere is harmful to
individuals and environment.
Failure to heed these warnings
can lead to serious injuries.
WARNING
OHYK059001
■
ExampleOLX2088007
Page 298 of 663

3-202
Convenience Features
Information
Operating the system primarily in
Fresh mode is recommended. Use
Recirculation mode temporarily only
when needed.
Prolonged operation of the heater in
Recirculation mode and without the
A/C ON can cause fogging of the wind-
shield.
In addition, prolonged use of the A/C
ON in Recirculation mode may result in
excessively dry, dehumidified air in the
cabin and may promote formation of
musty vent odor due to stagnant air.
Fan speed control (8)
The fan speed can be set as desired
by pushing the fan speed control but-
ton.
More air is delivered with higher fan
speeds.
Pressing the OFF button turns off the
fan.
Information
For better sound quality, fan speed
may automatically slow down for a
couple of minutes when you activate
voice recognition or hands free.
Operating the fan when the igni-
tion switch is in the ON position
could cause the battery to dis-
charge. Operate the fan when the
engine is running.
NOTICE
i
i
Continued use of the climate
control system operation in
Recirculation mode for a pro-
longed period of time may
cause drowsiness to the
occupants in the cabin. This
may lead to loss of vehicle
control which may lead to an
accident.
Continued use of the climate
control system operation in
Recirculation mode with the
A/C OFF may allow humidity
to increase inside the cabin.
This may cause condensation
to accumulate on the wind-
shield and obscure visibility.
Do not sleep in your vehicle or
remain parked in your vehicle
with the windows up and
either the heater or the air
conditioning ON for pro-
longed periods of time. Doing
so may increase the levels of
carbon dioxide in the cabin
which may lead to serious
injury or death.
WARNING
Page 306 of 663

3-210
Convenience Features
Air Conditioning refrigerant label
You can find out which air condition-
ing refrigerant is applied to your vehi-
cle on the label located in front of
engine compartment.Each symbol and specification on
the air conditioning refrigerant label
is represented as below:
1. Classification of refrigerant
2. Amount of refrigerant
3. Classification of compressor lubri-
cant
4. Caution
5. Flammable refrigerant
6. To require registered technician to service air conditioning system
Vehicles equipped with R-1234yf
Since the refrigerant
is operated at very
high pressure, the air
conditioning system
should only be serv-
iced by trained and certified
technicians. It is important that
the correct type and amount of
oil and refrigerant are used.
All refrigerants should be
reclaimed with proper equip-
ment.
Venting refrigerants directly to
the atmosphere is harmful to
individuals and environment.
Failure to heed these warnings
can lead to serious injuries.
WARNING
OHYK059001
■
ExampleOLX2088007
Page 307 of 663

3-211
Convenience Features
3
For maximum defrost perform-ance, set the temperature control
knob to the highest temperature
setting (rotated all the way to the
right) and the fan speed control to
the highest setting.
If warm air to the floor is desired while defrosting or defogging, set the
mode to the floor-defrost position.
Before driving, clear all snow and ice from the windshield, rear win-
dow, side view mirrors, and all side
windows.
Clear all snow and ice from the hood and air inlet in the cowl grill to
improve heater and defroster effi-
ciency and to reduce the probability
of fogging up the inside of the wind-
shield.
If the engine temperature is still
cold after starting, then a brief
engine warm up period may be
required for the vented air flow to
become warm or hot.Manual Climate Control System
To defog inside windshield
1. Select any fan speed except "0" position.
2. Select the desired temperature.
3. Select the or position.
4. Fresh mode will be selected auto- matically. Additionally, the air condi-
tioning will automatically operate if
the mode is selected to the
position.
Check to make sure the A/C is ON. If
the A/C ON LED is not illuminated,
press the A/C button once to turn the
air conditioner ON.
NOTICE
W W I IN N D DS SH H I IE E L LD D D D E EF FR R O O S ST T I IN N G G A A N N D D D D E EF FO O G GG GI IN N G G
Windshield heating
Do not use the or posi-
tion during cooling operation in
extremely humid weather. The
difference between the temper-
ature of the outside air and that
of the windshield could cause
the outer surface of the wind-
shield to fog up, causing loss of
visibility could cause an acci-
dent resulting in serious injury
or death. In this case, set the
mode selection knob or button
to the position and fan
speed control knob or button to
a lower speed.
WARNING
OLX2048335L