Page 25 of 269
23
C1_en_Chap01_instrument- de-bord_ed01-2016
Warning / indicator lamp State Cause Action / Observations
Gear shift
indicator fixed.
You
can change up.For
more information, refer to the corresponding
s
ection.
You
can change down (only for the
V
Ti 68 engine).
Speed limiter
(VTi 68 engine) fixed.
The
speed limiter is active.
Lane departure
warning system fixed.
The
button has been pressed. The lane departure warning system has been
a
ctivated.
For
more information, refer to the corresponding
s
ection.
fixed. The
system is operational: it has detected road
m
arkings to the left and /or right.
For
more information, refer to the corresponding
s
ection.
Active City
Brake fixed.
The
button has been pressed.
The
configuration of the system has
be
en
mo
difiied.The
Active City Brake system has been activated.
For
more information, refer to the corresponding
s
ection.
1
Instruments
Page 26 of 269

24
Passenger's
front airbagfixed,
in the seat belt a
nd front passenger's
a
irbag
w
arning
lam
ps
d
isplay. The
control switch, located in the g
love box, is set to the OFF p osition.The
passenger's front airbag is deactivated.
You can install a rear ward facing child seat on the
f
ront seat unless there is a fault with the airbags
(
Airbag warning lamp on).
Traction control
(TRC) fixed.
A
brief press has been made on the
b
utton.
The
traction control (TRC) system is
d
eactivated.Press
the button to activate the system.
The
TRC system is activated automatically when the
v
ehicle is started.
If
deactivated, the system is reactivated automatically
f
rom around 30 mph (50 km/h).
For
more information, refer to the corresponding
s
ection.
Dynamic
stability control
(DSC) fixed.
Vehicle stationary, the button
has
been pressed for more than
3 s
econds.
The
traction control (TRC) and
d
ynamic stability control (DSC)
s
ystems are deactivated.Press
this button to activate the systems.
The
DSC system is activated automatically when the
v
ehicle is started.
For
more information, refer to the corresponding
s
ection.
Warning
/ indicator lamp
State Cause Action
/ Observations
Deactivation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has been switched off intentionally.
T his is may be accompanied by an audible signal.
Instruments
Page 27 of 269
25
C1_en_Chap01_instrument- de-bord_ed01-2016
Warning / indicator lamp State Cause Action / Observations
Stop & Star t
( VTi 68 S&S
engine) fixed.
The
Stop & Start system has been
d
eactivated.Reactivate
the system by pressing the button again.
For
more information, refer to the corresponding
s
ection.
Active City
Brake fixed.
The
Active City Brake system has
b
een
d
eactivated.Reactivate
the system by pressing the button again.
For
more information, refer to the corresponding
s
ection.
1
Instruments
Page 28 of 269
26
Indicators
Total/trip distance recorder
Press one of the buttons 1 to alternate the
distance display:
-
t
otal with "ODO"
(odometer) displayed,
-
t
rip with "TRIP"
displayed.
To
reset the trip recorder to zero, when
i
t is displayed, press and hold one of the
t
wo buttons 1 .
When
the
ignition
is
switched
on,
the
distance
r
ecorder
selected
when
the
engine
was
s
witched
off
is
displayed. This
indicates the quantity of fuel available:
- 1/ 1 and six bars, the fuel tank is full.
-
R
and one bar, the fuel tank is on the
r
eserve.
Low fuel level
Fuel gauge
At least 5 litres must be added after running out of fuel.
You have approximately 5 litres remaining.
When the low level in the fuel tank is
r
eached, this warning lamp comes on
i
n the instrument panel, accompanied
b
y an audible signal.
Instruments
Page 29 of 269

27
C1_en_Chap01_instrument- de-bord_ed01-2016
Trip computer
System that gives you information on the journey in progress (range, fuel consumption…).
Information display
F Press one of theses buttons to display the v
arious trip computer tabs in turn:
-
T
he total distance.
-
T
he trip "A".
-
T
he trip "B".
-
T
he Stop & Start partial time counter*.
-
T
he Stop & Start global time counter*.
-
T
he ambient temperature*.
-
T
he current fuel consumption.
-
T
he average fuel consumption.
-
T
he remaining range.
-
T
he average speed.
-
T
he lighting dimmer.
Trip reset
F When the trip required is displayed, press o
ne of the two " DISP"
buttons for more
t
han two seconds.
Tr i p s "A"
and "B"
are independent but their
u
se is identical.
For
example, trip "A"
can be used for daily
f
igures, and trip "B"
for monthly figures.
* Depending
on version.
Ambient temperature
In certain situations, the ambient temperature may only be displayed after a delay or not at all,
in par
ticular:
-
w
hen stationary or at low speed (less than
a
bout 18 mph (25 km/h),
-
where there is too much variation in temperature (
entering or leaving a garage, a tunnel...),
- during very short journeys (less than about 2
minutes).
Lighting dimmer
When driving at night, this function allows certain displays in the instrument panel to be
s
witched off to reduce visual fatigue for the
d
river.
It
operates only when the sidelamps are on.
F
W
hen the "Lighting dimmer" menu
i
s displayed, press and hold one of
t
he "DISP " buttons for access to the
adjustment.
F
T
hen make repeated presses on one of the
t
wo "DISP "
buttons to increase or reduce
t
he brightness.
T
he display flashes to show you the
b
rightness chosen.
1
Instruments
Page 30 of 269

28
With the touch screen tablet
From the Menu page in the touch screen tablet:
F Sel ect the " Vehicle information "
tab.
The " Trip information "
window is displayed
w
ith the following information:
-
"A
verage speed ",
-
" E
lapsed time ",
-
" R
ange",
-
t
he current fuel consumption, presented in
g
raphical
fo
rm.
The " Erase "
button resets the fuel consumption
d
ata in the touch screen tablet and the
in
strument
pan
el.
If your vehicle has a touch screen tablet, you
can
view information on the current journey.
Trip computer, a few definitions
Range
(miles or km)
T he distance which can still be travelled with
t
he fuel remaining in the tank (related to the
a
verage fuel consumption over the last few
m
iles
(
kilometres)
t
ravelled).
This
value may vary following a change
i
n the style of driving or the relief,
r
esulting in a significant change in the
c
urrent fuel consumption.
When
the fuel level is low, the message
"
Lo FUEL" is displayed.
If
only a small amount of fuel is added, the
r
ange may not be recalculated.
Current fuel consumption
(mpg or l/100 km or km/l)
C alculated over the last few seconds.
Stop & Start time counter
(minutes / seconds or hours / minutes)
I f your vehicle is fitted with Stop & Start, a time
c
ounter calculates the time spent in STOP
m
ode during a journey.
It
resets to zero every time the ignition is
s
witched on.
Average fuel consumption
(mpg or l/100 km or km/l)
C alculated since the last trip computer reset.
Average speed
(mph or km/h)
C alculated since the last trip computer reset.
Instruments
Page 31 of 269
29
C1_en_Chap01_instrument- de-bord_ed01-2016
Audio system
The time is adjusted using the "M ENU" knob:
- p ress the knob for access to menus and to
c
onfirm a selection,
-
t
urn the knob to select a function, an item
i
n a list.
You
can go back to the previous step at any
t
ime by using the "Back "
button. F
P ress the knob for access to the menus.
F
T
urn the knob to select "CLOCK ".
F
P
ress the knob to confirm.
T
he hours figure flashes.
F
T
urn the knob to adjust the hours.
F
P
ress the knob to confirm.
T
he minutes figure flashes.
F
T
urn the knob to adjust the minutes.
F
P
ress the knob to confirm and quit
t
he menu.
Setting the time
1
Instruments
Page 32 of 269
30
Touch screen tablet
Adjust the hours and minutes using the virtual arrows in the screen.
Press on "
Configuration ".
Choose the time format.
Press on " General".
Select " Clock". Press on "
OK"
to confirm and quit the menu.
Instruments