
4 
MULTIMEDIA
UCONNECT SYSTEMS  ..........................................86
CYBERSECURITY  ..................................................86
UCONNECT SETTINGS  .........................................87 Uconnect 3/3 NAV Settings ........................ 87
UCONNECT INTRODUCTION.................................97
Identifying Your Radio ................................. 97
Safety And General Information ................. 99
UCONNECT MODES ........................................... 100
Radio Mode ................................................100
Media Mode ...............................................107Phone Mode  ..............................................109
NAVIGATION MODE — IF EQUIPPED ................ 121
Operating Navigation Mode — 
If Equipped .................................................121
STEERING WHEEL AUDIO CONTROLS — IF 
EQUIPPED ........................................................... 142
Radio Operation .........................................142
Media Mode ...............................................142
RAM TELEMATICS - IF EQUIPPED .................... 142
Ram Telematics General Information ......143
RADIO OPERATION AND MOBILE PHONES.... 143
Regulatory And Safety Information........... 144
SAFETY
SAFETY FEATURES ............................................ 145 Four-Wheel Anti-Lock Brake 
System (ABS) ..............................................145 Electronic Brake Control (EBC) System  ...146 AUXILIARY DRIVING SYSTEMS.........................149
Tire Pressure Monitoring 
System (TPMS) ........................................... 149
OCCUPANT RESTRAINT SYSTEMS  .................. 153
Occupant Restraint Systems .................... 153
Important Safety Precautions ................... 153
Seat Belt Systems ..................................... 154
Supplemental Restraint Systems (SRS)... 161
Child Restraints ......................................... 170
Transporting Pets ...................................... 184
SAFETY TIPS ....................................................... 185
Transporting Passengers .......................... 185Exhaust Gas  .............................................. 185
Safety Checks You Should Make Inside 
The Vehicle  ................................................ 185 Periodic Safety Checks You Should Make 
Outside The Vehicle ................................... 187
IN CASE OF EMERGENCY
HAZARD WARNING FLASHERS........................188
FUSES ..................................................................188
General Information .................................. 188Underhood Fuses ...................................... 189
Interior Fuses ............................................. 192
Central Unit Fuse Panel............................. 193 JACKING AND TIRE CHANGING  ...................... 194
Jack Location — If Equipped ..................... 194
Removing The Spare Tire — If Equipped .. 194Preparations For Jacking  ......................... 196
Jacking Instructions................................... 197
Vehicles With Alloy Wheels ....................... 200Vehicles Equipped With Wheel Covers .... 201
TIRE SERVICE KIT — IF EQUIPPED  .................. 202
Tire Service Kit Storage............................. 202
Tire Service Kit Usage ............................... 202
JUMP STARTING ................................................ 204
Preparations For Jump Starting ................ 205
Jump Starting Procedure .......................... 206
IF YOUR ENGINE OVERHEATS  ......................... 207
IGNITION KEY REMOVAL OVERRIDE ............... 208
GEAR SELECTOR OVERRIDE ............................ 209
FREEING A STUCK VEHICLE  ............................ 209
TOWING A DISABLED VEHICLE ........................ 211
ENHANCED ACCIDENT RESPONSE SYSTEM 
(EARS)  ................................................................ 212
EVENT DATA RECORDER (EDR) ....................... 212
BULB REPLACEMENT ........................................ 213 Replacement Bulbs ................................... 213
Replacing Exterior Bulbs ........................... 214
Replacing Interior Bulbs ............................ 215
21_VM_OM_EN_USC_t.book  Page 4   

36GETTING TO KNOW YOUR VEHICLE  
If the window runs into any obstacle during 
auto-closure, it will reverse direction and then 
go back down. Remove the obstacle and use 
the window switch again to close the window.
Power Windows System Initialization
The power windows may be reset if any of the 
following occurs:
On the front doors:
Fuse or battery are disconnected when 
the window is moving
50 window movements without ever 
closing the window
On the rear doors (in addition to the condi -
tions for the front doors):
Fuse or battery are disconnected when 
the window is moving
The auto-reverse system is activated 
while the window is moving and the door 
is opening
50 window movements without ever 
closing the window
One door opening with the window 
moving, without ever closing the door
Three door opening with the window in 
motion. During these maneuvers, the 
upper stop position is never reached
Proceed as follows for initialization:
1. Completely close the driver's door window,  keeping the window switch pushed for at 
least five seconds after the (upper) end of 
travel position.
2. Proceed in the same way on the  passenger's window switches.
Window Bar Grates — If Equipped
This vehicle may be equipped with metal grates 
over the sliding door windows. This feature is a 
part of the vehicle’s safety system, and is 
designed to protect you and your passengers in 
the event of an accident.
 Window Bar Grates
Wind Buffeting 
Wind buffeting can be described as the 
perception of pressure on the ears or a 
helicopter-type sound in the ears. Your vehicle 
may exhibit wind buffeting with the windows 
down in certain open or partially open positions. 
This is a normal occurrence and can be 
minimized. If wind buffeting occurs, open the 
front windows together to minimize the 
buffeting.
WARNING!
There is no anti-pinch protection when the 
window is almost closed. To avoid personal 
injury be sure to clear your arms, hands, 
fingers and all objects from the window path 
before closing.
WARNING!
The metal grates over the sliding door win
-
dows are designed to protect you in the event 
of an accident. Modification or removal of the 
grates could lead to serious injury or death.
21_VM_OM_EN_USC_t.book  Page 36   

GETTING TO KNOW YOUR VEHICLE41
(Continued)
(Continued)
Underhood Power Outlet Fuse Locations
ROOF RACK — IF EQUIPPED
The crossbars and siderails are designed to 
carry weight on vehicles equipped with a 
luggage rack. The load must not exceed 150 lbs 
(68 kg), and should be uniformly distributed 
over the luggage rack crossbars.
NOTE:
If not equipped with crossbars, an authorized 
dealer can order and install Mopar crossbars 
built specifically for this roof rack system.
Distribute cargo weight evenly on the roof rack 
crossbars. The roof rack does not increase the 
total load carrying capacity of the vehicle. Be 
sure the total load of cargo inside the vehicle 
plus that on the external rack does not exceed 
the maximum vehicle load capacity.1 — #86 Fuse 15A Blue IP Power Outlet 12V (Key)
2 — #30 Fuse 15A Blue 2nd IP Power Outlet 12V 
(Battery)
3 — #85 Fuse 15A Blue Rear Power Outlet 12V 
(Key)
WARNING!
To avoid serious injury or death:
Only devices designed for use in this type of 
outlet should be inserted into any 12 Volt 
outlet.
Do not touch with wet hands.
Close the lid when not in use and while 
driving the vehicle.
If this outlet is mishandled, it may cause an 
electric shock and failure.
CAUTION!
Many accessories that can be plugged in 
draw power from the vehicle's battery, even 
when not in use (i.e., cellular phones, etc.). 
Eventually, if plugged in long enough, the 
vehicle's battery will discharge sufficiently 
to degrade battery life and/or prevent the 
engine from starting.
All accessories connected to the “battery” 
powered outlets should be removed or 
turned off when the vehicle is not in use. 
Leaving devices connected overnight will 
drain the vehicle’s battery.
Accessories that draw higher power (i.e., 
coolers, vacuum cleaners, lights, etc.) will 
degrade the battery even more quickly. 
Only use these intermittently and with 
greater caution.
WARNING!  (Continued)
After the use of high power draw accesso -
ries, or long periods of the vehicle not being 
started (with accessories still plugged in), 
the vehicle must be driven a sufficient 
length of time to allow the generator to 
recharge the vehicle's battery.
CAUTION!  (Continued)
2
21_VM_OM_EN_USC_t.book  Page 41   

188  (Continued)
IN CASE OF EMERGENCY
HAZARD WARNING FLASHERS  
The Hazard Warning Flashers switch is located 
on the instrument panel below the climate 
controls.
Hazard Warning Flashers Switch
 Push the switch to turn on the Hazard Warning 
Flashers. When the switch is activated, all 
directional turn signals will flash on and off to 
warn oncoming traffic of an emergency. Push 
the switch a second time to turn off the Hazard 
Warning Flashers.
This is an emergency warning system and it 
should not be used when the vehicle is in 
motion. Use it when your vehicle is disabled and 
it is creating a safety hazard for other motorists.
When you must leave the vehicle to seek 
assistance, the Hazard Warning Flashers will 
continue to operate even though the ignition is 
placed in the OFF position.
NOTE:
With extended use, the Hazard Warning 
Flashers may wear down your battery.
FUSES
General Information
WARNING!
When replacing a blown fuse, always use 
an appropriate replacement fuse with the 
same amp rating as the original fuse. Never 
replace a fuse with another fuse of higher 
amp rating. Never replace a blown fuse with 
metal wires or any other material. Do not 
place a fuse inside a circuit breaker cavity 
or vice versa. Failure to use proper fuses 
may result in serious personal injury, fire 
and/or property damage.
Before replacing a fuse, make sure that the 
ignition is off and that all the other services 
are switched off and/or disengaged.
21_VM_OM_EN_USC_t.book  Page 188   

IN CASE OF EMERGENCY189
The fuses protect electrical systems against 
excessive current.
When a device does not work, you must check 
the fuse element inside the blade fuse for a 
break/melt. Also, please be aware that when using power 
outlets for extended periods of time with the 
engine off may result in vehicle battery 
discharge.
Blade Fuses
Underhood Fuses
The Front Distribution Unit is located on the 
right side of the engine compartment, next to 
the battery. To access the fuses, remove 
fasteners and remove the cover.
Front Distribution Unit
The ID number of the electrical component 
corresponding to each fuse can be found on the 
back of the cover.If the replaced fuse blows again, contact an 
authorized dealer.
If a general protection fuse for safety 
systems (air bag system, braking system), 
power unit systems (engine system, trans -
mission system) or steering system blows, 
contact an authorized dealer.
CAUTION!
If it is necessary to wash the engine 
compartment, take care not to directly hit the 
fuse box, and the windshield wiper motors 
with water.
WARNING!  (Continued)
1 — Fuse Element
2 — Blade Fuse with a good/functional fuse ele -
ment
3 — Blade fuse with a bad/not functional fuse el -
ement (blown fuse)
7
21_VM_OM_EN_USC_t.book  Page 189   

190IN CASE OF EMERGENCY  
CavityMaxi Fuse Mini Fuse Description
F0160 Amp Blue –Body Controller
F02 40 Amp Orange –Rear Power Windows, Fog Lamps, Front Heated Seats 
(If Equipped)
F02 30 Amp Green –Rear Power Windows, Front Heated Seats (If Equipped)
F02 30 Amp Green –Fog Lamps, Front Heated Seats (If Equipped)
F02 20 Amp Yellow –Front Heated Seats (If Equipped)
F03 20 Amp Yellow –Ignition Switch
F04 40 Amp Orange –BSM System Module
F06 20 Amp Yellow –Radiator Fan - Low Speed
F07 50 Amp Red –Radiator Fan - High Speed
F08 40 Amp Orange –Blower Motor
F10 –15 Amp BlueHorn
F11 –10 Amp RedSecondary Loads ECM
F14 –15 Amp BlueHigh Beam
F15 –15 Amp BlueIP Power Outlet 12 Volt
F16 –5 Amp TanECM and Transmission Shifter
F17 –25 Amp ClearECM Power Loads
F18 –5 Amp TanECM Load, Main Relay
F19 –7.5 Amp Brown Air Conditioning
21_VM_OM_EN_USC_t.book  Page 190   

IN CASE OF EMERGENCY191
F20 –30 Amp Green Rear Defroster (If Equipped)
F21 –5 Amp TanKey Unlock
F22 –10 Amp RedPrimary ECM Loads
F23 –20 Amp Yellow BSM System
F24 –5 Amp TanBSM System, Positive Key and Steering Angle Sensor
F30 –15 Amp Blue2nd Instrument Panel Power Outlet (Battery)
F83 20 Amp Yellow –Fuel Pump
F84 –15 Amp BlueAT Module
F85 –15 Amp BlueRear Power Outlet 12 Volts (ACC/ON/RUN)
F86 –15 Amp BlueIP Power Outlet 12 Volts (ACC/ON/RUN)
F87 –5 Amp TanIBS
F88 –7.5 Amp Brown External Mirror Defrost (If Equipped)
CavityMaxi Fuse Mini Fuse Description
7
21_VM_OM_EN_USC_t.book  Page 191   

192IN CASE OF EMERGENCY  
Interior Fuses
The interior fuse panel is part of the Body 
Control Module (BCM) and is located on the 
driver's side under the instrument panel.
Fuse Panel CoverFuse Panel Cavity Locations
CavityMini Fuse Description
F535 Amp Beige KL 30 (+30) - IPC, FTM
F38 20 Amp Yellow Central Doors Locking
F36 15 Amp Blue KL 30 (+30) - TPMS, EOBD, HVAC, Radio, USB, SGW
F43 15 Amp Blue Bi-Directional Washer Pump
F48 20 Amp Yellow Passenger Power Windows
F50 7.5 Amp Brown KL 15 (+15) - Air-Bag
F51 7.5 Amp Brown KL 15 (+15) - External Mirror Adjustment Command, HVAC, RVC, HWB Coils
F37 5 Amp Beige KL 15 (+15) - Brake Pedal Switch (N.O.), IPC, Brake Pedal Switch (N.C.)
F49 5 Amp Beige KL 15 (+15) - PAM, CSS Lighting, TTM, SGW, and Heaters Light, ECM Backlighting
F31 5 Amp Beige KL 15a (INT A) - HWB, MCO
F47 20 Amp Yellow Driver Power Windows
21_VM_OM_EN_USC_t.book  Page 192