#
Siphon off any excess engine oil that has
been added. Todo so, consult a qualified spe‐
cialist workshop.
For engine oil level turn on ignition #
Switch the ignition on tocheck the engine oil
le ve l.
Engine oil level System inoperative
The fill le vel sensor is defective or not plugged in. #
Have the oil le vel display checked at a quali‐
fi ed specialist workshop.
Engine oil level System currently unavail. #
Close the bonn et.
Checking engine oil le vel with on-board com‐
puter (engine with oil dipst ick)
Re quirements:
R The vehicle is le vel during the measuring
process.
R The engine is switched off at normal operat‐
ingtemp erature.
R Awa iting period of five minutes is obser ved.
R The ignition is switched on.
To check the engine oil le vel with the on-board
computer, the engine must ha veafill le vel sen‐
sor. If not, the engine oil le vel can be checked
only with the oil dipstick (/ page 223).
On-board computer: 4 Service 5
Engine oil level
The following messa ges may appear on the
di splay of the on-boa rdcompu ter:
Engine oil level OK #
Do not top up oil.
Engine oil level Add 1,0 l #
Addth e specified quantity of oil
(/ page 224). #
Repeat the engine oil measurement af ter a
fe w minutes.
Engine oil level Reduce oil level
The oil le vel is too high. #
Siphon off any excess engine oil that has
been added. Todo so, consult a qualified spe‐
cialist workshop.
For engine oil level turn on ignition #
Switch on the ignition.
Waiting period for engine oil level not observed #
Ifth e engine is at normal operating temp era‐
ture, repeat the engine oil measurement af ter
appr oximately five minutes. #
Ifth e engine is not at normal operating tem‐
perature, repeat the engine oil measurement
af te r appro ximately 30 minutes.
Engine oil level Not with the engine running #
Switch off the engine and, when it is at nor‐
mal operating temp erature, wait appr ox‐
imately five minutes before measu ring the
engine oil le vel.
Engine oil level System inoperative
The engine oil le vel measurement is malfunction‐
ing. #
Check the oil le vel with the oil dipstick
(/ page 223). #
Have the oil le vel display checked at a quali‐
fi ed specialist workshop.
Checking the engine oil le vel with an oil dip‐
st ick &
WARNING Risk of burn s from hot com‐
ponent parts in the engine compartment
Cer tain component pa rts in the engine com‐
partment can be very hot, e.g. the engine, the
cooler and pa rts of theex haust sy stem. #
Allow the engine tocool down and only
to uch component parts desc ribed in the
fo llowing. The engine oil becomes dirty during operation,
loses
quality and also gradually loses volume.
Check the oil le velre gularly and top up the oil or
ha ve itch anged if necessar y.
Re gular lych eck thefluid le vel and the major
assemblies for leaks . Ifyou de tect fluid loss, for
ex ample, oil drops on theve hicle parking space,
consult a qualified specialist workshop as quickly
as possible. #
Only check the oil le vel when the engine is at
normal operating temp erature. Maintenance and care
223
Oil dipstick and engine oil
filler opening (e xample:
petrol engine) Oil dipstick and engine oil
filler opening (e xample:
diesel engine) #
Pull oil dipstick 1out of the dipstick tube. #
Wipe the oil dipstick 1using a lint-free
clo th. #
Insert the oil dipstick 1back into the guide
tube as far as it will go and pull it out again.
If th e le vel is between MIN mark 3and MAX
mark 2,the oil le vel is adequate. #
Ifth e oil le vel has dropped toor below mini‐
mum mark 3, open cap 4and top up the
engine oil (/ page 224).
The dif fere nce in quantity between mar ks2 and
3 depends on the engine:
R Diesel engines, about 2 l
R Petrol engines about 1.5 litres To
pping up the engine oil &
WARNING Risk offire and injury from
engine oil
If engine oil comes into con tact with hot com‐
ponent parts in the engine compartment, it
may ignite. #
Make sure that no engine oil is spilled
next tothefiller opening. #
Allow the engine tocool off and thor‐
oughly clean the engine oil from compo‐
nent parts before starting theve hicle. &
WARNING Risk of burn s from hot com‐
ponent parts in the engine compartment
Cer tain component pa rts in the engine com‐
partment can be very hot, e.g. the engine, the
cooler and pa rts of theex haust sy stem. #
Allow the engine tocool down and only
to uch component parts desc ribed in the
fo llowing. *
NO
TEDama gecaused bytopping up too
much engine oil To
o much engine oil can damage the engine
or the catalytic con verter. #
Have excess engine oil remo ved at a
qu alified specialist workshop. *
NO
TEEngine damage due touse of addi‐
tives in the engine oil The use of additional additives in
the engine
oil can damage the engine. #
Do not use any additional additives in
the engine oil. +
ENVIRONMEN
TALNO TEEnvironmental
damage due tohydraulic fluid le vel spill‐
ages while topping up If
fluid spills on tosoil, the environment will be
damaged. #
Make sure that no fluid spills while top‐
ping up. 224
Maintenance and care
