#
Neverch ange a wheel on a slope. #
Consult a qualified specialist workshop. *
NO
TEVehicle damage from the jack If
yo u do not position the jack cor rectly at the
appropriate jack support point of theve hicle,
th e jack could tip over with theve hicle raised. #
The jack is designed exclusively for
jacking up theve hicle at the jack sup‐
port points. Re
quirements:
R There are no persons in theve hicle.
R The vehicle is prepared forch anging a wheel
(/ page 259).
Impor tant no tes on using the jack:
R Only use theve hicle-specific jack that has
been tested and appr ovedby Mercedes-Benz
to raise theve hicle. If the jack is used incor‐
re ctl y,it could tip over while theve hicle is
ra ised.
R The jack is designed only toraise theve hicle
fo r a short time while a wheel is being
ch anged and is not suitable for car rying out
maintenance workunder theve hicle.
R Avoid changing a wheel on uphill and downhill
slopes.
R The jack must be placed on a firm ,fl at and
non-slip sur face. If necessar y,use a lar ge,
fl at, load bearing and non-slip unde rlay.
R The base of the jack is positioned vertically
under the jack support point.
Saf ety instructions while theve hicle is raised:
R Do not put your hands or feet under theve hi‐
cle.
R Do not lie underneath theve hicle.
R Do not start theve hicle and do not release
th e parking brake.
R Do not open or close any doors. Jacking points
1(rubber stoppers) are located
behind the front wheel ar ches and in front of the
re ar wheel ar ches. #
Place jack 2beneath cor responding jack
support point 1. #
Turn handwheel 3until the plate of jack 2
sits securely on jack support point 1. #
Ensure that the base of jack 2is positioned
ve rtically under jacking point 1. #
Assemble adap ter4 and ratchet 5from
th eve hicle tool kit. #
Place adap ter4 and ratchet 5onthe he xa‐
gon nut of jack 2sothat the lettering
AU F/UP is visible. #
Turn ratchet wrench 5intheAU F/UP direc‐
tion until the tyre is raised a maximum of
3 cm off the ground.
When doing so, jack 2may mo vetoone of
th e side support sur faces. Re
moving a wheel Re
quirements:
R The vehicle is raised (/ page 259).
When changing a wheel, avoid applying any force
to the brake discs since this could impair the
le ve l of com fort when braking.
* NO
TEDama getothre ading from dirt on
wheel bolts #
Do not place wheel bolts in sand or on a
dirty sur face. #
Unscr ewthe wheel bolts. #
Remo vethe wheel. 260
Wheels and tyres
