#
Remo vethe co ver. Co
ver of jack support points #
Tofit: inse rttabs 3 ofthe co ver into the
re cesses of the longitudinal member panel
and press the co vers closed. #
Insert retaining clip 1into the co ver,as
shown in the illustration, until you hear it
en gage inthefloor bush.
Make sure that thefloor bush in theve hicle
is cor rectly aligned tothe co ver. &
WARNING Risk of inju ryfrom incor rect
positioning of the jack
If yo u do not position the jack cor rectly at
th e appropriate jacking point of theve hicle,
th e jack could tip with theve hicle raised. #
Only position the jack at the appropri‐
ate jacking point of theve hicle. The
base of the jack must be positioned ve
rtically under the jacking point of the
ve hicle. *
NO
TEDama getotheve hicle due to
using an unsuitable jack Yo
u can damage theve hicle and, in particular
th e high-voltage batter y,ifyo u use a jack
th at is not specifically designed forth e jack
support points of theve hicle. #
Only use jac ksthat are specifically
designed forth e jack support points, or
use an appropriate adap ter. *
NO
TERisk of dama getotheve hicle due
to incor rect positioning of the jack If
yo u do not position the jack at the designa‐
te d jack support points, you could damage
yo ur vehicle and, in particular, the high-volt‐
age batter y. #
Only position the jack at the designated
jack support points. Wheels and tyres
339
