2020 HYUNDAI VELOSTER turn signal

7-69
7
Maintenance
[1] : High beam, [2] : Low beam
Headlamp
1. Open the hood.
2. Disconnect the negative battery
cable.
3. Remove the headlamp bulb cover
by turning it counterclockwise.
4. Disconnect the headlamp bulb
socket-connector.5. Remove the bulb from the head-
lamp assembly.
6. Install a new headlamp bulb and
snap the headlamp bulb retaining
wire into position by aligning the
wire with the groove on the bulb.
7. Connect the headlamp bulb sock-
et-connector.
8. Install the headlamp bulb cover by
turning it clockwise.
Information
The headlamp aiming should be
adjusted after an accident or after the
headlamp assembly is reinstalled at an
authorized HYUNDAI dealer.
Turn signal
1. Open the hood.
2. Disconnect the negative battery
cable.
3. Remove the socket (1) from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
4. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
iOJS078028OJS078027 ■High/Low beam

7-70
Maintenance
5. Install a new bulb by inserting it
into the socket and rotating it until
it locks into place.
6. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
7. Push the socket into the assembly
and turn the socket clockwise.
Position lamp and daytime running
light
Your vehicle is equipped with LED
lamps. LED lamps do not have
replaceable bulbs. If the LED lamp
does not operate, have the vehicle
checked by an authorized HYUNDAI
dealer.Side marker lamp
1. Open the hood.
2. Disconnect the negative battery
cable.
3. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
4. Remove the bulb from the socket
by pulling out the bulb.
5. Insert a new bulb.
Type B
(1) Headlamp (High)
(2) Headlamp (Low)
(3) Turn signal lamp
(4) Position lamp &
Daytime running light (DRL)
(5) Side marker
OJS078058N
OJS078070N

7-72
Maintenance
8. Install the headlamp bulb cover by
turning it clockwise.
Information
The headlamp aiming should be
adjusted after an accident or after the
headlamp assembly is reinstalled at an
authorized HYUNDAI dealer.
Turn signal
1. Open the hood.
2. Disconnect the negative battery
cable.3. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
4. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
5. Install a new bulb by inserting it
into the socket and rotating it until
it locks into place.
6. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
7. Push the socket into the assembly
and turn the socket clockwise.
Side Repeater Lamp
Replacement
If the light bulb does not operate,
have the vehicle checked by an
authorized HYUNDAI dealer.
i
OJS078030
OJS078059L

7-73
7
Maintenance
Rear Combination Light Bulb
Replacement
(1) Stop/Tail lamp
(2) Tail lamp or Stop/Tail lamp
(3) Turn signal lamp
(4) Backup lamp
(5) Side marker
Side marker and Stop/Tail lamp
light
Your vehicle is equipped with LED
lamps. LED lamps do not have
replaceable bulbs. If the LED lamp
does not operate, have the vehicle
checked by an authorized HYUNDAI
dealer.
Stop/Tail lamp and turn signal lamp
1. Open the tailgate.
2. Open the lamp assembly retaining
screw covers.
3. Loosen the lamp assembly retain-
ing screws with a cross-tip screw-
driver.4. Remove the rear combination
lamp assembly from the body of
the vehicle.
5. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
OJS078032OJS078033
OJS078031N

7-74
Maintenance
[A] : Stop/Tail lamp [B] : Turn signal lamp
6. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.7. Insert a new bulb by inserting it
into the socket and rotating it until
it locks into place.
8. Install the socket into the assem-
bly by aligning the tabs on the
socket with the slots in the assem-
bly. Push the socket into the
assembly and turn the socket
clockwise.
9. Reinstall the lamp assembly to the
body of the vehicle.
Tail lamp and backup lamp
1. Turn off the engine.
2. Open the tailgate.
3. Remove the service cover using a
flat-blade screwdriver.
OJS078034OJS078035L
■Type A
OJS078036L
■Type B

B BU
UL
LB
B
W
WA
AT
TT
TA
AG
GE
E
88
Specifications
8-3 Light Bulb Bulb Type Wattage
FrontHeadlampLow (Type A) H7 55
High (Type A) HB3 60
Low (Type B) LED LED
High (Type B) HB3 60
Turn signal lamp 28/8W(2357A) 28
Turn signal lamp (Outside mirror) LED LED
Daytime running lamp (DRL) / position lamp LED LED
Side Marker LampType A W5W 5
Type B LED LED
RearRear combination lampStop/Tail (Type A) P21/5W 21/5
Tail (Type A) P21/5W 5
Stop/Tail (Type B) LED LED
Turn signal 27W(1156A) 27
Back up W16W 16
Side Marker LampType A W5W 5
Type B LED LED
High mounted stop lamp LED LED
License plate lamp W5W 5
InteriorMap lamp W10W 10
Room lamp (without sunroof) FESTOON 8
Sunvisor lamp FESTOON 5
Tailgate room lamp FESTOON 10

I-5
Exterior Lights ................................................................3-81
AUTO light position...................................................3-81
Battery saver function ................................................3-87
Daytime running light (DRL) ....................................3-88
Headlamp delay function ...........................................3-87
Headlamp position......................................................3-82
High Beam Assist (HBA) ...........................................3-83
High beam operation ..................................................3-82
Lane change signals ...................................................3-86
Parking lamp position ................................................3-82
Turn signals ................................................................3-86
Exterior Overview.............................................................1-2
Floor Mat Anchor(s) .....................................................3-132
Forward Collision-Avoidance Assist (FCA) System
(Camera) ......................................................................5-64
FCA Sensor ................................................................5-68
FCA Warning Message and System Control..............5-66
Limitations of the System ..........................................5-71
System Malfunction ...................................................5-69
System Setting and Activation ...................................5-64
Forward Collision-Avoidance Assist (FCA) System
(Fusion Sensor) ............................................................5-76
FCA Sensor ................................................................5-80
FCA Warning Message and System Control..............5-78
Limitations of the System ..........................................5-83
System Malfunction ...................................................5-81
System Setting and Activation ...................................5-76Front Seats ........................................................................2-5
Driver seat folding lever...............................................2-8
Forward and rearward adjustment................................2-6
Lumbar support ............................................................2-7
Seat cushion height ......................................................2-7
Seatback angle ..............................................................2-6
Fuel Filler Door ..............................................................3-38
Fuses ...............................................................................7-52
Engine Compartment Panel Fuse Replacement .........7-54
Fuse/Relay Panel Description ....................................7-56
Instrument Panel Fuse Replacement ..........................7-53
Gauges and Meters .........................................................3-43
Glove Box .....................................................................3-124
Hazard Warning Flasher ...................................................6-2
Head Restraints ...............................................................2-10
Front seat head restraints ............................................2-11
Rear seat head restraints .............................................2-13
Head Up Display (HUD) ................................................3-78
Headlamp ........................................................................7-68
Heated Steering Wheel ...................................................3-23
High Mounted Stop Lamp Replacement ........................7-76
Hill-Start Assist Control (HAC) .....................................5-48
Hood................................................................................3-35
Horn ................................................................................3-22
I
Index
F
G
H

I-7
Jump Starting ....................................................................6-4
Key Ignition Switch ..........................................................5-6
Lane Keeping Assist (LKA) System ..............................5-88
Limitations of the System ..........................................5-94
LKA system Function Change ...................................5-95
LKA System Operation ..............................................5-89
Warning Light and Message.......................................5-93
LCD Display ...................................................................3-63
LCD Display Control .................................................3-63
LCD Display Modes ..................................................3-64
LCD Display Control......................................................3-63
LCD Display Messages ..................................................3-58
LCD Display Modes .......................................................3-64
License Plate Light Bulb Replacement ..........................7-76Light Bulbs .....................................................................7-67
Headlamp, Position lamp, Daytime Running Light,
Turn signal lamp and Side marker ..........................7-68
High Mounted Stop Lamp Replacement....................7-76
Interior Light Bulb Replacement ...............................7-77
License Plate Light Bulb Replacement ......................7-76
Rear Combination Light Bulb Replacement ..............7-73
Side Repeater Lamp Replacement .............................7-72
Lighting ...........................................................................3-81
Exterior Lights............................................................3-81
Interior Lights.............................................................3-88
Welcome System ........................................................3-90
Maintenance Services .......................................................7-4
Owner Maintenance Precautions..................................7-4
Owner's Responsibility.................................................7-4
Manual Climate Control System ..................................3-101
Heating and Air Conditioning ..................................3-102
System Maintenance ................................................3-107
System Operation .....................................................3-105
Manual Transmission ......................................................5-18
Good Driving Practices ..............................................5-20
Manual Transmission Operation ................................5-18
Mirrors ............................................................................3-23
Inside Rearview Mirror ..............................................3-23
Side View Mirrors ......................................................3-25
I
Index
J
K
L
M