2019 HYUNDAI I10 Owners Manual

3-17
03
WARNING
NEVER place anything on the seat
that insulates against heat when
the seat warmer is in operation,
such as a blanket or seat cushion.
This may cause the seat warmer to
overheat, causing a burn or dam-
age to the seat.
NOTICE
To prevent damage to the seat
warmers and seats:
‡Never use a solvent such as
paint thinner, benzene, alcohol
or petrol to clean the seats.
‡Do not place heavy or sharp
objects on seats equipped with
seat warmers.
‡Do not change the seat cover. It
may damage the seat warmer or
air ventilation system.
OAC3039008TU
Whilst the engine is running, push
either of the switches to warm the
driver’s seat or front passenger’s
seat.
During mild weather or under condi-
tions where the operation of the seat
warmer is not needed, keep the
switches in the OFF position.
‡Each time you push the switch, the
temperature setting of the seat is
changed as follows:


OFFJHIGH ()JMIDDEL ()JLOW ()
K
‡The seat warmer defaults to the
OFF position whenever the ignition
switch is turned on.
‡When pressing the switch for more
than 1.5 seconds with the seat
warmer operating, the seat warmer
will turn OFF.

3-18
Safety system
SEAT BELTS
This section describes how to use the
seat belts properly. It also describes
some of the things not to do when
using seat belts.
Seat belt safety precautions
Always fasten your seat belt and
make sure all passengers have fas-
tened their seat belts before starting
any trip. Air bags (if equipped) are
designed to supplement the seat belt
as an additional safety device, but
they are not a substitute. Most coun-
tries require all occupants of a vehicle
to wear seat belts.
WARNING
Seat belts must be used by ALL
passengers whenever the vehicle
is moving. Take the following pre-
cautions when adjusting and wear-
ing seat belts:
‡ALWAYS properly restrain chil-
dren under age 13 in the rear
seats.
‡NEVER allow children to ride in
the front passenger seat. If a
child age 13 or older must be
seated in the front seat, move the
seat as far back as possible and
properly restrain them in the
seat.
‡NEVER allow an infant or child to
be carried on an occupant’s lap.
‡NEVER ride with the seatback
reclined when the vehicle is mov-
ing.
‡Do not allow children to share a
seat or seat belt.
‡Do not wear the shoulder belt
under your arm or behind your
back.‡Never wear a seat belt over frag-
ile objects. If there is a sudden
stop or impact, the seat belt can
damage it.
‡Do not use the seat belt if it is
twisted. A twisted seat belt will
not protect you properly in an
accident.
‡Do not use a seat belt if the web-
bing or hardware is damaged.
‡Do not latch the seat belt into the
buckles of other seats.
‡NEVER unfasten the seat belt
whilst driving. This may cause
loss of vehicle control resulting
in an accident.
‡Make sure there is nothing in the
buckle interfering with the seat
belt latch mechanism. This may
prevent the seat belt from fasten-
ing securely.
‡No modifications or additions
should be made by the user
which will either prevent the seat
belt adjusting devices from oper-
ating to remove slack, or prevent
the seat belt assembly from
being adjusted to remove slack.
WARNING
Damaged seat belts and seat belt
assemblies will not operate prop-
erly. Always replace:
‡Frayed, contaminated, or dam-
aged webbing.
‡Damaged hardware.
‡The entire seat belt assembly
after it has been worn in an acci-
dent, even if damage to webbing
or assembly is not apparent.

3-19
03
Seat belt warning light
Driver’s seat belt
„ Instrument cluster
1GQA2083
Regardless of the driver’s seat belt
fastening, the warning light will illumi-
nate for approximately 6 seconds
each time you turn the ignition switch
ON. If the driver’s seat belt is not fas-
tened, the warning chime will sound
for about 6 seconds and the waning
light will stay turned ON until the driv-
er’s seat belt is fastened.
If you start to drive without the driv-
er’s seat belt fastened, when you
drive under 12 mph (20 km/h) or stop,
the warning light will illuminate.
When you drive 12 mph (20 km/h) or
faster, the warning light will blink and
warning chime will sound for approxi-
mately 100 seconds.
When the driver’s seat belt is unfas-
tened during driving, the warning light
will illuminate when the speed is
under 12 mph (20 km/h). When the
speed is 12 mph (20 km/h) and fast-
er, the warning light will blink and
warning chime will sound for approxi-
mately 100 seconds.
Front passenger’s seat belt
(if equipped)
Regardless of the passenger’s seat belt
fastening, the warning light will illuminate
for approximately 6 seconds each time
you turn the ignition switch ON. If the
passenger’s seat belt is not fastened,
the waning light will stay turned ON until
the passenger’s seat belt is fastened.
If you start to drive without the pas-
senger’s seat belt fastened, when
you drive under 12 mph (20 km/h) or
stop, the warning light will illuminate.
When you drive 12 mph (20 km/h) or
faster, the warning light will blink and
warning chime will sound for approxi-
mately 100 seconds.
When the passenger’s seat belt is
unfastened during driving, the warn-
ing light will illuminate when the
speed is under 12 mph (20 km/h).
When the speed is 12 mph (20 km/h)
and faster, the warning light will blink
and warning chime will sound for
approximately 100 seconds.
WARNING
Riding in an improper position
adversely affects the front passen-
ger’s seat belt warning system. It
is important for the driver to
instruct the passenger to properly
be seated as instructed in this
manual.

3-20
Safety system
i Information
‡
Although the front passenger seat is
not occupied, the seat belt warning
light will blink or illuminate for 6
seconds. Also, when the front passen-
ger gets off the vehicle whilst the
warning is activating, the warning
may continue for 6 seconds even
after the passenger gets off.
‡ 7he front passenger¶s seat belt warn-
ing may operate when luggage, lap-
top or other electronic device is aced
on the front passenger seat.
Rear seat belt warning
(if equipped)
OAC3039043R
Rear left (1) and right side (3) seat
As a reminder to the rear passenger,
the rear passenger’s seat belt warn-
ing lights will illuminate for approxi-
mately 6 seconds each time you turn
the ignition switch ON regardless of
belt fastening.
If the seat belt is not fastened when
the ignition switch is turned ON, the
corresponding warning light will illu-
minate until the seat belt is fastened.If you start to drive without the seat
belt fastened or you unfasten the seat
belt when you drive under 12 mph (20
km/h), the corresponding warning
light will continue to illuminate until
you fasten the seat belt.
If you continue to drive without the
seat belt fastened or you unfasten the
seat belt when you drive 12 mph (20
km/h) and faster, the seat belt warn-
ing chime will sound for approximate-
ly 35 seconds and the corresponding
warning light will blink.
When the seat belt is unfastened dur-
ing driving, the warning lights will illu-
minate when the speed is under 12
mph (20 km/h).
When the speed is 12 mph (20 km/h)
and faster, the warning light will blink
and warning chime will sound for
approximately 35 seconds.
Rear centre seat (2)
(5 Seater, if equipped)
As a reminder to the rear passenger,
the rear passenger’s seat belt warn-
ing lights will illuminate for approxi-
mately 6 seconds each time you turn
the ignition switch ON regardless of
belt fastening.

3-21
03
Whether or not a passenger are seat-
ed :
If the seat belt is not fastened when
the ignition switch is turned ON, the
seat belt warning light will illuminate
for approximately 70 seconds.
If you start to drive without the seat
belt fastened the corresponding
warning light will continue to illumi-
nate for approximately 70 seconds
regardless of the speed.
If you unfasten the seat belt when
you drive under 12 mph (20 km/h),
the corresponding warning light will
illuminate for approximately 70 sec-
onds. If you unfasten the seat belt
when you drive over 12 mph (20
km/h), the seat belt warning chime
will sound for approximately 35 sec-
onds and the corresponding warning
light will blink.
If the rear door is opened whilst driv-
ing under 12 mph (20 km/h), warning
light and warning sound does not
work even if driving over 12 mph (20
km/h).
WARNING
Riding in an improper position
adversely affects the rear passen-
ger’s seat belt warning system. It
is important for the driver to
instruct the passenger to properly
be seated as instructed in this
manual.
i Information
‡ Although the rear side passenger
seat is not occupied, the seat belt
warning light will blink or illuminate
for 6 seconds.
‡ seat belt warning light on the centre
fascia panel.
‡ 7he rear side passenger¶s seat belt
warning may operate when luggage,
laptop or other electronic device is
placed on the rear side passenger
seat.
Seat belt restraint system
Lap/shoulder belt
ODH034055R
7o fasten your seat belt
Pull it out of the retractor and insert
the metal tab (1) into the buckle (2).
There will be an audible “click” when
the tab locks into the buckle.

3-22
Safety system
OIK037091R
You should place the lap belt (1) por-
tion across your hips and the shoul-
der belt (2) portion across your chest.
The seat belt automatically adjusts to
the proper length after the lap belt
portion is adjusted manually so that it
fits snugly around your hips. If you
lean forward in a slow, easy motion,
the belt will extend and move with
you.
If there is a sudden stop or impact,
the belt will lock into position. It will
also lock if you try to lean forward too
quickly.
NOTICE
If you are not able to smoothly pull
enough of the seat belt out from
the retractor, firmly pull the seat
belt out and release it. After
release, you will be able to pull the
belt out smoothly.
WARNING
OAE036074R
Improperly positioned seat belts
may increase the risk of serious
injury in an accident. Take the fol-
lowing precautions when adjust-
ing the seat belt:
‡Position the lap portion of the
seat belt as low as possible
across your hips, not on your
waist, so that it fits snugly. This
allows your strong pelvic bones
to absorb the force of the crash,
reducing the chance of internal
injuries.
‡Position one arm under the
shoulder belt and the other over
the belt, as shown in the illustra-
tion.
‡Always position the shoulder
belt anchor into locked position
at the appropriate height.
‡Never position the shoulder belt
across your neck or face.

3-23
03
OHI038142
7o release your seat belt
Press the release button (1) in the
locking buckle.
When it is released, the belt should
automatically draw back into the
retractor. If this does not happen,
check the belt to be sure it is not
twisted, then try again.
Rear centre seat belt
(if equipped)
OAC3039044TU
When using the rear centre seat belt,
the buckle with the “CENTER” mark
must be used.
i Information
If you are not able to pull out the safety
belt from the retractor, firmly pull the
belt out and release it. After release,
you will be able to pull the belt out
smoothly.
Pre-tensioner seat belt
(if equipped)
OLMB033039/H
Your vehicle is equipped with driver’s
and front passenger’s and rear left
side and right side passenger’s pre-
tensioner seat belts (Retractor Pre-
tensioner and EFD (Emergency
Fastening Device)).
The purpose of the pre-tensioner is to
make sure the seat belts fit tightly
against the occupant’s body in cer-
tain frontal or side collision(s). The
pre-tensioner seat belts may be acti-
vated in crashes where the frontal or
side collision(s) is severe enough,
together with the air bags.
When the vehicle stops suddenly, or
if the occupant tries to lean forward
too quickly, the seat belt retractor will
lock into position.
WARNING
Make sure that the seatback is
locked in place when using the
rear center seat belt.
If not, the seatback may move
when there is a sudden stop or col-
lision, which could result in seri-
ous injury.

3-24
Safety system
In certain frontal collisions, the pre-
tensioner will activate and pull the
seat belt into tighter contact against
the occupant’s body.
- Retractor Pretensioner
The purpose of the retractor preten-
sioner is to make sure that the
shoulder belts fit in tightly against
the occupant’s upper body in cer-
tain frontal or side collision(s).
- EFD (Emergency Fastening
Device)
The purpose of the EFD is to make
sure that the pelvis belts fit in tightly
against the occupant’s lower body
in certain frontal or side collisions.
(if equipped, Driver only)
If the system senses excessive ten-
sion on the driver or passenger’s seat
belt when the pre-tensioner system
activates, the load limiter inside the
retractor pre-tensioner will release
some of the pressure on the affected
seat belt.
CAUTION
If equipped with rollover sensor
The pre-tensioner will activate not
only in a frontal collision but also
in a side collision or rollover, if the
vehicle is equipped with a side or
curtain air bag.
CAUTION
Without rollover sensor
The pre-tensioner will activate not
only in a frontal collision but also
in a side collision, if the vehicle is
equipped with a side or curtain air
bag.
WARNING
‡Always wear your seat belt and
sit properly in your seat.
‡Do not use the seat belt if it is
loose or twisted. A loose or
twisted seat belt will not protect
you properly in an accident.
‡Do not place anything near the
buckle. This may adversely affect
the buckle and cause it to func-
tion improperly.
‡Always replace your pre-tension-
ers after activation or an acci-
dent.
‡NEVER inspect, service, repair
or replace the pre-tensioners
yourself. This must be done by a
HYUNDAI authorised repairer.
‡Do not hit the seat belt assem-
blies.
WARNING
Do not touch the pre-tensioner
seat belt assemblies for several
minutes after they have been acti-
vated. When the pre-tensioner seat
belt mechanism deploys during a
collision, the pre-tensioner can
become hot and can burn you.
CAUTION
Body work on the front area of the
vehicle may damage the pre-ten-
sioner seat belt system. Therefore,
we recommend that the system be
serviced by a HYUNDAI authorised
repairer.