2018 MITSUBISHI L200 length

During cold weather
If the temperatures in your area drop belowfreezing, there is the danger that the coolant
in the engine or radiator could freeze and
cause severe damage to the engine and/or ra- diator. Add a sufficient amount of anti-freeze to the coolant to prevent it from freezing.The concentration should be checked before the start of cold weather and anti-freeze add-
ed to the system if necessary.
Washer fluid
E01000702113
Open the washer fluid reservoir cap andcheck the level of washer fluid with the dip- stick.
If the level is low, replenish the container with washer fluid.
NOTEl The washer fluid container serves the wind-
screen and headlamps (if so equipped).
During cold weather
To ensure proper operation of the washers at
low temperatures, use a fluid containing ananti-freezing agent.
Brake fluid
E01000902131
To check the fluid level
Check the brake fluid level in the reservoir.
The brake fluid level must be between the “MAX” and “MIN” marks on the reservoir.
The brake fluid level is monitored by a float.
When the brake fluid level falls below the “MIN” mark, the brake fluid warning lamp
lights up.
The fluid level falls slightly with wear of the brake pads, but this does not indicate any ab-
normality.
If the brake fluid level falls markedly in a short length of time, it indicates leaks from
the brake system.
If this occurs, we recommend you to have the vehicle checked.
Fluid type
Use brake fluid conforming to DOT3 or
DOT4. The brake fluid is hygroscopic. Too
much moisture in the brake fluid will ad- versely affect the brake system, reducing the brake performance.
In addition, the brake fluid reservoir is equip-
ped with a special cap to prevent the entrance
of air, and this cap should not be removed.
WARNINGl Take care in handling brake fluid as it is
harmful to the eyes, may irritate your
skin and will damage painted surfaces.
Wipe up spills immediately. If brake fluid gets on your hands or in your eyes, flushimmediately with clean water. Follow up
with a doctor as necessary.
Washer fluid
10-08OKTE18E1Maintenance10EMPTY

Single cab1Front track1,520 mm2Overall width1,785 mm3Front overhang865 mm4Wheel base3,000 mm5Rear overhangWithout rear bumper1,215 mmWith rear bumper1,295 mm6Overall lengthWithout rear bumper5,080 mmWith rear bumper5,160 mm7Ground clearance (unladen)200 mm8Overall height (unladen)1,780 mm9Rear track1,515 mm10Cargo bed length2,265 mm11Cargo bed width1,470 mm12Cargo bed height845 mm
Minimum turning radius
Body6.3 mWheel5.9 m
Vehicle dimensions
11-05OKTE18E1Specifications11

Club cab1Front track1,520 mm2Overall width1,785 mm, 1,815 mm*3Front overhang865 mm4Wheel base3,000 mm5Rear overhangWithout rear bumper1,330 mmWith rear bumper1,410 mm6Overall lengthWithout rear bumper5,195 mmWith rear bumper5,275 mm7Ground clearance (unladen)200 mm, 205 mm*8Overall height (unladen)1,775 mm, 1,780 mm *9Rear track1,515 mm10Cargo bed length1,850 mm11Cargo bed width1,470 mm12Cargo bed height845 mm, 850 mm**
: Vehicles with wide fenderNOTEl The vehicle overall length and height may vary depending on the equipment installed.
Minimum turning radius
Body6.3 m
Vehicle dimensions
11-07OKTE18E1Specifications11

Double cab1Front track1,520 mm2Overall width1,785 mm, 1,815 mm*3Front overhang865 mm4Wheel base3,000 mm5Rear overhangWithout rear bumper1,340 mmWith rear bumper1,420 mm6Overall lengthWithout rear bumper5,205 mmWith rear bumper5,285 mm7Ground clearance (unladen)200 mm, 205 mm*8Overall height (unladen)1,775 mm, 1,780 mm *9Rear track1,515 mm10Cargo bed length1,520 mm11Cargo bed width1,470 mm12Cargo bed height845 mm, 850 mm**
: Vehicles with wide fender
Minimum turning radius
Body6.3 mWheel5.9 m

Vehicle dimensions
11-09OKTE18E1Specifications11