2018 MERCEDES-BENZ CLA oil

bolts to come loose. As ar esult, you could
lose aw heel while driving .T here is ar isk of
accident.
Never oil or grease wheel bolts. In the event of
damage to the threads, contact aq ualified
specialist workshop immediately. Have the
damaged wheel bolts or hub threads
replaced/renewed. Do not continue driving.
G WARNING
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip
over. There is ar isk of injury.
Only tighten the wheel bolts or wheel nuts
when the vehicle is on the ground.
Always pay attention to the instructions and
safety notes in the "Changing aw heel" section
( Y
page 307).
Only use wheel bolts that have been designed
for the wheel and the vehicle. For safety rea-
sons, Mercedes-Benz recommends that you
only use wheel bolts which have been approved
for Mercedes-Benz vehicles and the respective
wheel.
! To preven td amage to the paintwork, hold
the wheel securely against the wheel hub
while screwin gint he first wheel bolt.
X
Clean the wheel and wheel hub contact sur-
faces. X
Place the new wheel on the wheel hub and
push it on. X
Tighten the wheel bolts until they are finger-
tight. Lowering the vehicle
G WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightenin gt orque. There is ar isk of accident.
Have the tightenin gt orque immediately
checked at aq ualified specialist workshop
after aw heel is changed. X
Place the ratchet wrenc ho nt ot he hexagon
nut of the jack so that the letters AB are visi-
ble. X
Turn the ratchet wrenc hu ntil the vehicle is
onc ea gain standing firmly on the ground. X
Place the jack to one side.
X
Tighten the wheel bolts evenly in ac rosswise
pattern in the sequence indicated ( C to

Do not mix such fuel sw it ht he fuel recom-
mended for your vehicle.
! To ensur et he longevity and full perform-
ance of the engine ,o nl yp remium-grade
unleade dg as oline must be used.
If standard unleade dg as oline is unavailable
and yo uh av etor efue lw it hu nleade dg as oline
of al ower grade ,o bs erve the following pre-
cautions: R
Onl yf il lt he fuel tank to half full with regular
unleade dg as oline and fil lt he res tw it hp re-
mium-grad eu nleade dg as oline as soo na s
possible. R
Do not drive at the maximum speed. R
Avoi ds udde na cceleratio na nd engine
speeds ove r3 ,000 rpm.
Yo uw il lu sually find informatio na bout the fuel
grade on the fuel pump. If yo uc anno tf ind the
labe lont he fuel pump, as kt he ga ss tatio ns taff.
i For furthe ri nformation, consul taq uali fied
specialis tw or kshop or visit
http://www.mbusa.com (USA only).
CL A2 50 ,C LA 25 0S port, CL A2 50 4MATIC,
CL A2 50 Sport 4MATIC: as at emporary meas-
ure, if the recommende df ue lisn ot available,
yo um ay also us er egular unleade dg as oline with
an octane rating of 88 AKI /93 RON .
All othe rm odels: as at emporary measure, if
the recommende df ue lisn ot available, yo um a y
also us er egular unleade dg as oline with an
octane rating of 87 AKI/91 RON. Thi sm ay
reduce engine performance and increase fuel
consumption. Avoi dd rivin gatf ul lt hrottle and
sudden acceleration. Never refue lu si ng gaso-
line with al ower AKI.
Informatio nonr efueling ( Y
page 139).
Additives
! Operating the engine with fuel additives
adde dl at er can lead to engine failure. Do not
mix fuel additive sw it hf uel. Thi sd oe sn ot
includ ea ddit ive sf or the remova la nd preven-
tio nofr esidue buildup. gasoline must onl yb e
mixed with additive sr ecommende db y
Mercedes-Benz. Compl yw it ht he instructions
for us eont he product label. Mor ei nformation
abou tr ecommende da ddit ive sc an be
obtained fro ma ny authorize dM er cedes-Benz
Center.
Mercedes-Benz recommends tha ty ou us eb ran-
de df uels tha th av ea ddit ives. The fuel quality availabl eins om ec ountries may
not be sufficient. Residu ec ould buil dupint he
fuel injectio ns ys tem as ar esult. In such cases,
and in consultation with an authorized
Mercedes-Benz Center, the fuel ma ybem ixed
with the cleaning additive recommende db y
Mercedes-Benz. Yo um us to bs erve the notes
and mi xing ratio ss p
e cifie dont he container.
Engine oil
General notes
! Do not us ee ngine oi lorano il filter with
specifications deviating fro mt hos ee xpressly
required for the prescribe ds ervic ei ntervals.
Do not change the engine oi loro il filter in
order to set replacement intervals longe rt han
thos ep rescribed. Thi sc ould otherwis ec ause
damage to the engine or exhaust ga sa ft er-
treatment.
Follo wt he instructions on the servic ei nterval
displa yf or changing the engine oil. Thi sc ould
otherwis ec ause damage to the engine or
exhaust ga sa ft ertreatment.
When handling engine oil, observe the important
safety note sons ervic ep roducts ( Y
page 315).
The engine oils ar em at che dtot he performance
of Mercedes-Benz engine sa nd servic ei ntervals.
Yo us houl dt herefore onl yu se engine oils and oil
filters tha ta re approved for vehicles with main-
tenance systems.
For al is tofa pp roved engine oils and oi lf ilters,
consul tana ut horize dM er cedes-Benz Center.
Or visit the website
http://bevo.mercedes-benz.co m.
The table shows which engine oils have been
approved for your vehicle.Service products and filling capacities 317
Technical data Z

Model MB-Freigabe or
MB-Approval
All models
229.5
Use only SAE 0W-40 or SAE 5W-40 engine oils
for Mercedes-AMG vehicles.
i MB approval is indicated on the oil contain-
ers.
Fillin gc apacitiesThe following values refer to an engine oil
change, including the oil filter.
Model Capacity
Mercedes ‑ AM Gv ehicles
5.8 US qt (5.5 l)
All other models
5.9 US qt (5.6 l)
Additives
! Do not use any additives in the engine oil.
This could damage the engine.
Brake fluid
G WARNING
The brake flui dc onstantly absorbs moisture
from the air. This lowers the boiling point of
the brake fluid. If the boiling point of the brake
flui dist oo low ,v apo rp ockets may form in the
brake system when the brakes are applied
hard. This would impair braking efficiency.
There is ar isk of an accident.
You should have the brake flui dr enewe da t
the specified intervals.
When handling brake fluid, observe the impor-
tant safety notes on service products
( Y
pag e3 15).
The brake flui dc hange interval sc an be found in
the Maintenance Booklet.
Only use brake flui da pproved by Mercedes-
Benz in accordance with MB-Freigabe or MB-
Approva l3 31.0.
Information about approved brake flui dc an be
obtained at any qualified specialist workshop or
on the Internet at
http://bevo.mercedes-benz.com. i Have the brake flui dr egularl yr eplaced at a
qualified specialist workshop and the replace-
ment confirmed in the Maintenance Booklet.
Coolant
Important safety notes
G WARNING
If antifreeze comes into contact with hot com-
ponents in the engine compartment, it may
ignite. There is ar isk of fire and injury.
Let the engine cool down before you add anti-
freeze. Make sure that antifreeze is not spilled
next to the filler neck. Thoroughly clea nt he
antifreeze from components before starting
the engine.
! Only add coolant that has been premixed
with the desired antifreeze protection. You
coul do therwise damage the engine.
Further information on coolants can be found
in the Mercedes-Benz Specifications for Ser-
vice Products, MB BeVo 310.1, e.g. on the
Internet at http://bevo.mercedes-benz.com.
Or contact aq ualified specialist workshop.
! Always use as uitable coolant mixture, even
in countries where high temperatures prevail.
Otherwise, the engine cooling system is not
sufficiently protected from corrosio na nd
overheating.
i Have the coolant regularl yr eplaced at a
qualified specialist workshop and the replace-
ment confirmed in the Maintenance Booklet.
Comply with the important safety precautions
for service products when handling coolant
( Y
pag e3 15).
The coolant is am ixture of water and corrosion
inhibitor/antifreeze concentrate. It performs
the following tasks: R
Anti-corrosion protection R
Antifreeze protection R
Raising the boiling point
If the coolant has antifreeze protection down to
-35 ‡( -37 †), the boiling point of the coolant
during operation is approximatel y2 66 ‡
(130 †).318
Servic ep roducts and filling capacities
Technical data

The antifreeze concentrate/corrosion inhibitor
concentration in the engine cooling system
should: R
be at least 50%. This will protec tt he engine
cooling system against freezin gd own to
approximately -35 ‡( -37 †)R
not exceed 55% (antifreez ep rotection down
to -49 ‡[ -45 †]) .O th erwise ,h ea tw ill no tb e
dissipated as effectively
Mercedes-Ben zr ecommends ac oo lan torc or -
rosio ni nh ibitor/antifreez ec oncentrat ei n
accordance wit h
MB Specification sf or Servic eP ro ducts 310. 1.
i When the vehicle is first delivered, it is filled
with ac oolant mixture that ensures adequate
antifreeze and anti-corrosion protection.
i The coolant is checked with every mainte-
nanc ei nterval at aq ualified specialist work-
shop.
Filling capacities Model Capacity
Mercedes ‑ AMG
vehicles Approx .1 2. 6USq t
(11. 9l )
Al lo th er models
Approx. 8.2 US qt
(7.8 l)
Windshield washe rs ystem
Important safety notes
G WARNING
Windshiel dw as her concentrate coul di gnite if
it comes into contact with hot engine compo-
nents or the exhaust system .T here is ar isk of
fire and injury.
Make sure that no windshield washer con-
centrate is spilled next to the filler neck.
! Only MB SummerFi ta nd MB WinterFit
washer flui ds hould be mixed together. The
spra yn ozzles may otherwise become
blocked.
Do not use distille dord e-ionized water. Other-
wise, the leve ls ensor may give af als er eading. When handling washer fluid, observe the impor-
tant safety notes on service products
( Y
pag e3 15).
At temperatures above freezing: X
Fill the washer flui dr eservoir with am ixture of
water and windshield washer fluid, e.g. MB
SummerFit.
Add 1p art MB SummerFi tto1 00 parts water.
At temperatures below freezing: X
Fill the washer flui dr eservoir with am ixture of
water and washer fluid, e.g. MB WinterFit.
For the correct mixing ratio refer to the infor-
mation on the antifreeze reservoir.
i Add windshield washer fluid, e.g. MB Sum-
merFit or MB WinterFit, to the washer flui da ll
yea rr ound.
Climate control system refrigerant
Important safety notes The climate control system of you rv ehicl eisf il-
led with refrigerant R ‑ 134a.
The instruction label regarding the refrigerant
type use dc an be found on the left, on the under-
side of the hood.
! Only the refrigerant R ‑ 134a and the PAG oil
approved by Mercedes-Benz may be used.
The approved PAG oil may not be mixed with
any other PAG oil that is not approved for
R-134a refrigerant. Otherwise, the climate
control system may be damaged.
Service work, such as refilling with refrigerant or
replacing component parts, may only be carried
out by aq ualified specialist workshop. All appli-
cabl er egulations, as wel lasS AE standard J639,
must be adhered to.
Always have work on the climate control system
carrie do ut at aq ualified specialist workshop.Service products and filling capacities 319
Technical data Z