2018 Lexus LC500 door lock

393
7
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
When trouble arises
The glove box can be opened by per-
forming the following operations after
unlocking the doors.
If the glove box is locked, unlock it with the
mechanical key. ( P.293)
1Remove the cover using a flathead
screwdriver.
To prevent damage to the cover, cover the tip of the screwdriver with a rag.
2 Push the flathead screwdriver into
the part shown in the illustration to
open the glove box.
■After opening the glove box
The glove box can be opened normally by closing the glove box after restarting the
engine .
If you have a set of jumper (or booster)
cables and a second vehicle with a 12-
volt battery, you can jump start your
vehicle using the following procedure.
1 Confirm that the electronic key is
being carried.
When connecting the jumper (or booster) cables, depending on the situation, the
alarm may activate and doors locked. ( P.77)
NOTICE
■When installing the cover in the cen- ter of the rear seat
Make sure that the seat belts are not caught in the cover. Failure to do so may cause damage to the cover installation
clip and make it impossible to install the cover.
Opening the glove box
Restarting the engine system>

398
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
ponents when the vehicle is running at a low speed for an extended period, such as in heavy traffic.
■When the 12-volt battery is removed or
discharged
●Information stored in the ECU is cleared.
When the 12-volt battery is depleted, have the vehicle inspected at any autho-rized Lexus retailer or Lexus authorized
repairer.
●Some systems may require initialization.
( P.436)
■When removing the 12-volt battery ter- minals
When the 12-volt battery terminals are removed, the information stored in the ECU is cleared. Before removing the 12-
volt battery terminals, contact any autho- rized Lexus retailer or Lexus authorized repairer.
■Charging the 12-volt battery
The electricity stored in the 12-volt battery will discharge gradually even when the
vehicle is not in use, due to natural dis- charge and the draining effects of certain
electrical appliances. If the vehicle is left for a long time, the 12-volt battery may dis-charge, and the engine
may be unable to start. (The 12-volt battery recharges automatically during driving.)
■When recharging or replacing the 12-volt battery
●In some cases, it may not be possible to unlock the doors using the smart entry &
start system when the 12-volt battery is discharged. Use the wireless remote control or the mechanical key to lock or
unlock the doors.
●The engine may not start
on the first attempt after the 12-volt bat- tery has recharged but will start normally after the second attempt. This is not a
malfunction.
●The engine switch mode
is memorized by the vehicle. When the 12-volt battery is reconnected, the system will return to the mode it was in before
the 12-volt battery was discharged.
Before disconnecting the 12-volt battery, turn the engine switch off. If you are unsure what mode the engine
switch was in before the 12-volt battery discharged, be especially careful when reconnecting the 12-volt
battery.
●If the 12-volt battery discharges, it may
not be possible to shift the shift position to other positions. In this case, the vehicle cannot be towed without lifting both rear
wheels because the rear wheels will be locked. ( P.363)
■When replacing the 12-volt battery
●Use a Central Degassing type 12-volt battery (European Regulations).
●LC500: Use a 12-volt battery that the case size is same as the previous one (LN4), 20 hour rate capacity (20HR) is
equivalent (80Ah) or greater, and per- formance rating (CCA) is equivalent (685A) or greater.
LC500h: Use a 12-volt battery that the case size is same as the previous one (LN3), 20 hour rate capacity (20HR) is
equivalent (70Ah) or greater, and perfor- mance rating (CCA) is equivalent
(600A) or greater. • If the sizes differ, the 12-volt battery can-not be properly secured.
• If the 20 hour rate capacity is low, even if the time period where the vehicle is not used is a short time, the 12-volt battery
may discharge and engine may not be able to start.
●Use a 12-volt battery with a handle. If a 12-volt battery without a handle is used, removal is more difficult.
●After exchanging, firmly attach the fol-lowing items to the exhaust hole of the 12-
volt battery. • Use the exhaust hose that was attached to the 12-volt battery before exchanging.
• Use the exhaust hole plug included with the 12-volt battery exchanged or the one installed on the battery prior to the
exchange. (Depending on the 12-volt battery to be exchanged, the exhaust hole may be plugged.)

428
-$@-$I@0.@0.&@ &&

8-2. Customization
■RSA (Road Sign Assist)*1 (P.226)
*1: If equipped
*2: If a speed limit with supplemental mark is exceeded, the warning buzzer does not oper-
ate.
*3: Including No overtaking notification and No-e ntry notification (vehicles with navigation
system)
■Active rear wing* ( P.259)
*: If equipped
■Door lock (P.115, 119, 389)
FunctionDefault settingCustomized setting
RSA (Road Sign Assist)OnOff—O—
Excess speed notification methodOnly visual
No Notification
—O—
Visual and audible*2
Excess speed notification level2 km/h (1 mph)5 km/h (3 mph)—O—10 km/h (5 mph)
Other notifications method*3Only visual
No Notification
—O—
Visual and audible*2
FunctionDefault settingCustomized setting
Operation of the active rear wingOffOn—OO
FunctionDefault settingCustomized setting
Unlocking using a mechanical key
Both side doors
unlocked in one
step
Driver’s door
unlocked in one
step, both side
doors unlocked in
two steps
——O
Speed linked door locking functionOnOffO—O
Shift position linked door locking
functionOffOnO—O
Shift position linked door unlocking
functionOffOnO—O
ABC
ABC
ABC

429
8
-$@-$I@0.@0.&@ &&

8-2. Customization
Vehicle specifications
■Smart entry & start system and wireless remote control (P.113, 122)
■Smart entry & start system (P.122)
Driver’s door linked door unlock-
ing functionOnOffO—O
Locking/unlocking of the trunk
when both side doors are
locked/unlocked
OnOff——O
Time elapsed before the door lock
indicator lights turn off30 seconds
1 minute
——O10 minutes
20 minutes
FunctionDefault settingCustomized setting
Operation signal (Emergency
flashers)OnOffO—O
Time elapsed before automatic
door lock function is activated if
door is not opened after being
unlocked
30 seconds
60 seconds
——O120 seconds
Open door warning buzzerOnOff——O
FunctionDefault settingCustomized setting
Smart entry & start systemOnOffO—O
Smart door unlockingBoth side doorsDriver’s doorO—O
Number of consecutive door lock
operations
As many as
desired2 times——O
FunctionDefault settingCustomized settingABC
ABC
ABC

430
-$@-$I@0.@0.&@ &&

8-2. Customization
■Wireless remote control (P.113)
■Driving position memory (P.140)
■Steering wheel (P.145)
FunctionDefault settingCustomized setting
Wireless remote controlOnOff——O
Unlocking operation
Both side doors
unlocked in one
step
Driver’s door
unlocked in one
step, both side
doors unlocked in
two steps
O—O
Trunk unlocking operationPress and hold
(short)
One short press
——O
Push twice
Press and hold
(long)
Off
FunctionDefault settingCustomized setting
Selecting the door linking driving
position memory with door unlock
operation
Driver’s doorBoth side doors——O
FunctionDefault settingCustomized setting
Auto tilt & telescopic away functionTilt only
Telescopic only
O—OTilt & telescopic
Off
ABC
ABC
ABC

431
8
-$@-$I@0.@0.&@ &&

8-2. Customization
Vehicle specifications
■Outside rear view mirrors (P.147)
■Power windows (P.150)
■Turn signal lever (P.186)
■Automatic light control system (P.191)
FunctionDefault settingCustomized setting
Automatic mirror folding and
extending operation
Linked to the
locking/unlock-
ing of the doors
Off
——OLinked to operation
of the engine switch

Linked mirror function when
reversingOnOff——O
FunctionDefault settingCustomized setting
Mechanical key linked operationOffOn——O
Wireless remote control linked
operationOffOn——O
Wireless remote control linked
operation signal (buzzer)OnOff——O
FunctionDefault settingCustomized setting
The number of times the turn signal
lights flash automatically when the
turn signal lever is moved to the
first position during a lane change
3
5
——O7
Off
FunctionDefault settingCustomized setting
Light sensor sensitivityStandard-2 to 2O—O
Follow me home
(Time elapsed before headlights
automatically turn off)
30 seconds
60 seconds
——O90 seconds
120 seconds
ABC
ABC
ABC
ABC

433
8
-$@-$I@0.@0.&@ &&

8-2. Customization
Vehicle specifications
■Alarm* (P.76)
*: If equipped
■Rain-sensing windshield wipers (P.196)
Operation when the doors are
unlockedOnOff——O
Operation when you approach the
vehicle with the electronic key on
your person
OnOff——O
Footwell lightingOnOff——O
Door trim ornament lightsOnOff——O
Time elapsed before the outside
door handle lights turn off15 seconds
Off
O—O7.5 seconds
30 seconds
Operation of the outside door han-
dle lights when the doors are
unlocked with the power door lock
switch
OnOff——O
Operation of the outside door han-
dle lights when a door is openedOnOff——O
Fading out of the outside door han-
dle lights when they turn offLongShort——O
FunctionDefault settingCustomized setting
Cancellation when the mechanical
key is used to unlockOffOn——O
FunctionDefault settingCustomized setting
Wiper operation when the wiper
switch is in the “AUTO” position
Rain-sensing
operation
Intermittent opera-
tion linked to vehicle
speed (with interval
adjuster)
——O
FunctionDefault settingCustomized settingABC
ABC
ABC

435
8
-$@-$I@0.@0.&@ &&

8-2. Customization
Vehicle specifications
■Vehicle customization
●When the speed-detecting automatic door lock and shift-linked automatic door
lock are both on, the door lock operates as follows.• When shifting the shift position to any
position other than P, both side the doors will be locked.• If the vehicle is started with both side
doors locked, the speed-detecting auto- matic door lock will not operate.
• If the vehicle is started with any door unlocked, the speed-detecting auto-matic door lock will operate.
●When the smart entry & start system is off, the entry unlock function cannot be
customized.
●When the doors remain closed after
unlocking the doors and the timer acti- vated automatic door lock function acti-vates, signals will be generated in
accordance with the operational signal (Emergency flashers) function setting.
●Some settings can be changed using a switch or the audio system screen. If a setting is changed using a switch, the
changed setting will not be reflected on the audio system screen until the engine switch is turned off and
then to IGNITION ON mode .
Chassis control in custom modeNormalSportO——Comfort
Air conditioning operation in cus-
tom modeNormalEcoO——
FunctionDefault settingCustomized settingABC