2018 Lexus LC500 battery

13
1
-$@-$I@/BWJ@0.&@ &&

1-1. Basic function
Quick guide
WARNING
●For safety reasons, drivers should avoid performing operations as much as possible while driving. Performing
operations while driving may cause the driver to mistakenly operate the steer-ing wheel, which may lead to an acci-
dent. Stop the vehicle before using. Furthermore, avoid looking at the screen as much as possible while driv-
ing.
●Always follow the actual traffic regula- tions and drive according to the road conditions. Routes displayed by the
destination guidance may include routes where the vehicle is prohibited from entering due to changes to speed
limit signs and routes where the road is too narrow to pass through.
NOTICE
●To prevent the 12-volt battery from becoming fully depleted, do not use
the remote touch for long periods of time while the engine/hybrid system is turned off.

18
-$@-$I@/BWJ@0.&@ &&

1-1. Basic function
The reception level of the con-
nected phone display ( P.18)
Remaining battery charge display
( P.19)
Bluetooth® phone connection
condition display ( P.19)
Wi-Fi® connection condition dis-
play ( P.18)
Shown during data communication
performed via Miracast™ ( P.18)
●The number of status icons that can be displayed differs depending on the dis-
played screen.
The level of reception does not always
correspond with the level displayed on
the cellular phone. The level of recep-
tion may not be displayed depending
on the phone you have.
When the cellular phone is out of the
service area or in a place inaccessible
by radio waves, is displayed.
“Rm” is displayed when receiving in a
roaming area. While roaming, display
“Rm” top-left on the icon.
The receiving area may not be dis-
played depending on the type of phone
you have.
While connected with cellular
phone
When using Wi-Fi®
When using Miracast™
Status icon
Status icons are displayed at the top
of the screen.
Status icon explanation
Reception level display
A
B
C
D
E
LevelIndicators
No connection
Poor
Excellent
LevelIndicators
No connection
Poor
Excellent
LevelIndicators
No connection

19
1
-$@-$I@/BWJ@0.&@ &&

1-1. Basic function
Quick guide
●When Wi-Fi®/Miracast™ function is off, no item is displayed.
The amount displayed does not always
correspond with the amount displayed
on the Bluetooth® device.
The amount of battery charge left may
not be displayed depending on the
type of the Bluetooth® device con-
nected.
This system does not have a charging
function.
An antenna for the Bluetooth® con-
nection is built into the instrument
panel.
The condition of the Bluetooth® con-
nection may deteriorate and the sys-
tem may not function when a
Bluetooth® phone is used in the fol-
lowing conditions and/or places:
The cellular phone is obstructed by
certain objects (such as when it is
behind the seat or in the glove box or
console box).
The cellular phone is touching or is
covered with metal materials.
Leave the Bluetooth® phone in a place
where the condition of the Bluetooth®
connection is good.
Poor
Excellent
Remaining battery charge dis-
play
Remaining chargeIndicators
Empty
Low
Full
Bluetooth® connection condition
display
LevelIndicators
Indica-
torsConditions
(Blue)
Indicates that the condition of
the Bluetooth® connection is
good.
(Gray)
While in this condition, sound
quality during phone calls may
deteriorate.
Indicates that the cellular phone
is not connected via Bluetooth®.

69
3
-$@-$I@/BWJ@0.&@ &&

3-1. Basic operation
Navigation system
1Press the “MAP” button on the
Remote Touch.
2 Select “Continue”.
 After about a few seconds, the cau-
tion screen automatically switches
to the map screen.
When starting the navigation system,
the current position is displayed first.
This screen displays the current vehicle
position and a map of the surrounding
area.
1 A short while later after the select-
ing “MAP” button on the Remote
Touch, the display automatically
switches to map screen.
 The current vehicle position mark
appears in the centre of the map
screen.
●While driving, the current vehicle posi- tion mark is fixed on the screen and the map moves.
●The current position is automatically set as the vehicle receives signals from the
GPS (Global Positioning System). If the current position is not correct, it is auto-matically corrected after the vehicle
receives signals from the GPS.
●After battery disconnection, or on a new vehicle, the current position may not be correct. As soon as the system receives
signals from the GPS, the correct current position is displayed.
Use the scroll feature to move the
desired point to the center of the
screen for looking at a point on the
map screen that is different from the
current position.
1 Select the desired point on the map
screen.
 Move the desired point on the cen-
ter of the map screen.
 After the screen is scrolled, it is pos-
sible to do the drag or flick opera-
tion on the touchpad.
Map screen operation
Displaying map screen
Current vehicle position display
Screen scroll operation

121
4
-$@-$I@/BWJ@0.&@ &&

4-1. Basic operation
Audio/visual system
■Certification
• CAUTION:
THIS PRODUCT IS A CLASS I LASER PRODUCT. USE OF CONTROLS OR
ADJUSTMENTS OR PERFOR- MANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADI- ATION EXPOSURE. DO NOT OPEN COVERS AND DO NOT REPAIR BY
YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL.
“PWR·VOL” knob: Press to turn the
audio/visual system on and off. The sys-
tem turns on in the last mode used.
Turn this knob to adjust the volume.
 A function that enables automatic
return to the previous screen from
the audio/visual screen can be
selected. ( P.56)
Using the audio control switch
1 Display the audio control screen.
2 Each time the “RADIO” or
“MEDIA” button is pressed, the
audio source changes.
“RADIO” button: To change radio
modes.
“MEDIA” button: To change media
modes.
From the audio source selection
screen
1 Display the audio control screen.
2 Select “Source” on the sub menu.
3 Select the desired source.
●Dimmed screen buttons cannot be oper- ated.
Some basics
This section describes some of the
basic features of the audio/visual
system. Some information may not
pertain to your system.
Your audio/visual system works
when the engine switch switch> is in ACCESSORY or
IGNITION ON mode .
NOTICE
●To prevent the 12-volt battery from
being discharged, do not leave the audio/visual system on longer than necessary when the engine is not run-
ning .
Turning the system on and off
Selecting an audio source

138
-$@-$I@/BWJ@0.&@ &&

4-3. Media operation
The track currently being listened to
can be repeated.
1 Select .
●Each time is selected, the mode
changes as follows:
When shuffle is off (iPhone 5 or later) • file/track repeat  folder/album repeat
 off
When shuffle is off (iPhone 4s or earlier)
• file/track repeat  off
When shuffle is on
• file/track repeat  off
It depends on the models.
Tracks or albums can be automatically
and randomly selected.
1 Select .
●Each time is selected, the mode
changes as follows:
• track shuffle  album shuffle  off
It depends on the models.
Turn to select a track.
Turn and hold to fast for-
ward/rewind.
Turn to select a track.
Turn to move up/down the list.
●When an iPod is connected using a genu- ine iPod cable, the iPod starts charging its battery.
●Depending on the iPod and the songs in the iPod, iPod cover art may be displayed.
This function can be changed to “On” or “Off”. ( P.148) It may take time to dis- play iPod cover art, and the iPod may not
be operated while the cover art display is in process.
●When an iPod is connected and the audio source is changed to iPod mode, the iPod
will resume playing from the same point it was last used.
●Depending on the iPod that is connected to the system, certain functions may not be available.
●The system may not function properly if a conversion adapter is used to connect a
device.
Repeating
Random order
Audio control switch
WARNING
●Do not operate the player’s controls or connect the iPod while driving.
NOTICE
●Depending on the size and shape of
the iPod that is connected to the sys- tem, the console box may not close fully. In this case, do not forcibly close
the console box as this may damage the iPod or the terminal, etc.
●Do not leave your portable player in the car. In particular, high tempera-
tures inside the vehicle may damage the portable player.
A
B

140
-$@-$I@/BWJ@0.&@ &&

4-3. Media operation
Displays cover art
Select to set repeat playback.
( P.140)
Select to select a track.
Select and hold to fast rewind.
Select to play/pause.
Select to select a track.
Select and hold to fast forward.
Select to set random playback.
( P.140)
The track or album currently being lis-
tened to can be repeated.
1 Select .
●Each time is selected, the mode
changes as follows:
• track repeat  album repeat  off
Tracks or albums can be automatically
and randomly selected.
1 Select .
●Each time is selected, the mode
changes as follows:
•album random  all track random  off
Turn to select a track.
Turn and hold to fast for-
ward/rewind.
Turn to select a track.
Turn to move up/down the list.
●Depending on the Bluetooth® device that is connected to the system, the music
may start playing when selecting
while it is paused. Conversely, the music
may pause when selecting while it is
playing.
●In the following conditions, the system may not function:
• The Bluetooth® device is turned off.
• The Bluetooth® device is not connected.
• The Bluetooth® device has a low battery.
●It may take time to connect the phone
when Bluetooth® audio is being played.
●For operating the portable player, see the instruction manual that comes with it.
●If the Bluetooth® device is disconnected due to poor reception from the
Bluetooth® network when the engine switch is in ACCES-
Control screen
Repeating
Random order
A
B
C
D
E
F
Audio control switch
A
B

186
-$@-$I@/BWJ@0.&@ &&

6-1. Lexus parking assist monitor
The guide lines are very far
out of alignment
The camera position is out of
alignment.
Have the vehicle inspected by
any authorized Lexus retailer
or Lexus authorized repairer,
or any reliable repairer.
 The vehicle is tilted (there is
a heavy load on the vehicle,
tire pressure is low due to a
tire puncture, etc.)
 The vehicle is used on an
incline.
If this happens due to these
causes, it does not indicate a
malfunction.
Back up while visually check-
ing the vehicle’s surroundings.
The estimated course lines
move even though the
steering wheel is straight
There is a malfunction in the
signals being output by the
steering sensor.
Have the vehicle inspected by
any authorized Lexus retailer
or Lexus authorized repairer,
or any reliable repairer.
Guide lines are not dis-
playedThe trunk is open.
Close the trunk.
If this does not resolve the
symptom, have the vehicle
inspected by any authorized
Lexus retailer or Lexus autho-
rized repairer, or any reliable
repairer.
The estimated course lines
are not displayed
 The steering wheel has
been moved while the 12-
volt battery was being rein-
stalled.
 12-volt battery power is
low.
 The steering sensor has
been reinstalled.
 There is a malfunction in
the signals being output by
the steering sensor.
Stop the vehicle, and turn the
steering wheel as far as it will
go to the left and right.
If this does not resolve the
symptom, have the vehicle
inspected by any authorized
Lexus retailer or Lexus autho-
rized repairer, or any reliable
repairer.
SymptomLikely causeSolution