Fog lights are used to provide improved
visibility when visibility is poor due to fog, rain or snow, etc. The fog lights
will turn on when the fog light switch
(1) is turned on after the parklight is turned on.
To turn off the fog lights, turn the fog
light switch (1) to the O (Off) position.
CAUTION
When in operation, the fog lightsconsume large amounts of vehicleelectrical power. Only use the foglights when visibility is poor.
Rear fog light (if equipped)
¥ 5 Z Q F "
¥ 5 Z Q F #
To turn the rear fog lights on, turn the
rear fog light switch (1) to the on posi‐ tion when the headlight is turned on. Also, the rear fog lights turn on when
the rear fog light switch is turned on
after the front fog light switch (if equipped) is turned on and the head‐
light switch is in the parklight position.
To turn the rear fog lights off, turn the
rear fog light switch to the on position again.
NOTICE
Rear fog light is only on the driver’s
side (if equipped).
Static bending light (if equipped)
While driving the corner, for your sight
and safety, the static bending light is turned on automatically. The system
will operate automatically as follows. • When turning the headlight on
• When the angle of steering wheel is over 35~40 (it is differed from vehicle
speed)
• When the vehicle speed is over 3 km/h
• When driving forward or backward.
Features of your vehicle
4-86
Daytime running light (if
equipped)
The Daytime Running Lights (DRL) can
make it easier for others to see the front of your vehicle during the day.
DRL can be helpful in many different
driving conditions, and it is especially helpful after dawn and before sunset. The DRL system turns OFF when: 1. The headlight switch is ON.
2. The engine is OFF.
3. The front fog light is on.
4. Engaging the Parking Brake
Headlight leveling device (if
equipped)
0 : #
To adjust the headlight beam level ac‐
cording to the number of the passen‐ gers and loading weight in the luggage
area, turn the beam leveling switch.
The higher the number of the switch
position, the lower the headlight beam level. Always keep the headlight beam
at the proper leveling position, or head‐
lights may dazzle other road users.
Listed below are the examples of prop‐ er switch settings. For loading condi‐
tions other than those listed below, ad‐
just the switch position so that the beam level may be the nearest as the
condition obtained according to the list.
Loading conditionSwitch position
Driver only 0
Driver + Front passenger 0
Full passengers
(including driver) 1
Full passengers
(including driver) +Maximum permis‐sible loading 2
Driver + Maximumpermissible load‐ing 3
4-87
4
Features of your vehicle