2018 KIA STONIC window

WIPER BLADES
Blade inspection
NOTICE
Commercial hot waxes applied by
automatic car washes have been
known to make the windshield diffi‐
cult to clean.
Contamination of either the windshield
or the wiper blades with foreign matter can reduce the effectiveness of the
windshield wipers. Common sources of
contamination are insects, tree sap, and hot wax treatments used by some
commercial car washes. If the blades
are not wiping properly, clean both the window and the blades with a good
cleaner or mild detergent, and rinse
thoroughly with clean water.
CAUTION
To prevent damage to the wiperblades, do not use gasoline, kero‐sene, paint thinner, or other solventson or near them.
Blade replacement
When the wipers no longer clean ade‐
quately, the blades may be worn or cracked, and require replacement.
CAUTION
To prevent damage to the wiperarms or other components, do not
(Continued)
(Continued)
attempt to move the wipers man‐ually.
CAUTION
The use of a non-specified wiperblade could result in wiper malfunc‐tion and failure.
Front windshield wiper blade
Maintenance
8-60

2. Lift up the wiper blade clip. Thenpull down the blade assembly and
remove it.
3. Install the new blade assembly.
Rear window wiper blade
1. Raise the wiper arm (1) and pull out the wiper blade assembly.
2. Install the new blade assembly byinserting the center part into the
slot in the wiper arm until it clicks
into place.
3. Make sure the blade assembly is in‐ stalled firmly by trying to pull it
slightly.
To prevent damage to the wiper arms or other components, have the wiper
blade replaced by a professional work‐
shop. Kia recommends to visit an au‐ thorized Kia dealer/service partner.
Maintenance
8-62

❈The actual battery label in the vehi‐
cle may differ from the illustration.
1. AGM90L-DIN : The Kia model name
of battery
2. 90Ah(20HR) : The nominal capacity (in Ampere hours)
3. 170RC : The nominal reserve ca‐ pacity (in min.)
4. 12V : The nominal voltage
5. 850CCA (SAE) : The cold-test cur‐ rent in amperes by SAE
6. 680A : The cold-test current in am‐ peres by EN
Battery recharging
Your vehicle has a maintenance-free,
calcium-based battery. • If the battery becomes discharged in a short time (because, for example,the headlights or interior lights were
left on while the vehicle was not in
use), recharge it by slow charging
(trickle) for 10 hours.
• If the battery gradually discharges because of high electric load while
the vehicle is being used, recharge it
at 20-30A for two hours.
WARNING
nRecharging battery
When recharging the battery, ob‐serve the following precautions:•The battery must be removedfrom the vehicle and placed in anarea with good ventilation.
•Do not allow cigarettes, sparks, orflame near the battery.
•Watch the battery during charg‐ing, and stop or reduce the charg‐ing rate if the battery cells begingassing (boiling) violently or if thetemperature of the electrolyte ofany cell exceeds 49°C (120°F).
•Wear eye protection when check‐ing the battery during charging.
•Disconnect the battery charger inthe following order.1.Turn off the battery chargermain switch.
2.Unhook the negative clampfrom the negative battery ter‐minal.
3.Unhook the positive clamp fromthe positive battery terminal.
WARNING
•Before performing maintenance orrecharging the battery, turn off allaccessories and stop the engine.
•The negative battery cable mustbe removed first and installed lastwhen the battery is disconnected.
•Operation related to the battery isrecommended to be done by aprofessional workshop. Kia recom‐mends to visit an authorized Kiadealer/service partner.
CAUTION
•Keep the battery away from wa‐ter or any liquid.
•For your safety, use parts for re‐placement from a professionalworkshop. Kia recommends to visitan authorized Kia dealer/servicepartner.
Reset items
Items should be reset after the battery
has been discharged or the battery has been disconnected. • Auto up/down window

8-65
8
Maintenance

(Continued)
Do not try remodeling the vehicle in
any way. It is illegal, and may affect
the vehicle’s performance, durability,
and safety. Warranty is also not
provided for problems caused by re‐
modeling.
Be aware of safety problems caused
by remodeling the vehicle with unau‐
thorized electrical devices (lamp,
black box, electrical equipment, diag‐
nostic device, communication device,
etc.). It might cause malfunction of
the vehicle, wiring damage, battery
discharge, connector damage, or
fire. the vehicle or cause fire.
NOTICE
nWindow tinting precaution
Window tint (especially metallic film)
might cause communication disorder
or poor radio reception, and mal‐
function of the automatic lighting
system due to excessive change of
(Continued)
(Continued)
illumination inside the vehicle. The
solution used might also flow into
electric, electronic devices causing
disorder and failure.
Inner panel fuse replacement
0:#
1. Turn the ignition switch and all oth‐er switches off.
2. Open the fuse panel cover.
3. Pull the suspected fuse straight out. Use the removal tool provided
in the main fuse box in the engine
compartment.
4. Check the removed fuse; replace it if it is blown.
Spare fuses are provided in the in‐
strument panel fuse panel (or in
the engine compartment fuse pan‐
el).
5. Push in a new fuse of the same rating, and make sure it fits tightly
in the clips.
If it fits loosely, consult a professional
workshop. Kia recommends to consult an authorized Kia dealer/service part‐
ner.

8-79
8
Maintenance

Instrument panel (Driver’s side fuse panel)
SymbolFuse rat‐ingCircuit Protected
20A Tail Gate Unlock Relay, Dead Lock Relay, Door Lock/Unlock Relay
20A Power Outlet
25A Driver Safety Power Window Module
STOP
LAMP15A Stop Signal Electronic Module
15A BCM (Body Control Module), SLM Unit
20A Cigarette Lighter
10A Driver Power Outside Mirror, Passenger Power Outside Mirror, Air Conditioner Control Module, ECM
(Engine Control Module)/PCM (Power train Control Module)
10A Outside Mirror Folding
RH25A Power Window Main Switch, Passenger Power Window Switch(LHD)
20A Front Seat Warmer Control Module
10A DRL (Daytime Running Light) Relay
7.5A With Immobilizer & Smart Key : ECM (Engine Control Module)/PCM (Power train Control Module), En‐ gine Room Junction Block(Start Relay)
Without Immobilizer & Smart Key : Burglar Alarm Relay
7.5A Head Lamp RH, License Lamp RH(Sedan), Rear Combination Lamp (IN) RH(Wagon), ILL (+)
Maintenance

8-84

SymbolFuse rat‐ingCircuit Protected
10ABCM (Body Control Module), Crash Pad Switch, FCA Unit, Lane Departure Warning System, BLIND-
SPOT DETECTION WARNING Radar LH/RH
15AEngine Room Junction Block(Back-Up Lamp Switch), Sport Mode Switch, Speed Sensor, Stop Lamp
Switch, Speed Sensor (In/Out), Transaxle Range Switch
LH25A Power Window Main Switch, Passenger Power Window Switch(RHD)
SPARE25A Spare
10A Rear Fog Lamp Relay
15A Clock Spring
LH7.5A Head Lamp LH, License Lamp LH(Sedan), Rear Combination Lamp (IN) LH(Wagon)
7.5A Front Console Switch, Front Seat Warmer Control Module, Audio, Audio / Video & Navigation Head
Unit, Head Lamp Leveling Device Actuator LH/RH, Air Conditioner Control Module, Electro Chromic
Mirror, Crash Pad Switch, DC-DC Converter, Clock Spring, A/T Shift Lever Indicator
7.5A
Engine Room Junction Block(Multipurpose Check Connector), ABS/ESC (Electronic Stability Control)
Control Module
10A Smart Key Control Module, Stop Lamp Switch
SPARE15A Spare
15A Front Fog Lamp Relay
7.5AEngine Room Junction Block(Air Conditioner Blower Relay), GSL Junction Block(PTC Heater Relay),
DSL Junction Block(Start Relay, Air Conditioner Blower Relay), Air Conditioner Control Module
MODULE510AEngine Room Junction Block(Head Lamp High Relay, Head Lamp Relay), Front Seat Warmer Control
Module, BCM (Body Control Module)


8-85
8
Maintenance

SymbolFuse ratingCircuit Protected
IGN
COIL20A Ignition Coil #1~#4
INJECTOR15A Fuel Pump Relay, ECM (Engine Control Module)
10A Back-Up Lamp Switch
40A Instrument Panel Junction Block
50A Instrument Panel Junction Block (Power Window Relay)
40A Ignition Switch, PDM Relay Box (IG2 Relay)
60A Cooling Fan Relay
30A Fuse - ENG E3, ENG E4, Main Relay
10A Air Conditioner Clutch Type ECV Relay
20A Head Lamp Relay
20A Head Lamp High Relay
FUEL
PUMP20A Fuel Pump Relay
15A Horn Relay, Burglar Alarm Horn Relay
AMS10A Battery Sensor
40A Instrument Panel Junction Block (Tail Lamp Relay)
40A Ignition Switch, PDM Relay Box (IG1 Relay, ACC Relay)
Maintenance
8-92

SymbolFuse ratingCircuit Protected
10A Back-Up Lamp Switch
40A Instrument Panel Junction Block
50A Instrument Panel Junction Block (Power Window Relay)
40A Ignition Switch, PDM Relay Box (IG2 Relay)
40A Cooling Fan1 Relay, Cooling Fan2 Relay
30A Main Relay
10A Air Conditioner Clutch Type ECV Relay
20A Head Lamp Relay
20A Head Lamp High Relay
FUEL
PUMP20A Fuel Pump Relay
15A Horn Relay, Burglar Alarm Horn Relay
E315A ECM/PCM
AMS10A Battery Sensor
40A Instrument Panel Junction Block (Tail Lamp Relay)
40A Ignition Switch, PDM Relay Box (IG1 Relay, ACC Relay)
POWER
OUTLET40A Instrument Panel Junction Block (Power Outlet Relay)

8-95
8
Maintenance