106 uu Indicators u Driver Information Interface Wa rning and Information Messages
Instrument Panel Message Condition Explanation●
Appears after the driver’s door is opened when the
power mode is in ACCESSORY. ●
Press the POWER button twice with your foot off the
brake pedal to change the power mode to VEHICLE
OFF.●
Appears when the power mode is in ACCESSORY.
—●
Appears when you close th e door with the power
mode in ON without the smart entry remote inside
the vehicle. ●
Disappears when you bring the smart entry remote back
inside the vehicle and close the door. 2 Smart Entry Remote Reminder P. 160●
Appears when the smart entry remote battery
becomes weak. ●
Replace the battery as soon as possible. 2 Replacing the Button Battery P. 510●
Appears if the smart entry remote’s battery is too
weak to turn on the power system or the key is not
within operating range to turn on the power system.
A beeper sounds six times. ●
Bring the back of the smart entry remote into contact
with the POWER button.2 If the Smart Entry Remote Battery is Weak P. 537●
Appears when you set the power mode to
ACCESSORY or ON. ●
Appears after you unlock a nd open the driver’s door. 2 Turning on the Power P. 376●
Appears when the POWER button is pressed while
driving. 2 Emergency Power System Off P. 538Canadian models18 CLARITY PHEV CSS-31TRW6000.book 106 ページ ２０１７年８月３１日 木曜日 午後２時４９分
uu Security System u Security System Alarm
154
Controls ■ Setting the security system alarm
The security system alarm automatically sets when th e following conditions have
been met:
• The power mode is set to VEHICLE OFF (LOCK).
• The hood is closed.
• All doors and the trunk are locked from outside with the key , remote transmitter
or smart entry system.
■ When the security system alarm sets
The security system alarm indicator in the instrument panel blinks. When the
blinking interval changes after about 15 seconds, the security system alarm is set.
■ To cancel the security system alarm
The security system alarm is canceled when the vehicle is unloc ked using the remote
transmitter, smart entry system, or the power mode is set to ON. The security system
alarm indicator goes off at the same time. 1 Security System Alarm
Do not set the security system alarm when someone
is in the vehicle or a window is open. The system can
accidentally activate when:
• Unlocking the door with the lock tab.
• Opening the trunk with the trunk opener or the
emergency trunk opener.
• Opening the hood with the hood release.
If the 12-volt battery goes dead after you have set the
security system alarm, the security alarm may go off
once the 12-volt battery is recharged or replaced.
If this occurs, deactivate the security system alarm by
unlocking a door using the key, remote transmitter or
smart entry system.18 CLARITY PHEV CSS-31TRW6000.book 154 ページ ２０１７年８月３１日 木曜日 午後２時４９分
