2018 FIAT 500 hill

KNOWING YOUR CAR
12
HOT ENGINE COOLANT
The warning light switches on when the ignition key is turned to MAR, but it should switch off after a few seconds.
The warning light or symbol on the display lights up when the engine is overheated, on some versions, together with a
dedicated message on the display.
❒ In normal driving conditions: stop the car, switch off the engine and check that the fluid level in the reservoir is not
below the MIN mark. In this case, wait for the engine to cool down, then slowly and carefully open the cap, top up with
coolant and check that the level is between the MIN and MAX marks on the reservoir itself. Also check visually for any
fluid leaks. Should the warning light turn on again at the next start-up, contact a Fiat Dealership.
❒ if the vehicle is used under demanding conditions (e.g. towing trailers uphill or fully loaded): slow down and, if the
light stays on, stop the car. Stop for two or three minutes with the engine running and slightly accelerated to facilitate
better coolant circulation, then turn the engine off. Check that the coolant level is correct as described above.
IMPORTANT Over demanding routes, it is advisable to keep the engine running and slightly accelerated for a few minutes
before turning it off.
On certain versions the dedicated message is displayed.uu
{{
“DUALDRIVE” ELECTRIC POWER STEERING FAULT
When the key is turned to MAR, the warning light switches on but it should switch off after a few seconds.
If the warning light stays on, on some versions along with a dedicated message on the display, you may not have steering
assistance and the effort required to operate the steering wheel could be notably increased; steering is, however, possible.
In this case, contact a Fiat Dealership.
If the warning light switches on while driving (on some versions, together with a dedicated message on the display) you may
not have steering assistance. Although it will still be possible to steer the vehicle, the effort needed to operate the steering
wheel could be increased: contact a Fiat Dealership as soon as possible.
IMPORTANT In some circumstances, factors independent of the electric power steering could cause the warning light on
the instrument panel to switch on. In this case, stop the car immediately (should it be in motion), stop the engine for about
20 seconds and then restart the engine. If the warning light stays on, contact a Fiat Dealership.
IMPORTANT After the battery is disconnected, the steering must be initialised. The warning light switches on to indicate
this. To carry out this procedure, simply turn the steering wheel all the way from one end to the other or drive in a straight
line for about a hundred metres.

19
ESC SYSTEM (for versions/markets, where required)
The warning light switches on when the ignition key is turned to MAR, but it should switch off after a few seconds.
ESC system activation
Flashing of the warning light while driving indicates the intervention of the ESC system.
ESC system failure
If the warning light does not go off or stays on together with the LED on the ASR OFF button while driving.
The display will show a dedicated message.
Contact a Fiat Dealership.
Hill Holder failure
This warning light switches on, on some versions together with a dedicated message on the display, in the event of a Hill
Holder system fault.
In this case, contact a Fiat Dealership as soon as possible. Parking sensor fault
The warning light turns on and the dedicated message is shown on the display when a parking sensor fault is detected.
Start&Stop system fault (versions with multifunction display)
A fault of the system is indicated by the warning light switching on. A dedicated message will appears on the instrument
panel.
Airbag warning light fault (for versions/markets, where provided)
The warning light will blink when a fault of the
¬warning light is detected.
ESCESC
BRAKE PAD WEAR
The warning light switches on, together with a dedicated message on the display, if the front or rear brake pads (on
version/markets, where provided) are worn.
In this case have them replaced as soon as possible.
dd
POSSIBLE ICE ON ROAD
The symbol is shown on the display (on some versions together with a dedicated message) when the outside temperature
is equal to or below 3°C.
èè
(versions with
multifunction
display)
(versions with
multifunction
display)

21
PARKING SENSOR FAULT (colour display – for versions/markets, where provided)
The symbol is shown on the display together with a dedicated message if there is a fault in the parking sensors. Contact a
Fiat Dealership.
HILL HOLDER FAULT (colour display) (for versions/markets, where provided)
The symbol will appear on the display together with a dedicated message when there is a fault in the Hill Holder system.
In this case, contact a Fiat Dealership as soon as possible.
**
DUSK SENSOR FAILURE
The symbol switches on along with a message on the display in the event of dusk sensor failure. Contact a Fiat Dealership
as soon as possible.
RAIN SENSOR FAILURE
The symbol switches on in the case of failure of the rain sensor. Contact a Fiat Dealership as soon as possible.
SPEED LIMITER FAILURE
The symbol switches on in the case of failure of the Speed Limiter device. Contact a Fiat Dealership as soon as possible to
have the failure eliminated.

49
ESC (Electronic
Stability Control)
system 15)
This is an electronic system that
controls vehicle stability in the event of
tyre grip loss, helping maintain
directional control.
The system is capable of recognising
potentially dangerous situations in
terms of the stability and intervenes
automatically on the brakes in a
differentiated manner for the four
wheels in order to provide a stabilising
torque.
The ESC system also includes the
following subsystems:
❒ HH (Hill Holder): it activates
automatically when starting with car
stationary, on a road with a
gradient higher than 5%.
❒ ASR (AntiSpin Regulation):
The system automatically operates
in the event of slipping, loss of grip
on wet roads (aquaplaning) and
acceleration on slippery, snowy or
icy roads, etc. on one or both drive
wheels.
The ASR comes on automatically
whenever the engine is started. When
driving it is possible to deactivate and
then reactivate the ASR system by
pressing the button A fig. 50: the
system activation is signalled by the
LED on the same button switching on
and, on some versions, by a message
on the display.
❒ HBA (Hydraulic Brake Assist): it
operates automatically and
improves the braking capacity of the
vehicle during emergency braking.
50DVDF0S0151c
SYSTEM INTERVENTION
It is signalled by the blinking of the
warning light
Ion the instrument
panel, to inform the driver that the car
is in critical stability and grip
conditions.
SYSTEM ACTIVATION
The ESC system switches on
automatically when the engine is
started and cannot be switched off.

STARTING AND DRIVING
120
PARKING THE
VEHICLE
When parking and leaving the car,
proceed as follows:
❒ engage a gear (1st gear if facing
uphill or reverse if facing downhill)
and leave the wheels turned;
❒ stop the engine and engage the
handbrake;
❒ always remove the key from the
starter switch.
Block the wheels with a wedge or a
stone if the car is parked on a steep
slope.
On versions equipped with automatic
transmission, wait for the letter P to be
displayed before releasing the brake
pedal.
IMPORTANT NEVER leave the car with
the gearbox in neutral (or, on versions
equipped with automatic transmission,
before putting the shift lever at P).
HANDBRAKE 27)
The handbrake lever fig. 86 is located
between the two front seats.
To use the handbrake pull the lever
upwards until the car cannot be
moved.
To release the handbrake, raise the
lever slightly and press the release
button A fig. 86; hold down the button
and lower the lever.
86DVDF0S162c
USING THE MANUAL
GEARBOX
28) 14)
To engage the gears, press the clutch
pedal fully and put the gear lever into
one of the required positions (the
diagram is shown on the knob fig. 87).
For cars provided with 6-speed
gearbox, to engage the 6
thgear,
operate the lever by pressing it
towards the right in order to avoid
engaging the 4
thgear by mistake. The
same applies to shifting from 6thto 5th
gear.
87DVDF0S0156c

STARTING AND DRIVING
126
SETTING THE
DESIRED SPEED
Proceed as follows:
❒ activate the device by turning the
ring C fig. 95 downwards.
❒ when the vehicle has reached the
desired speed, turn the ring B fig. 95
upwards (or downwards) and release it
to activate the device. When the
accelerator is released, the vehicle will
automatically maintain the selected
speed.
If needed (e.g. when overtaking), you
can increase speed simply by pressing
the accelerator; when you release the
pedal, the vehicle goes back to the
speed stored previously.
When travelling downhill with the device
active, the vehicle speed may slightly
exceed the set one.
WARNING Before turning the ring B
upwards or downwards, the vehicle
must travel at a constant speed on
level ground.
INCREASING THE SPEED
Once the electronic Cruise Control has
been activated, the speed can be
increased by turning the ring B
upwards.
DECREASING SPEED
To decrease the speed with the device
activated, turn the ring B downwards.
RECALLING THE SPEED
For versions with Dualogic transmission
operating in D (Drive - automatic)
mode, press and release the
CANC/RES A button (fig. 95).
For versions with manual or Dualogic
transmission in sequential mode,
before recalling the previously set
speed you should accelerate to get
close to it, then press and release the
CANC/RES A button.
DEACTIVATING
THE DEVICE
Lightly pressing the brake pedal or
pressing the CANC button deactivates
the electronic Cruise Control without
deleting the stored speed.
Changing gear deactivates the Cruise
Control.
DEACTIVATING
THE DEVICE
The electronic Cruise Control is
disabled by turning the ring
C fig. 95 to the 0 position or putting the
starter switch at STOP.

IN AN EMERGENCY
128
BUMP STARTING13)
Never bump start the engine by
pushing, towing or driving downhill.
This could cause fuel to flow into the
catalytic converter and damage it
beyond repair.
IMPORTANT Remember that the
brake servo and electrical power
steering system (where provided) are
not operational until the engine is
started, a greater effort will therefore
be required to press the brake pedal
or turn the steering wheel.
CHANGING A
WHEEL 32) 30)
JACK
Please note that:
❒ the jack weighs 1.76 kg;
❒ the jack requires no adjustment;
❒ the jack cannot be repaired; if it
breaks, it must be replaced with a
new one of the same type;
❒ no tool other than its cranking
device may be fitted on the jack.
SERVICING
❒ prevent any dirt from depositing on
the “worm screw”
❒ keep the “worm screw” lubricated
❒ never modify the jack.
CONDITIONS OF NON-
USE
❒ at temperatures lower than -40°C
on a sandy or muddy ground
❒ on uneven ground
❒ on a road with steep gradient
❒ in extreme weather conditions:
thunderstorms, typhoons,
hurricanes, blizzards, storms, etc.
❒ in direct contact with the engine or
to carry out repairs under the
vehicle
❒ on boats.
RAISING WITH A JACK
AND REPLACING A
WHEEL
To change a wheel, proceed as
follows:
❒ Stop the car in a position that is
not dangerous for oncoming traffic
where you can change the wheel
safely. The ground must be flat and
sufficiently compact.
❒ Turn the engine off and pull up the
handbrake.
❒ Engage first gear or reverse.
❒ Lift up the luggage compartment
mat and loosen the central locking
device A - fig. 99.
❒ Take out the tool container
B and take it near to the wheel to
be changed.
❒ Take the space-saver wheel C.

PERSONAL SAFETY
187
IMPORTANT INFORMATION AND
RECOMMENDATIONS
3) ADJUSTMENTS
Any and all adjustments to seats, head restraints, steering wheel or
rear view mirrors must be performed exclusively with the
vehicle stationary and the engine off.
4) SEATS
•If a side bag is fitted, it is dangerous to use
seat covers not available from Lineaccessori MOPAR
®.
•Once you have released the adjustment lever, always check that
the seat is locked on the guides by trying to move it back and
forth. If the seat is not locked into place, it may unexpectedly slide
and cause the driver to lose control of the car.
5) HEAD RESTRAINTS
• All adjustments must be carried out only with the car stationary
and engine off. The head restraints should be adjusted to support
the back of your head and not your neck. Only in this position do
they exert their protective action.
• To make the best use of the protective action of the head
restraints, adjust the backrest so that you are sitting upright and
keep your head as close as possible to the head restraint.
6) REAR VIEW MIRRORS
As door mirrors are curved, they may slightly alter the perception
of distance. When driving, these mirrors must always be in the
open position.
We recommend you carefully read the following environmental information.
In an emergency we recommend that you call the toll-free phone number found in the Warranty Booklet.
Go to the www.fiat500.com website to locate the Fiat Dealership closest to you.
(CONTINUES)
1) THE KEYS
Press button B fig. 9 only with the key away from your body,
especially your eyes and from objects which could get damaged
(e.g. your clothes).
Do not leave the key unattended to avoid the button being
accidentally pressed while it is being handled, e.g. by a child.
2) STARTING DEVICE
• Never remove the key while the car is moving.
The steering wheel will automatically lock as soon as it is turned.
This holds true for cars being towed as well.
• It is absolutely forbidden to carry out any after-market operation
involving steering system or steering column modifications
(e.g. installation of anti-theft device) that could adversely affect
performance and safety, invalidate the warranty and also result in
non-compliance of the vehicle with type-approval requirements.
•If the ignition device has been tampered with
(e.g. an attempted theft), have it checked over by a Fiat
Dealership before driving again.
•Always remove the key when you leave your car to prevent
someone from accidentally operating the controls.
Remember to engage the handbrake.
If the car is parked on a slope uphill, engage the first gear; if the
car is facing downhill, engage the reverse gear. Never leave
children unattended in the vehicle.