2018 FIAT 500 fuel

STARTING AND DRIVING
122
SPORT function
(1.4 16V versions – for versions /
markets, where provided)
On these versions, the driver can also
use the SPORT function which enables
a sporty driving setting by intervening
on gear changes, the engine control
unit and the steering. To activate this
function, press the SPORT button
fig. 90 on the dashboard.
90DVDF0S0194c
ECO function
The ECO function, which optimises the
gearbox, can be activated only with
AUTO mode on.
This function is activated by pressing
button E fig. 88 on the trim next to the
gear lever (on 1.2 8V versions), or by
pressing the ECO button fig. 89 on the
dashboard (on 0.9 TwinAir 85 HP
versions).
With the ECO function active, the
display will show the current gear and
the words AUTO and ECO; the system
will select the most suitable gear
depending on the car speed, engine
rpm and intensity with which the
accelerator pedal is pressed, with the
aim of limiting fuel consumption.
89DVDF0S0193c
SHIFT PADDLES
(for versions/markets, where provided)
fig. 91
Shifting can be managed sequentially
via the shift paddles on the steering
wheel.
❒ To use the steering wheel paddles,
the gear lever A-fig. 88 must be in
the middle position between
+ and –.
To shift up: pull the right paddle +
towards the steering wheel.
To shift down:pull the left paddle –
towards the steering wheel.
NOTE Shifting up (or down) is only
permitted if the engine rpm allow it.
NOTE For correct use of the system,
you are advised only to use your right
foot to operate the pedal unit.
91DVDF0S0195c

IN AN EMERGENCY
128
BUMP STARTING13)
Never bump start the engine by
pushing, towing or driving downhill.
This could cause fuel to flow into the
catalytic converter and damage it
beyond repair.
IMPORTANT Remember that the
brake servo and electrical power
steering system (where provided) are
not operational until the engine is
started, a greater effort will therefore
be required to press the brake pedal
or turn the steering wheel.
CHANGING A
WHEEL 32) 30)
JACK
Please note that:
❒ the jack weighs 1.76 kg;
❒ the jack requires no adjustment;
❒ the jack cannot be repaired; if it
breaks, it must be replaced with a
new one of the same type;
❒ no tool other than its cranking
device may be fitted on the jack.
SERVICING
❒ prevent any dirt from depositing on
the “worm screw”
❒ keep the “worm screw” lubricated
❒ never modify the jack.
CONDITIONS OF NON-
USE
❒ at temperatures lower than -40°C
on a sandy or muddy ground
❒ on uneven ground
❒ on a road with steep gradient
❒ in extreme weather conditions:
thunderstorms, typhoons,
hurricanes, blizzards, storms, etc.
❒ in direct contact with the engine or
to carry out repairs under the
vehicle
❒ on boats.
RAISING WITH A JACK
AND REPLACING A
WHEEL
To change a wheel, proceed as
follows:
❒ Stop the car in a position that is
not dangerous for oncoming traffic
where you can change the wheel
safely. The ground must be flat and
sufficiently compact.
❒ Turn the engine off and pull up the
handbrake.
❒ Engage first gear or reverse.
❒ Lift up the luggage compartment
mat and loosen the central locking
device A - fig. 99.
❒ Take out the tool container
B and take it near to the wheel to
be changed.
❒ Take the space-saver wheel C.

Years4321SERVICING AND CARE
148
5109876
SCHEDULED SERVICING PLAN39) 21)
Thousands of kilometres7515013512010590
PETROL/LPG VERSIONS
IMPORTANT: When you have carried out the last intervention in the table, continue with the scheduled servicing,
maintaining the frequency indicated in the plan by marking each operation with a dot or dedicated note.
Warning: simply restarting maintenance from the beginning of the plan may cause the allowed interval to be exceeded for
some operations!
60453015
Thousands of miles4590817263543627189





 
 
 
 Check tyre condition/wear and adjust pressure, if necessary;
check the condition/expiry date of the “Fix&Go Automatic” repair kit (for versions/markets, where provided)
Check operation of lighting system (headlights, direction indicators,
hazard warning lights, boot, passenger compartment,
glove compartment, instrument panel warning lights, etc.)
Check and, if necessary, top up fluid levels (1)
Check exhaust emissions/smokiness
Use the diagnosis socket to check supply/engine management
systems, emissions and engine oil decay
(for versions/markets, where provided)
Visually inspect the conditions of: bodywork, underbody protection,
pipes and tubes (exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check windscreen/rear window wiper blade
position/wear (for markets/versions, where provided)
Check operation of windscreen washer system and adjust jets
if necessary
Check cleanliness of bonnet and luggage compartment locks,
cleanliness and lubrication of linkage
(1) Topping up must be carried out with the fluids indicated in this Use and Maintenance Booklet and only after checking that the system is
undamaged

149
43215109876
Check soft top operation while closing and opening; check
of seals and lubrication of canvas sliding side guide
(convertible versions only)
Check handbrake lever travel and adjust, if necessary
Check and adjust clutch pedal travel (0.9 TwinAir 65 HP versions)
Check conditions and wear of front/rear disc brake pads
(for versions/markets, where provided) and operation
of pad wear indicator
Visually inspect condition and wear of the rear drum brake lining
Visually inspect condition of the accessory drive belt(s)
Inspect and if necessary adjust tensioning of accessory drive belt(s)
(for versions without automatic tensioner only)
Visually inspect conditions of toothed timing drive belt
(0.9 TwinAir versions excluded)
Check and adjust tappet clearance (1.2 8V engines)
Check and, if necessary, top up Dualogic gearbox
electro-hydraulic control oil level (2)
Visually inspect condition of: LPG pipes and connectors,
LPG tank fixing (LPG versions only)
Check fuel system operation and parameters using
the diagnosis socket (LPG versions only)
(2) Check to carry out every year for vehicles on the road in countries with particularly severe climates (cold countries)











Thousands of kilometres751501351201059060453015
Thousands of miles4590817263543627189
Years

151
43215109876
100200180160140120
DIESEL VERSIONS
IMPORTANT: When you have carried out the last intervention in the table, continue with the scheduled servicing, maintaining
the frequency indicated in the plan by marking each operation with a dot or dedicated note.
Warning: simply restarting maintenance from the beginning of the plan may cause the allowed interval to be exceeded for
some operations!
80604020
Check tyre condition/wear and adjust pressure, if necessary;
check the condition/expiry date of the “Fix&Go Automatic” repair kit
(for versions/markets, where provided)
Check operation of lighting system (headlights, direction indicators,
hazard warning lights, boot, passenger compartment,
glove compartment, instrument panel warning lights, etc.)
Check and, if necessary, top up fluid levels (1)
Check exhaust emissions/smokiness
Use the diagnosis socket to check supply/engine management
systems, emissions and engine oil decay (for versions/markets,
where provided)
Visually inspect the conditions of: bodywork, underbody protection,
pipes and tubes (exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check windscreen/rear window wiper blade position/wear
(for markets/versions, where provided)
Check operation of windscreen washer system and adjust jets
if necessary
Check cleanliness of bonnet and luggage compartment locks,
cleanliness and lubrication of linkage
(1) Topping up must be carried out with the fluids indicated in this Use and Maintenance Booklet and only after checking that the system is
undamaged




 
 
 

Thousands of kilometres
Thousands of miles6012010896847248362412
Years

153
43215109876
Replacing fuel filter (4)
Replace air cleaner cartridge (5)
Change the brake fluid
Replace passenger compartment cleaner (5)
(4) If the vehicle runs on fuel with quality below the relevant European specification, this filter must be replaced every 20,000 km.
(5) If the vehicle is used in dusty areas, this cleaner must be replaced every 20,000 km.
(6) The brake fluid replacement has to be done every year, irrespective of the mileage.
(
❍) Recommended operations
() Mandatory operations

(6)
❍❍❍❍❍
10020018016014012080604020Thousands of kilometres
Thousands of miles6012010896847248362412
Years

SERVICING AND CARE
154
REGULAR
INSPECTIONS
39) 22) 4)
Every 1,000 km or before long
journeys, check and, if necessary, top
up the following:
❒ engine coolant fluid level;
❒ brake fluid level;
❒ windscreen washer fluid level;
❒ tyre inflation pressure and condition;
❒ operation of lighting system
(headlights, direction indicators,
hazard warning lights, etc.);
❒ operation of the windscreen
wiper/washer system, position and
wear of the windscreen and rear
window wiper blades.
Every 3,000 km check and top up if
required: engine oil level.
You are advised to use PETRONAS
LUBRICANTS products, which have
been designed and produced
specifically for Fiat cars (see table
“Capacities” in the “Technical
specifications” section).
DEMANDING USE
OF THE CAR
If the vehicle is mainly used in one of
the following particularly harsh
conditions:
❒ trailer or caravan towing;
❒ dusty roads;
❒ short repeated distances (less than
7-8 km) and with external
temperatures below zero;
❒ engine often idling or driving long
distances at low speeds or long
periods of inactivity;
perform the following inspections more
frequently than shown on the
Scheduled Servicing Plan:
❒ check front disk brake pad
conditions and wear;
❒ Check cleanliness of bonnet and
luggage compartment locks,
cleanliness and lubrication of
linkage;❒ sight inspect the conditions of:
engine, gearbox, transmission,
pipes and hoses (exhaust -
fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.);
❒ check battery charge and battery
fluid level (electrolyte);
❒ visually check the various drive belt
conditions;
❒ check and, if necessary, change
engine oil and replace oil filter;
❒ check pollen filter and replace it, if
required;
❒ check air cleaner and replace it, if
required.

167
ENGINE
GENERAL0.9TwinAir 65 HP0.9TwinAir 85 HP0.9TwinAir 105 HP
Engine code 312A4000 312A2000 199B6000
Cycle Otto Otto Otto
Number and position of cylinders 2 straight 2 straight 2 straight
Piston diameter and stroke (mm) 83.5 x 88 80.5 x 86.0 80.5 x 86.0
Total capacity (cm3
) 964 875 875
Compression ratio 11.1 : 1 10 ± 02 : 1 10 ± 02 : 1
Maximum power (EEC) (kW) 48 62.5 77 (*) 72 (**)
Maximum power (EEC) (HP) 65 85 105 (*) 98 (**)
corresponding engine speed (rpm) 6250 5500 5500 (*) 5500 (**)
Maximum torque (EEC) (Nm) 88 145 145 (*) 120 (**)
Maximum torque (EEC) (kgm) 8.9 14.8 14.8 (*) 12.2 (**)
corresponding engine speed (rpm) 3500 1900 2000 (*) 1750 (**)
Spark plugs NGK LKR7DI-12 NGK LKR9EI-8 NGK ILKR9G8
Fuel
95 RON unleaded petrol
(EN228 specifications)95 RON unleaded petrol
(EN228 specifications)
(*) SPORT mode
(**) NORMAL mode