2018 CITROEN DS3 battery

3
07
08
0609
bit.ly/helpPSA
116 Driving recommendations
118
S
tarting-switching off the engine
120
P

arking brake
120
6

-speed manual gearbox
120
E

lectronic gearbox (ETG)
124
Aut

omatic gearbox
127
A

utomatic gearbox (EAT6)
130 Gear
ef ficiency indicator
131
H

ill start assist
132
St

op & Start
13 4 Tyre
under-inflation detection
136
Spe

ed limiter
138
C

ruise control
14 0
A

ctive City Brake
14 3
P

arking assistance
14 4
R

eversing camera 14 8 Fu
el tank
14 8
M

isfuel prevention (Diesel)
15 0
C

ompatibility of fuels
151
S

now chains
152


To w b a r
152
L

oad reduction mode
15 3
E

nergy economy mode
15 3
C

hanging wiper blades
15 3


Bonnet
15 4


Engines
155
Ch

ecking levels
157
C

hecks
15 9
Ad

Blue
® (BlueHDi engines)
162
A

dvice on care and maintenance
165
R

unning out of fuel (Diesel)
165
T

emporary puncture repair kit
169
S

pare wheel
174
C

hanging a

bulb
181
C

hanging a

fuse
188
1

2

V battery
191


To w i n g 194
C

haracteristics of engines and towed
loads
195
Pe
trol engines
198
D
iesel engines
199

Dimensions
201 Identification
ma
rkings
Driving
Practical information
In the event of a
breakdown Technical data
Alphabetical index Audio and telematics
Access to additional videos
7-inch touch screen tablet
Audio system
Contents

15
Engine oil
pressureFixed.
There is a fault with the engine oil
lubrication circuit. You must stop as soon as it is safe to do so.
Park, switch off the ignition and contact the dealer
network or a
qualified workshop.
Warning/indicator lamp
StateCause Action/Observations
Maximum
coolant
temperature Fixed.
The temperature of the cooling
system is too high. You must stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping
up the level, if necessary.
If the problem persists, contact the dealer network or
a


qualified workshop.
Battery charge Fixed. The battery charging circuit has
a
fault (dirty or loose terminals, slack
or cut alternator belt, etc.). The warning lamp should go off when the engine is
started.
If it does not go off, contact the dealer network or
a


qualified workshop.
Door(s) open
Fixed, if the speed is
below 6 mph (10 km/h).A door or the boot is still open. Close the door or boot.
Fixed and accompanied
by an audible signal
if the speed is above
6
mph (10 km/h).
Seat belt not
fastened/
unfastened Fixed, then flashing,
accompanied by an
increasing audible
signal. The driver or front passenger has
not fastened or has unfastened their
seat belt.
Pull the strap then insert the tongue into the buckle.
01
Instruments

16
Warning/indicator lampStateCause Action/Observations
Engine
diagnostic
system Flashing.
The engine management system has
a


fault.The catalytic converter may be destroyed.
Have it checked in the dealer network or by
a


qualified workshop.
Fixed. The emission control system has
a


fault.
The warning lamp should go off when the engine is started.
If it does not go off, contact the dealer network or a
qualified workshop without delay.
ServiceTemporarily on. A minor fault has occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in
the screen, such as, for example:
-

e
ngine oil level,
-

s
creenwash fluid level,
-
r

emote control battery,
-

p
article filter saturation on Diesel vehicles.
For any other faults, contact the dealer network or
a


qualified workshop.
Fixed. A major fault has occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in
the screen and then contact the dealer network or a
qualified workshop.
Anti-lock
Braking System
(ABS) Fixed.
The anti-lock braking system has
a


fault.The vehicle retains conventional braking.
Drive carefully at reduced speed and contact the
dealer network or a
qualified workshop without delay.
01
Instruments

27
Resetting the service indicator
After each service, the service indicator must
be reset to zero.
The procedure for resetting to zero is as
follows:
F
S
witch off the ignition.
F

P
ress and hold the trip distance recorder
reset button.
F

S
witch on the ignition; the distance recorder
display begins a


countdown.
F

W
hen the display indicates "=0", release the
button; the spanner disappears.
Following this step, if you wish to
disconnect the battery, lock the vehicle
and wait at least five minutes for the reset
to be taken into account.
Retrieving the service information
You can access the ser vice information at any
time.
F
P
ress the trip distance recorder reset
button. The ser vice information is displayed
for a
few seconds, then disappears.
Engine oil level indicator
Oil level correct
Low oil level
(Depending on version) The level read will only be correct if the
vehicle is on level ground and the engine
has been off for more than 30
minutes.
It is indicated by "OIL" flashing, accompanied
by the Ser vice warning lamp lighting up, an
audible signal and a

message.
If the low oil level is confirmed by a
check using
the dipstick, the level must be topped up to
avoid damage to the engine.
For more information on Checking levels ,
refer to the corresponding section.
On versions fitted with an electric oil level
indicator, the state of the engine oil level is
displayed in the instrument panel for a
few
seconds after switching the ignition on, after
the servicing information.
01
Instruments

44
With the remote control
F Press the closed padlock to lock the vehicle completely.
F

P

ress the closed padlock again within five
seconds to deadlock the vehicle.
With the key
F Turn the key to the rear in the driver's door lock to lock the vehicle completely.
F

T
urn the key to the rear again within five
seconds to deadlock the vehicle.
Deadlocking is confirmed by fixed illumination
of the direction indicators for approximately two
seconds.
Depending on your version, the door mirrors
fold at the same time.
Locating your vehicle
F Press the closed padlock to locate your locked vehicle in
a


car park.
This is indicated by lighting of the courtesy
lamps and flashing of the direction indicators
for a

few seconds.
Remote control problem
Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.
F

F
irst of all, use the key in the door lock to
unlock or lock your vehicle.
F

T
hen reinitialise the remote control.
If the problem persists, contact the dealer
network as soon as possible.
Reinitialisation
Battery type: CR1620/3 volts.
F

S

witch off the ignition.
F

T

urn the key to position 2


(Ignition) .
F

P

ress the closed padlock button for a

few
seconds.
F

S

witch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
Changing the battery
If the battery is discharged, you are
informed by lighting of this warning lamp in
the instrument panel, an audible signal and
a
message in the multifunction screen.
F Unfold the key.
F U nlock the chrome finisher by pressing
lug A .
F

K
eep lug A pressed in and remove the
chrome finisher by sliding it at 45°.
F

U
nclip the unit by inserting a coin into the
slot and per forming a
rotation movement.
02
Access

45
Lost keys
Go to a member of the dealer network, taking
with you the vehicle's registration certificate,
your personal identification documents and if
possible, the label bearing the key code.
The member of the dealer network will be able
to look up the key code and the transponder
code required to order a
new key.
Do not throw away the remote control
batteries, they contain metals which are
harmful to the environment.
Take them to an approved collection
point. Anti-theft protection
Do not make any modifications to the electronic
engine immobiliser system; this could cause
malfunctions.
Remote control
The high frequency remote control is a
sensitive
system; do not handle it while it is in your pocket
as there is a
possibility that it may unlock the
vehicle without you being aware of it.
Do not repeatedly press the buttons of your
remote control out of range and out of sight of
your vehicle. You may stop it from working and
the remote control would have to be reinitialised.
No remote control can operate when the key is
in the ignition switch, even when the ignition is
switched off, except for reinitialisation.
Locked vehicle
Driving with the doors locked could make it
difficult for the emergency services to enter the
vehicle in an emergency.
As a
safety precaution, never leave children
alone in the vehicle, except for a
very short
period.
In all cases, it is essential to remove the key
from the ignition switch when leaving the
vehicle. Second-hand vehicle
Have the pairing of all of the keys in your
possession checked in the dealer network, to
ensure that only your keys can be used to open
and start the vehicle.
F
S
lide the discharged battery out of its
location.
F

S

lide the new battery into its location,
observing the original direction of fit.
F

C

lip in the unit then the chrome finisher.
F

R

einitialise the remote control.
02
Access

46
Alarm
- Perimeter protection
The system manages the opening of the
vehicle.
The alarm is triggered if anyone tries to open
a door, the boot or the bonnet.
- Volumetric protection
(Except Cabrio versions)
The system manages any variation in the
volume of the passenger compartment.
The alarm is triggered if anyone breaks
a
window or moves inside the vehicle.
When leaving an animal in the vehicle or
a
window open, deactivate the volumetric
protection. This system protects and provides a deterrent
against theft and break-ins.
It provides the following types of monitoring: Do not make any modifications to the alarm
system; this could cause malfunctions.
Locking the vehicle with
complete alarm
Activation
F Switch off the ignition and get out of the
vehicle.
F

L
ock or deadlock the vehicle using the
locking button on the remote control.
The alarm activates; the indicator lamp in
button A flashes once per second.
The perimeter protection is activated 5
seconds
after pressing the locking button on the remote
control.
The volumetric protection is activated
45
seconds after pressing the locking button on
the remote control. If an opening – door, boot, etc. – is
incorrectly closed, the vehicle is not
locked but the perimeter protection will be
activated after 45


seconds.
Deactivation
F Unlock the vehicle using the unlock button
on the remote control.
The alarm is deactivated: the indicator lamp in
button A goes off.
Locking the vehicle with
exterior perimeter protection
only
Deactivating the volumetric
protection
F Switch off the ignition.
F W ithin ten seconds, press button A until the
indicator lamp is on continuously.
F

G
et out of the vehicle.
F

L
ock or deadlock the vehicle quickly using
the locking button on the remote control.
The exterior perimeter protection alone
remains active; the indicator lamp in button A
flashes once per second.
- Self-protection function
(Except Cabrio versions)
The system manages the deactivation status of
its components.
The alarm is triggered if the battery, central
control unit or the siren wiring is taken out of
service or damaged.
02
Access

50
Driving with the doors locked could make
it difficult for the emergency ser vices to
enter the vehicle in an emergency.
Automatic central locking
System to automatically and fully lock or unlock
the doors and the boot while driving.
You can activate or deactivate this function.
Locking
When the speed is above 6 mph (10 km/h), the
d oors and boot lock automatically.
If one of the doors is open, the automatic
central locking does not work.
If the boot is open, the automatic central
locking of the doors is active.
Unlocking
F Above 6 mph (10 km/h), press the button to
momentarily unlock the doors and boot.
Activation
Deactivation
F Press the button again for more than two seconds.
A confirmation message appears on the
screen, accompanied by an audible signal.
Back-up control
For mechanically locking and unlocking the
doors in the event of a fault with the central
locking system or a
battery failure.
In the event of a
fault with the central
locking system, it is essential to
disconnect the battery to lock the boot and
so ensure complete locking of the vehicle.
Locking the driver's door
F Insert the key in the lock and then turn it to the rear.
Unlocking the driver's door
F Insert the key in the lock and then turn it to the front.
Locking the passenger door
F Remove the black cap on the edge of the door, using the key.
F

I
nsert the key into the hole then turn it as far
as it will go.
F

R
emove the key and refit the cap.
F

P

ress this button for more than two
seconds.
A confirmation message appears on the
screen, accompanied by an audible signal.
02
Access