2018 BMW X6 Owners Manual

3.Fold open the holder.4.Slide wiper blade out of the wiper arm.5.Insert the new wiper blade and press it on
until it you hear it snap into the holder.6.Fold down the wipers.
Light/bulb
replacement
General
information
Lights
and
bulbs
Lights and bulbs make an essential contribuj
tion to vehicle safety.
The vehicle manufacturer recommends that
you have the relevant work carried out a dealj erss service center or another qualified servicecenter or repair shop.
A spare light box is available from a dealerss
service center or another qualified service cenj
ter or repair shop.
Observe the safety information, refer to
page 249.
Light-emitting
diodes
(LEDs)
Some items of equipment use light-emitting
diodes installed behind a cover as a light source. These light-emitting diodes, which arerelated to conventional lasers, are officially
designated as Class 1 light-emitting diodes.
Observe the safety information, refer topage 249.
Safety
information
Lights
and
bulbs WARNING
Bulbs can get hot during operation. Conj
tact with the bulbs can cause burns. There is a risk of injury. Only change bulbs after they
have cooled off.'

Light-emitting
diodes
(LEDs)WARNING
Too intensive brightness can irritate or
damage the retina of the eye. There is a risk of injury. Do not look directly into the headlights
or other light sources. Do not remove the LED
covers.'

Turn
signal
Safety
information
Observe the safety information, refer to
page 249.
Replacement
21-watt bulb, PY 21W.1.Opening the hood, refer to page 2382.Unscrew the lid counterclockwise and rej
move it carefully.
The bulb is attached to the lid.3.Turn the bulb clockwise to remove it.4.Insert the new bulb and attach the cover in the reverse order.
Turn
signal
in
exterior
mirror
The turn signals in the exterior mirrors feature
LED technology. In the case of a malfunction, contact a dealerss service center or another
qualified service center or repair shop.
Front
fog
lights/cornering
lights
Safety
information
Observe the safety information, refer to
page 249.
Replacement
55-watt bulb, H11.1.Insert the screwdriver from the onboard vehicle tool kit, with the flat side on the clip,
arrow 1.2.Turn the screwdriver by 90p, arrow 2.3.Remove the front fog lamp toward the front.4.Detach the connector.5.Turn the bulb bracket and remove it.6.Remove the bulb and replace it.7.Proceed in reverse order to insert the frontfog lamp. Note the guide rails in doing so.Seite 251Replacing
componentsMobility251
Online Edition for Part no. 01402981185 - VI/17

LED
front
fog
lights
These front fog lights are made using LED
technology. In the case of a malfunction, conj
tact a dealerss service center or another qualij fied service center or repair shop.
Tail
lights,
bulb
replacement
LED
tail
lights
These tail lights are made using LED technolj
ogy. In the case of a malfunction, contact a
dealerss service center or another qualified
service center or repair shop.
Vehicle
battery
Maintenance
The battery is maintenance-free.
The added amount of acid is sufficient for the
service life of the battery.
More information about the battery can be rej quested from a dealerss service center or anjother qualified service center or repair shop.
Replacing
the
vehicle
battery
General
information The manufacturer of your vehicle recommends
that you have a dealerss service center or anj other qualified service center or repair shopregister the vehicle battery to the vehicle afterthe battery has been replaced. Once the batjtery has been registered again, all comfort feajtures will be available without restriction andany Check Control messages displayed which
relate to comfort features will disappear.
Safety
information NOTE
Vehicle batteries that are not compatible
can damage vehicle systems and impair vehij cle functions. There is a risk of personal and
property damage. Only vehicle batteries thatare compatible with your vehicle type should
be installed in your vehicle. Information on
compatible vehicle batteries is available at your
dealerss service center.'

'yTime: update.'yDate: update.'yGlass sunroof: initialize the system.
Disposing
of
old
batteriesHave old batteries disposed of by adealerss service center or another
qualified service center or repair shop
or take them to a collection point.
Maintain the battery in an upright position for transport and storage. Secure the battery so
that it does not tip over during transport.
Fuses Safety
information WARNING
Incorrect and repaired fuses can overload
electrical lines and components. There is a risk of fire. Never attempt to repair a blown fuse.Do not replace a nonworking fuse with a subjstitute of another color or amperage rating.'

Breakdown
assistanceVehicle
features
and
options
This chapter describes all standard, country- specific and optional features offered with theseries. It also describes features that are notnecessarily available in your vehicle, e. g., due
to the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and systems, the applicable laws and regulations
must be observed.
Hazard
warning
flashers
The button is located in the center console.
The red light in the button flashes when the
hazard warning flashers are activated.
Intelligent
emergency
call
Concept
In case of an emergency, an Emergency Rej
quest can be made through the system.
General
information Only press the SOS button in an emergency.
For technical reasons, the Emergency Request cannot be guaranteed under unfavorable conj
ditions.
Overview
SOS button in the roofliner
Functional
requirements
'yThe SIM card integrated in the vehicle hasbeen activated.'yThe radio-ready state is switched on.'yThe Assist system is functional.
Initiating
an
Emergency
Request
automatically
Under certain conditions, for instance if the airj bags trigger, an Emergency Request is autoj
matically initiated immediately after an accij
dent of corresponding severity. Automatic
Collision Notification is not affected by pressj
ing the SOS button.
Initiating
an
Emergency
Request
manually
1.Press the cover briefly to open it.2.Press the SOS button until the LED at the button lights up green.'yThe LED is illuminated green when an
Emergency Request has been initiated.
If a cancel prompt appears on the Control
Display, the Emergency Request can be
aborted.Seite 254MobilityBreakdown
assistance254
Online Edition for Part no. 01402981185 - VI/17

If the situation allows, wait in your vehicle
until the voice connection has been estabj
lished.'yThe LED flashes green when a connection to the BMW Response Center has been
established.
The BMW Response Center then makes contact with you and takes further steps to
help you.
Even if you are unable to respond, the
BMW Response Center can take further
steps to help you under certain circumj
stances.
For this, data is transmitted to the BMW
Response Center which serves to deterj
mine the necessary rescue measures. E.g., the current position of the vehicle, if it canbe established.
Even if you can no longer hear the BMW Response Center through the loudspeakj
ers, the BMW Response Center may still
be able to hear you.
The BMW Response Center ends the Emerj
gency Request.
Roadside
Assistance
Service
availability
Roadside Assistance can be reached around
the clock in many countries. You can obtain asj sistance there in the event of a vehicle breakjdown.
Roadside
Assistance
The Roadside Assistance phone number can
be viewed via iDrive or a connection to Roadj
side Assistance can be established directly.
Warning
triangle1.Open the cover on the left side trim.2.Lift the warning triangle slightly and rej
move in the direction of the car's interior.
First-aid
kit
General
information
Some of the articles have a limited service life.
Check the expiration dates of the contentsregularly and replace any expired items
promptly.
Seite 255Breakdown
assistanceMobility255
Online Edition for Part no. 01402981185 - VI/17

Storage
The first-aid kit is located behind the left-hand
cover in the cargo area.
To open, pull on the handle.
Jump-starting
General
information
If the battery is discharged, the engine can be
started using the battery of another vehicle and two jumper cables. Only use jumper caj
bles with fully insulated clamp handles.
Safety
information DANGER
Contact with live components can lead to
an electric shock. There is a risk of injuries or danger to life. Do not touch any componentsthat are under voltage.'