2017 Peugeot 308 Owner's Manual

79
308_en_Chap03_ergonomie-et-confort_ed01-2016
Rear seats (hatchback)
F Move the corresponding front seat for ward if necessary.
F

C
heck that the corresponding outer seat
belt is positioned correctly against the
backrest and buckle it.
F

P
lace the head restraints in the low
position. F
Straighten the seat backrest 2 and secure it.F Check that the red indicator, located next to
the control 1 , is no longer visible.
F
u
n
buckle and reposition the outer seat belt
on the side of the backrest.
When folding the seat, the centre seat
belt should not be fastened, but laid out
flat on the seat
F

P

ress control 1 to release the seat
backrest
2
.
F
F
old the seat backrest 2 on to the
cushion


3 .
Folding the backrestRepositioning the seat backrest
Rear seats with fixed one-piece cushion and 1/3 - 2/3 split backrests which can be folded individually to adapt the load space in the boot.
th

e rear seat cushion does not fold,
just the seat backrest can be folded to
increase the boot loading space. When repositioning the seat backrest,
take care not to trap the seat belts.
3
ease of use and comfort

80
308_en_Chap03_ergonomie-et-confort_ed01-2016
Rear seats (SW)
1/3 - 2/3 split rear seats which can be folded to vary the boot load space.
ea
ch section of the seat (1/3 or 2/3) has its own control to release the seat backrest from inside the
boot.
Folding the seat from the boot
F Check that nothing is preventing the seat backrest from folding (seat belts, ...) and
that no object might inter fere with the seat
manoeuvre (above as well as below).
F

P
lace the head restraints in the low
position. F
P ull the control from inside the boot, the
seat backrest folds onto the cushion.
Folding the seat from
the rear
F Check that nothing is preventing the seat backrest folding and that no object might
interfere with the seat manoeuvre
(above as well as below).
F

M
ove the corresponding front seat
forwards if necessary.
F

C
heck that the seat belt is positioned
correctly on the side of the seat backrest.
F

P
lace the head restraints in the low
position.
ease of use and comfort

81
308_en_Chap03_ergonomie-et-confort_ed01-2016
these have one position for use (up) and
a stowed position (down).
th

ey can be removed and are interchangeable.
Outer rear seat head restraints
Never drive with the head restraints
removed; they must be in place and
correctly adjusted.
to r

emove a head restraint:
F

p

ull the head restraint upwards to the stop,
F

t

hen, press the lug A
.
th
e centre head restraint is not
adjustable.
F

P

ull the control 1 for wards, the seat
backrest folds onto the cushion.
Returning the seat back to its original position
F Put the seat backrest in the upright position and secure it.
F

C
heck that the red indicator, located at the
control 1 , is no longer visible.
F

R
efit the head restraints or put them back
in place.
When returning the rear seat back to
its original position, take care not to
trap the seat belts and ensure that their
buckles are positioned correctly.
3
ease of use and comfort

82
308_en_Chap03_ergonomie-et-confort_ed01-2016
Interior fittings
1. Cooled glove box fitted with a ventilation nozzle
2.
1

2 V accessory socket (120 W)


O
bserve the maximum power rating to
avoid damaging your accessory.
3.


u
S
B port
4.
J

ack auxiliary socket
5.
C

up holder (depending on version)
6.
St

orage (depending on version)
7.
St

orage - Retractable cup holder


t
u
rn the carrier for access to the cup
h o l d e r.
8.
Fr

ont armrest
9.
2

30 V (120 W) accessory socket
O

bserve the power rating to avoid
damaging your accessory.
ease of use and comfort

83
308_en_Chap03_ergonomie-et-confort_ed01-2016
Mats
When fitting the mat for the first time, on the
driver's side use only the fixings provided in the
wallet attached.
th
e other mats are simply placed on the
carpet.
Fitting Removal
Refitting
to avoid any risk of jamming of the
pedals:
-

o
nly use mats which are suited to
the fixings already present in the
vehicle; these fixings must be used,
-

n
ever fit one mat on top of another.
th

e use of mats not approved by
P
e

uge
Ot
may inter fere with access to
the pedals and hinder the operation of
the cruise control / speed limiter.
th

e mats approved by P
e
uge
Ot
have
two fixings located below the seat.
to r

emove the mat on the driver's side:
F

m

ove the seat as far back as possible,
F

un
clip the fixings,
F

r

emove the mat.
to r

efit the mat on the driver's side:
F

p

osition the mat correctly,
F

r

efit the fixings by pressing,
F

c

heck that the mat is secured correctly.
3
ease of use and comfort

84
308_en_Chap03_ergonomie-et-confort_ed01-2016
F to connect a 12 V accessory (maximum power: 120 Watts), lift the cover and
connect a suitable adaptor.
12 V accessory
socket
Front armrest
the height and longitudinal position of the armrest cover can be adjusted for greater comfort.
F

R
aise the cover to the required position
(low, intermediate or high).
F

I
f you raise the cover slightly beyond the
high position, guide it when lowering it to
the low position.
F

Ra
ise the lever.
F

Ra
ise the cover fully.
F

S
lide the cover fully for wards or rear wards.
Storage Longitudinal adjustment
Height adjustment
Observe the maximum power rating to
avoid damaging your accessory.
th

e connection of an electrical device
not approved by P
e

uge
Ot, s
uch as a
uS

B charger, may adversely affect the
operation of vehicle electrical systems,
causing faults such as poor telephone
reception or inter ference with displays
in the screens.
ease of use and comfort

85
308_en_Chap03_ergonomie-et-confort_ed01-2016
It permits the connection of a portable device
so that you can listen to your music files via the
vehicle's speakers.
th
e management of the files is done using your
portable device.
It allows the connection of a portable device,
such as a digital audio player of the iPod® type
or a
uS
B memory stick.
It reads the audio files which are transmitted to
your audio system and played via the vehicle's
speakers.
You can manage these files using the steering
mounted controls or the audio system.
Jack auxiliary socketuSB p
ort
For more information on the use of
this equipment, refer to the Audio and
telematics section.
When a
u
S

B port is used, the portable
device charges automatically.
While charging, a message is displayed
if the current consumption of the
portable device exceeds the power
rating of the port.
For more information on using this
equipment, refer to the Audio and
telematics section.
230 V / 50 Hz power socket
F Open the central storage box,
F
C heck that the warning lamp is on green,
F

C
onnect your multimedia or other electrical
device (telephone charger, laptop
computer, CD-DVD player, baby food
warmer...).
In the event of a fault with the socket, the green
warning lamp flashes.
Have it checked by a P
e

uge
Ot
dealer or a
qualified workshop. A 230 V / 50 Hz socket (maximum power:
120 W) is fitted in the rear storage box.
th

is socket works with the engine running, as
well as in S
tO
P mode with Stop & Start.
3
ease of use and comfort

86
308_en_Chap03_ergonomie-et-confort_ed01-2016
Ski flap
F Lower the armrest.
F P ress the flap opening control.
F

L
ower the flap.
F

L
oad the objects from inside the boot.
F

L

ower the rear armrest for a more
comfortable position.
It may be fitted with cup holders and also gives
access to the ski flap.
Rear armrest
Connect only one device at a time to
the socket (no extension or multi-way
connector).
Connect only devices with class II
insulation (shown on the device).
Do not use a device with a metal case.
As a safety measure, when electrical
consumption is high and when required
by the vehicle's electrical system
(particular weather conditions, electrical
overload...), the current supply to the
socket will be cut off; the green warning
lamp goes off.
th

e different "ports and sockets" can
be either not available, an option or
standard, depending on the trim level of
the vehicle.
Do not leave the flap open when not
carrying long objects in the vehicle.
It allows long objects to be carried in the
vehicle.
ease of use and comfort