2017 Peugeot 301 Owner's Manual

63
Storage box
F Raise the boot floor to access the storage box.
This has areas for the storage of a box of spare
bulbs, a first aid kit, two warning triangles...
It also houses the vehicle tools, the temporary
puncture repair kit...
Mats
Removable carpet protection.
Fitting
When fitting the mat for the first time, on the
driver's side use only the fixings provided in the
wallet attached.
The other mats are simply placed on the
carpet.
Removing
To remove the mat on the driver's side:
F M ove the seat as far back as possible.
F

U
nclip the fixings.
F

R
emove the mat.
Fitting
To refit the mat on the driver's side:
F P osition the mat correctly.
To avoid any risk of jamming the pedals:
-

O
nly use mats which are suited to the
fixings already present in the vehicle;
these fixings must be used.
-

D
o not fit one mat on top of another.
The use of mats not approved by
PEUGEOT may inter fere with access to
the pedals and hinder the operation of the
cruise control / speed limiter.
F

R
efit the fixings by pressing.
F

C
heck that the mat is secured correctly.
3
Ease of use and comfort

64
Lighting control
In some climate conditions (low
temperature, humidity), the presence
of mist on the internal sur face of the
headlamp and rear lamp glass is normal;
this disappears a few minutes after the
lights are switched on.
Selection ring for main lighting
mode
Lighting off (ignition off) / Daytime
running lights (engine running).
Turn the ring to align the desired symbol with
the marking.
Side lights only.
Dipped or main beam headlights.
Dipping the headlights
Pull the lever to switch the lighting
between dipped and main beam
headlights.
Display
Illumination of the corresponding indicator
light in the instrument panel confirms that the
lighting selected is on.
Fog light selection ring
The fog lights operate with the dipped and main
beam headlights.
Rear fog light only
F To switch it on, turn the ring for wards.
F T o switch it off, turn the ring backwards.
In the lighting off and side lights modes, the
driver can switch on the main beam headlights
temporarily ("headlight flash") by keeping the
lever pulled.
Lighting and visibility

65
Front fog lights and rear fog light
Press the ring by rotating it:
F A 1st time for ward to switch the front fog
lights on.
F

A 2nd time for ward to switch the rear fog
light on.
F

1
st time backward to switch the rear fog
light of f.
F

2
nd time backward to switch the front fog
lights of f. The fog lights and side lights remain on if the
dipped beams are switched off manually.
F

T
urn the ring towards the rear to switch
off the fog lights, the side lights will then
switch off.
In good or rainy weather, both day and
night, using the front fog lights and the
rear fog light is prohibited. In these
situations, the power of their beams may
dazzle other drivers. They should only be
used in fog or falling snow.
In these weather conditions, it is your
responsibility to switch on the fog lights
and dipped headlights manually as the
sunshine sensor may detect sufficient
light.
Do not forget to turn of the front fog lights
and the rear fog light as soon as they are
no longer necessary. Switching off the lights when the
ignition is switched off
On switching off the ignition, all of the
lights turn off immediately, except for
dipped beam if automatic guide-me-home
lighting is activated.
Switching on the lighting when
switching off the ignition
To reactivate the lighting control, rotate
the ring to the "0" position - lights off, then
to the desired position.
When the driver's door is opened, a
temporary audible signal warns you that
the vehicle's lighting is on.
The lighting, with the exception of the
side lights, switch off automatically after
a maximum duration of thirty minutes to
prevent discharging of the battery.
4
Lighting and visibility

66
Daytime lights
(Depending on the country of sale.)
When starting the vehicle, the daytime running
lights come on automatically, if the lighting
control is in the "0" position.The daytime running lights go off
if the side lights and dipped beam
headlights are switched on.
This function cannot be deactivated.
Switching on
F With the ignition off, "flash" the headlamps using the lighting stalk.
F

A f
urther "headlamp flash" switches the
function off.
Manual follow-me lighting goes off
automatically at the end of a given period of
time.
Manual guide-me-home
lighting
The temporary illumination of the dipped beam
headlamps after the vehicle's ignition has been
switched off makes the driver's exit easier
when the light is poor.
Lighting and visibility

67
Headlight beam height adjustment
To avoid causing a nuisance to other road
users, the height of the headlight beams should
be adjusted according to the load in the vehicle.
Depending on the version, this adjustment can
be carried out using the control located:
-
U
nder the bonnet.
-

T
o the left of the steering wheel
Bonnet
F Raise the bonnet to access the control (one per headlight).
F

T
urn the control to adjust the height of the
headlight beam.
To the left of the steering wheel
0 1 or 2 people in the front seats.
- 5 people.
1 5 people + maximum authorised load in
the boot.
- Driver on his own + maximum authorised
load in the boot.
The higher number positions can be used, but
may limit the area illuminated by the headlights.
The initial setting is position "0". Travelling abroad
The design of the dipped beam headlights
allows, without modification, driving in a
country that drives on the other side of the
road to the country in which your vehicle
was sold.
4
Lighting and visibility

68
Front windscreen wipers
Fast wiping (heavy rain).
Normal wiping (moderate rain).
Intermittent wiping (proportional to
the speed of the vehicle).
Stop.
Raise or lower the control to the desired
position to change the wiping speed.
Single wipe (press down and
release).
Front windscreen wash
Pull the wiper control lever towards you. The
windscreen washer and then the wiper operate
for a fixed time.The screenwash jets are not adjustable.
Do not try to move them (risk of damage).
Special position of the
windscreen wipers
This position permits release of the windscreen
wiper blades.
It is used for cleaning or replacement of the
wiper blades. It can also be useful, in winter, to
release the wiper blades from the windscreen.
F

I
n the minute following ignition switch-off,
any operation of the wiper control stalk will
position the wiper blades vertically.
F

T
o park the wiper blades again, switch on
the ignition and operate the wiper stalk.
To maintain the effectiveness of the wiper
blades, it is advisable to:
-

h

andle them with care,
-

c

lean them regularly using soapy
water,
-

a

void using them to retain cardboard
on the windscreen,
-

r

eplace them at the first signs of wear.
Wiper control stalk
Lighting and visibility

69
Courtesy lights
ACourtesy lights
B Map reading lights
Front and rear courtesy lights
In permanent lighting mode, the
lighting time varies according to the
circumstances:
-

W
hen the ignition is off, approximately
ten minutes.
-

I
n energy saving mode,
approximately thirty seconds.
-

W
hen the engine is running, no limit.
Front map reading lights
F With the ignition on, press the corresponding switch.
In this position, the courtesy light
comes on gradually:
-
W

hen unlocking the vehicle.
-

W

hen the key is removed from the ignition
switch.
-
W

hen opening a door.
-

W

hen actuating the locking button on
the remote control in order to locate your
vehicle.
It switches off gradually:
-
W

hen locking the vehicle.
-

W

hen the ignition is switched on.
-

3

0 seconds after the last door is closed. Permanently off.
Permanent lighting.
4
Lighting and visibility

70
General safety recommendations
Labels are attached in different places of
your vehicle. They include safety warnings
as well as identification information of your
vehicle. Do not remove them: they are an
integral part of your vehicle.
For any work on your vehicle, use a
qualified workshop that has the technical
information, skills and equipment required,
all of which a PEUGEOT dealer is able to
provide. We draw your attention to the following
points:
-

T
he fitting of electrical equipment or
accessories not listed by PEUGEOT
may cause excessive current
consumption and faults and failures
with the electrical system of your
vehicle. Contact a PEUGEOT dealer
for information on the range of
recommended accessories.
-

A
s a safety measure, access to
the diagnostic socket, used for the
vehicle's electronic systems, is
reserved strictly for PEUGEOT dealers
or qualified workshops equipped
with the special tools required (risk
of malfunctions of the vehicle's
electronic systems that could cause
breakdowns or serious accidents).
The manufacturer cannot be held
responsible if this advice is not
followed.
-

A
ny modification or adaptation not
intended or authorised by PEUGEOT
or carried out without meeting the
technical requirements defined
by the manufacturer will result in
the suspension of the legal and
contractual warranties. Installation of accessory radio
communication transmitters
Before installing a radio communication
transmitter, you must contact a PEUGEOT

dealer for the specification of transmitters
which can be fitted (frequency, maximum
power, aerial position, specific installation
requirements), in line with the Vehicle
Electromagnetic Compatibility Directive
(2004/104/EC).
Depending on country regulations, some
safety equipment may be compulsory:
high visibility safety vests, warning
triangles, breathalysers, spare bulbs,
spare fuses, fire extinguisher, first aid kit,
mud flaps at the rear of the vehicle, etc.
Safety