2017 MITSUBISHI L200 lock

Quick guideE08500500010Locking and unlocking the
doors
E08500601454
Keyless entry system*
Press the key switch, and all doors will be
locked or unlocked as desired.
It is also possible to operate the outside rear-
view mirrors. (Vehicles equipped with the mirror retractor switch)
The key switch will operate within approxi-
mately 4 m from the vehicle.
1. LOCK switch
2. UNLOCK switch
3. Indication lamp
Refer to “Keyless entry system*” on page
3-03.
For vehicles equipped with the mirror retrac- tor switch, the outside rear-view mirrors can
be folded and extended automatically if you press the LOCK switch (1) or UNLOCK
switch (2).
Refer to “Operation of the outside rear- view mirrors” on page 3-04.
Keyless operation system*
When you are carrying the keyless operation
key and within the operating range, if you
press the driver’s or front passenger’s door switch (A), the doors are locked/unlocked.The operating range is approximately 70 cm from the driver’s or front passenger’s door
lock/unlock switch.
Refer to “Keyless operation system*” on page 3-07.
Around the driver’s seat
E08500801531
Quick guide
1-15OKTE17E1Overview/Quick guide1Keyless entry key Keyless operation key

Type 2
OFF All lamps off
AUTO With the ignition switch or the
operation mode is in
ON, head-
lamps, position, tail, licence plate and instrument panellamps turn on and off automati-
cally in accordance with outside
light level. All lamps turn off automatically when the ignition
switch is turned to “OFF” posi-
tion or the operation mode is put in OFF. Position, tail, licence plate and
instrument panel lamps on Headlamps and other lamps go
on Refer to “Combination headlamps and
dipper switch” on page 5-17. 3-Turn-signal lever The turn-signal lamps flash when the lever is
operated. 1. Turn-signals
2.
Lane-change signals
Refer to
“Turn-signal
lever” on page
5-20.
4-Steering wheel height and
reach adjustment 1. Release the lever while holding the
steering wheel up.
2. Adjust the

steering wheel to the desired
position. 3. Securely lock the steering wheel by pull-
ing the lever fully upward. A- Locked
B- Release *: Vehicles equipped with the reach adjustment Quick guide
1-17
OKTE17E1 Overview/Quick guide 1
* *

Refer to “Steering wheel height and reach
adjustment” on page 6-07.
5-Wiper and washer switch Except for vehicles equipped with rain
sensor MIST- Misting function
The wipers will operate
once.
OFF- Off INT- Intermittent (Speed sensi- tive)
LO- Slow HI- Fast Vehicles with rain sensor
MIST- Misting function
The
wipers will operate
once.
OFF- Off
AUTO- Auto-wiper control Rain sensor
The

wipers will automati-
cally operate depending on
the degree of wetness on
the windscreen.
LO- Slow HI- Fast
The
washer fluid will be sprayed onto the
windscreen by pulling the lever towards you.
Refer to “Wiper and washer switch” on page 5-23. 6-Electric window control* Press the switch down for opening the win-
dow, and pull the switch for closing. 1. Driver’s door window
2.

Front passenger’s door window
3. Rear left door window (Double cab)
4. Rear right door window (Double cab)
5. Lock switch
Lock switch
If you press the switch (5), the passenger’s switches cannot be operated. To cancel, press
it once again.
Refer to “Electric window control*” on
page 3-21.
Quick guide
1-18
OKTE17E1
Overview/Quick guide 1 Driver’s switch
L
HD Driver’s switch
RHD

7-Fuel tank filler door release
lever*
Open the fuel tank filler door.
The fuel tank filler is located on the rear left side of your vehicle.
Refer to “Filling the fuel tank” on page 2-02.
Automatic transmission Sports
Mode 5A/T
E08501001325
Selector lever operation
The transmission selects an optimum gear ra- tio automatically, depending on the speed of the vehicle and the position of the acceleratorpedal.
While depressing the brake ped-
al, move the selector lever through the gate.Move the selector lever through
the gate.
Selector lever positions
“P” PARK
This position locks the transmission to pre-
vent the vehicle from moving. The engine
can be started in this position.
“R” REVERSE
This position is to back up.
“N” NEUTRAL
At this position the transmission is disengag- ed.
“D” DRIVE
This position is for normal driving.

Refer to “Automatic transmission Sports Mode 5A/T” on page 6-28.
Multi information display
E08501201226
Always stop the vehicle in a safe place before
operating.
Quick guide
1-19OKTE17E1Overview/Quick guide1Type 1 Type 2 LHD RHD

WARNINGlKeep the doors and windows closed while
refueling the vehicle. If they were open,fuel vapour could get into the cabin.
l If the fuel cap must be replaced, use only
a MITSUBISHI MOTORS genuine part.
Fuel tank capacity
75 litres
Refueling
1. Before filling with fuel, stop the engine.
2. The fuel tank filler is located on the rear
left side of your vehicle.
Open the fuel tank filler door with the
release lever located below the instru- ment panel. (Only vehicles for Type 1,
2)
3. [Vehicles for Type 1, 2] Open the fuel tank filler tube by slowly
turning the fuel cap anticlockwise.1- Remove
2- Close

[Vehicles for Type 3]
Open the cover (1). Insert the key in the
fuel cap (2) and unlock it.
Turn the fuel cap and remove it.
Filling the fuel tank
2-03OKTE17E1General information2 Type 1 Type 2 Type 1 Type 2 Type 3

CAUTIONlSince the fuel system may be under pressure,
remove the fuel cap slowly. This relieves any pressure or vacuum that might have
built up in the fuel tank. If you hear a hissing sound, wait until it stops before removing the fuel cap. Otherwise, fuel may spray out,
injuring you or others.NOTEl While filling with fuel, hang the fuel cap on
the hook (A) located on the inside of the fuel
tank filler door.4. Insert the gun in the tank port as far as it
goes.CAUTIONl Do not tilt the gun.
5.
When the gun stops automatically, do
not fill with fuel any more.

6. [Vehicles for Type 1, 2] To close, turn the fuel cap slowly clock-
wise until you hear clicking sounds, then
gently push the fuel tank filler door
closed.
[Vehicles for Type 3]
To close, turn the fuel cap slowly clock-
wise until you hear clicking sounds, then turn the key clockwise to lock the fuelcap.
Entering or leaving the
vehicle E00205800022CAUTIONlTo avoid slipping and damaging the painted
surface, do not step on the cover of the side
step (A).Installation of accessories
E00200302303
We recommend you to consult yourMITSUBISHI MOTORS Authorized Service
Point.
Entering or leaving the vehicle
2-04OKTE17E1General information2 Type 1 Type 2

Keys.................................................................................................... 3-02Key number tag................................................................................... 3-02
Electronic immobilizer (Anti-theft starting system)........................... 3-03
Keyless entry system*.........................................................................3-03
Keyless operation system*.................................................................. 3-07
Doors................................................................................................... 3-15
Central door locks............................................................................... 3-17
Dead Lock System*............................................................................ 3-18
“Child-protection” rear doors (Double cab)........................................3-20
Rear gate............................................................................................. 3-20
Manual window control*.................................................................... 3-21
Electric window control*.................................................................... 3-21Locking and unlocking
OKTE17E13

KeysE00300104045
1. Master key
2. Keyless entry key
3. Keyless operation key
4. Emergency key
WARNINGl When taking a key on flights, do not press
any switches on the key while on the plane. If a switch is pressed on the plane,the key emits electromagnetic waves,which could adversely affect the plane’s
flight operation.
When carrying a key in a bag, be careful that no switches on the key can be easily
pressed by mistake.NOTEl The key is a precision electronic device with
a built-in signal transmitter. Please observe
the following in order to prevent a malfunc- tion.
• Do not leave in a place that is exposed to
direct sunlight, for example on the dash- board.
• Do not disassemble or modify.
• Do not excessively bend the key or sub-
ject it to strong impacts.
• Do not expose to water.
• Keep away from magnetic key rings.
• Keep away from audio systems, personal
computers, TVs, and other equipment that generates a magnetic field.
• Keep away from devices that emit strong
electromagnetic waves, such as cellular phones, wireless devices and high fre-
quency equipment (including medical de- vices).NOTE• Do not clean with ultrasonic cleaners or
similar equipment.
• Do not leave the key where it may be ex-
posed to high temperature or high humidi-
ty.
l The engine is designed so that it will not
start if the ID code registered in the immo-
bilizer computer and the key’s ID code do
not match. Refer to the “Electronic immobil- izer” section for details and key usage.Key number tag
E00312701092
The key number is stamped on the tag as in-
dicated in the illustration.
Make a record of the key number and store the key and key number tag in separate pla-ces, so that you can order a key from yourMITSUBISHI MOTORS Authorized Service
Point in the event the original keys are lost.
Keys
3-02OKTE17E1Locking and unlocking3Key Keyless operation keyKeyless entry key