2017 MAZDA MODEL CX-5 ignition

4–58
When Driving
Switches and Controls
Lane-Change Signals
Move the lever halfway toward the
direction of the lane change—until the
indicator fl ashes— and hold it there. It will
return to the off position when released.
Three-Flash Turn Signal
After releasing the turn signal lever, the
turn signal indicator fl ashes three times.
The operation can be cancelled by moving
the lever in the direction opposite to which
it was operated.
NOTE
The three-fl ash turn signal function can be
switched to operable/inoperable using the
personalization function.
Refer to Personalization Features on page
9-11 .

Windshield Wipers and
Washer
The ignition must be switched ON to use
the wipers.
WARNING
Use only windshield washer fl uid or
plain water in the reservoir: Using radiator antifreeze as washer
fl uid is dangerous. If sprayed on the
windshield, it will dirty the windshield,
aff ect your visibility, and could result in
an accident.

Only use windshield washer fl uid mixed
with anti-freeze protection in freezing
weather conditions: Using windshield washer fl uid without
anti-freeze protection in freezing
weather conditions is dangerous as
it could freeze on the windshield and
block your vision which could cause
an accident. In addition, make sure
the windshield is suffi ciently warmed
using the defroster before spraying the
washer fl uid.

CX-5_8FN1-EA-16L_Edition1.indb 582016/12/12 10:05:56

4–60
When Driving
Switches and Controls
Auto-wiper control
When the wiper lever is in the

position, the rain sensor senses the amount
of rainfall on the windshield and turns the
wipers on or off automatically (off—
intermittent—low speed—high speed).

The sensitivity of the rain sensor can be
adjusted by turning the switch on the
wiper lever.
From the center position (normal), rotate
the switch upward for higher sensitivity
(faster response) or rotate it downward for
less sensitivity (slower response).


Higher sensitivity
Less sensitivitySwitch
Center
position

CAUTION
 Do not shade the rain sensor by adhering a sticker or a label on the
windshield. Otherwise the rain sensor
will not operate correctly.

 When the wiper lever is in the
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
 If the windshield above the rain sensor is touched or wiped with a
cloth.
 If the windshield is struck with a hand or other object from either outside or
inside the vehicle.
 Keep hands and scrapers clear of the windshield when the wiper lever is in the

position and the ignition is
switched ON as fi ngers could be pinched
or the wipers and wiper blades damaged
when the wipers activate automatically.
 If you are going to clean the windshield, be sure the wipers are turned off
completely (when it is most likely
that the engine is left running) this is
particularly important when clearing ice
and snow.

CX-5_8FN1-EA-16L_Edition1.indb 602016/12/12 10:05:57

4–62
When Driving
Switches and Controls
Rear Window Wiper and
Washer
The ignition must be switched ON to use
the wiper.
Rear Window Wiper

Turn the wiper on by turning the rear
wiper/washer switch.

Switch
Position Wiper operation

Stop

Intermittent

Normal

Rear Window Washer
To spray washer
fl uid, turn the rear wiper/
washer switch to either of the
position.
After the switch is released, the washer
will stop.
If the washer does not work, inspect the
fl uid level (page 6-27 ). If the fl uid
level is normal and the washer still does
not work, consult an Authorized Mazda
Dealer.
Rear Window Defogger
The rear window defogger clears fog from
the rear window.

The ignition must be switched ON to use
the defogger.

Press the switch to turn on the rear
window defogger. The rear window
defogger operates for about 15 minutes
and then turns off automatically.
The indicator light illuminates when the
defogger is operating.

To turn off the rear window defogger
before the 15 minutes has elapsed, press
the switch again.
Manual Climate Control

Indicator light

Fully Automatic Climate Control

Indicator light

CX-5_8FN1-EA-16L_Edition1.indb 622016/12/12 10:05:57

4–63
When Driving
Switches and Controls
CAUTION
Do not use sharp instruments or
window cleaners with abrasives to
clean the inside of the rear window
surface. They may damage the
defogger grid inside the window.

NOTE
  This defogger is not designed
for melting snow. If there is an
accumulation of snow on the rear
window, remove it before using the
defogger.
  The rear window defogger setting
can be changed. After changing the
setting, the rear window defogger
stops automatically after 15 minutes
have elapsed and when the ambient
temperature is high. When the ambient
temperature is low, it continues to
operate until the switch is pressed
again.
 Refer to Personalization Features on page 9-11 .

Windshield Wiper De-icer
The thermal fi laments at the following
positions heat up and facilitate the removal
of snow accumulated on the windshield.


The windshield wiper de-icer operates
in conjunction with the rear window
defogger.
To turn on the windshield wiper de-icer,
switch the ignition ON and press the rear
window defogger switch (page 4-62 ).
Manual Climate Control

Indicator light

CX-5_8FN1-EA-16L_Edition1.indb 632016/12/12 10:05:58

4–64
When Driving
Switches and Controls
*Some models.
Fully Automatic Climate Control
Indicator light

Mirror Defogger *
The mirror defoggers defrost the outside
mirrors.

The mirror defoggers operate in
conjunction with the rear window
defogger.
To turn on the mirror defoggers, switch
the ignition ON and press the rear window
defogger switch (page 4-62 ).
Manual Climate Control

Indicator light

Fully Automatic Climate Control

Indicator light

CX-5_8FN1-EA-16L_Edition1.indb 642016/12/12 10:05:58

4–72
When Driving
Brake
  An operation sound occurs when
applying or releasing the electric
parking brake (EPB), however, this does
not indicate a malfunction.
  If the electric parking brake (EPB) is
not used for long periods, an automatic
inspection of the system is performed
while the vehicle is parked. An
operation sound can be heard, however,
this does not indicate a problem.
  When the electric parking brake (EPB)
is applied and the ignition is switched
OFF, an operation sound can be heard,
however, this does not indicate a
problem.
  The brake pedal may move while the
electric parking brake (EPB) is being
applied or released, however, this does
not indicate a problem.
  If the electric parking brake (EPB)
switch is continually pulled while
driving the vehicle, the electric parking
brake (EPB) will be applied and the
electric parking brake (EPB) warning
beep will be activated. When the switch
is released, the electric parking brake
(EPB) is released and the beep stops.
  If the electric parking brake (EPB) is
applied with the ignition switched off
or in ACC, the electric parking brake
(EPB) indicator light in the instrument
cluster and the indicator light in the
switch may turn on for 15 seconds.
  When running the vehicle through an
automatic car wash, it may be necessary
to switch the ignition off with the
parking brake released depending on
the type of automatic car wash.

When applying the electric parking
brake (EPB)
The electric parking brake (EPB) can be
applied regardless of the ignition switch
position.
Securely depress the brake pedal and
pull up the electric parking brake (EPB)
switch.
The electric parking brake (EPB) is
applied and the electric parking brake
(EPB) indicator light and the electric
parking brake (EPB) switch indicator light
turn on.
Refer to Warning/Indicator Lights on page
4-32 .


CX-5_8FN1-EA-16L_Edition1.indb 722016/12/12 10:06:00

4–73
When Driving
Brake
When releasing the electric parking
brake (EPB)
The electric parking brake (EPB) can be
released while the ignition is switched
ON or the engine is running. When the
electric parking brake (EPB) is released,
the electric parking brake (EPB) indicator
light and the electric parking brake (EPB)
switch indicator light turn off.
electric parking brake (EPB) manual
release
Securely depress the brake pedal and press
down the electric parking brake (EPB)
switch.
Indicator light

Firmly depress the brake pedal and press
the electric parking brake (EPB) switch.
If the electric parking brake (EPB) switch
is pressed without depressing the brake
pedal, the display or indicator light in the
instrument cluster noti fi es the driver that
the brake is not depressed.
(Type A instrument cluster)
A message is displayed on the multi-
information display in the instrument
cluster.
Refer to Message Indicated in Multi-
information Display on page 7-35 . (Type B instrument cluster)
The brake pedal operation demand
indicator light (green) in the instrument
cluster turns on.

(Green)
electric parking brake (EPB) automatic
release
If the accelerator pedal is depressed with
the electric parking brake (EPB) applied
and all of the following conditions met, the
parking brake is released automatically.
   The engine is running.  The driver's door is closed.  The driver's seat belt is fastened.
(Manual transaxle)   The change lever is in a position other
than neutral.
   The clutch pedal is depressed halfway
(Automatic transaxle)   Selector lever is in the D, M, or R
position

NOTE
If something such as the driver's foot
contacts the accelerator pedal with the
engine running and the electric parking
brake (EPB) applied, the parking brake
may be released automatically. If you
do not intend to drive immediately, shift
the change lever (manual transaxle) to
the neutral position, or shift the selector
lever (automatic transaxle) to the P or N
position.

CX-5_8FN1-EA-16L_Edition1.indb 732016/12/12 10:06:00

4–77
When Driving
Brake
CAUTION
If you stop operating the accelerator pedal before the vehicle starts moving, the force
holding the vehicle in the stopped position may weaken. Firmly depress the brake pedal
or depress the accelerator pedal to accelerate the vehicle.

NOTE
  Under the following conditions, a problem with the AUTOHOLD is occurring. Have your
vehicle inspected at an Authorized Mazda Dealer as soon as possible.
  The brake pedal operation request warning light (red) in the instrument cluster fl ashes
and the warning sound is activated for about fi ve seconds while the AUTOHOLD is
operating or when you press the AUTOHOLD switch.
   A message is indicated on the multi-information display and a warning sou\
nd is
activated for about fi ve seconds while the AUTOHOLD is operating or when your
press the AUTOHOLD switch.
   If the ignition is switched OFF while the AUTOHOLD is still operating, the electric
parking brake (EPB) is applied automatically shift lever is shifted to\
R.
  (Automatic transaxle vehicle)  The AUTOHOLD is canceled when the shift lever is shifted to R while the vehicle\
is on
level ground, or facing up a hill or grade (as shown below).

Level ground
: Driving in reverse (selector lever in R)
Vehicle tilts forward Vehicle tilts rearward
AUTOHOLD :
Operates AUTOHOLD :
Does not operate,
canceled
AUTOHOLD :
Does not operate,
canceled

CX-5_8FN1-EA-16L_Edition1.indb 772016/12/12 10:06:01