2017 MAZDA MODEL CX-5 brakes
[x] Cancel search: brakesPage 214 of 664
4–70
When Driving
Brake
Brake System
Foot Brake
This vehicle has power-assisted brakes
that adjust automatically through normal
use.
Should power-assist fail, you can stop by
applying greater force than normal to the
brake pedal. But the distance required to
stop will be greater than usual.
WARNING
Do not coast with the engine stalled or
turned off , fi nd a safe place to stop: Coasting with the engine stalled or
turned off is dangerous. Braking will
require more eff ort, and the brake's
power-assist could be depleted if
you pump the brake. This will cause
longer stopping distances or even an
accident.
Shift to a lower gear when going down
steep hills: Driving with your foot continuously on
the brake pedal or steadily applying
the brakes for long distances is
dangerous. This causes overheated
brakes, resulting in longer stopping
distances or even total brake failure.
This could cause loss of vehicle
control and a serious accident. Avoid
continuous application of the brakes.
Dry off brakes that have become
wet by driving slowly, releasing the
accelerator pedal and lightly applying
the brakes several times until the brake
performance returns to normal: Driving with wet brakes is dangerous.
Increased stopping distance or the
vehicle pulling to one side when
braking could result in a serious
accident. Light braking will indicate
whether the brakes have been aff ected.
CX-5_8FN1-EA-16L_Edition1.indb 702016/12/12 10:05:59
Page 215 of 664
4–71
When Driving
Brake
CAUTION
Do not drive with your foot held on the clutch pedal or brake pedal, or hold
the clutch pedal depressed halfway
unnecessarily. Doing so could result in
the following:
The clutch and brake parts will wear out more quickly.
The brakes can overheat and adversely aff ect brake performance.
Always depress the brake pedal with
the right foot. Applying the brakes with
the unaccustomed left foot could slow
your reaction time to an emergency
situation resulting in insuffi cient braking
operation.
Wear shoes appropriate for driving in order to avoid your shoe contacting
the brake pedal when depressing the
accelerator pedal.
Electric Parking Brake (EPB)
The electric parking brake (EPB)
equipment applies the parking brake
using an electric motor. When the
electric parking brake (EPB) is applied,
the electric parking brake (EPB) switch
indicator light turns on.
Indicator light
WARNING
Do not drive the vehicle with the electric
parking brake (EPB) applied: If the vehicle is driven with the parking
brake applied, the brake parts may
generate heat and the brake system
may not operate, leading to an
accident.
Before driving, release the electric
parking brake (EPB) and verify that the
electric parking brake (EPB) indicator
light is turned off .
NOTE
The electric parking brake (EPB)
cannot be applied or released while the
vehicle battery is dead.
If the electric parking brake (EPB) is
repeatedly applied and released it may
stop operating to prevent overheating
of the motor. If this occurs, wait approx.
1 minute before operating the electric
parking brake (EPB) switch again.
CX-5_8FN1-EA-16L_Edition1.indb 712016/12/12 10:05:59
Page 218 of 664
4–74
When Driving
Brake
Warning Light
The warning light turns on when the
system has a malfunction.
Refer to Warning Indication/Warning
Lights on page 4-33 .
Brake Pad Wear Indicator
When the disc brake pads become worn,
the built-in wear indicators contact the
disc plates. This causes a screeching noise
to warn that the pads should be replaced.
When you hear this noise, consult an
Authorized Mazda Dealer as soon as
possible.
WARNING
Do not drive with worn disc pads: Driving with worn disc pads is
dangerous. The brakes could fail and
cause a serious accident. As soon as
you hear a screeching noise consult an
Authorized Mazda Dealer.
Brake Assist
During emergency braking situations
when it is necessary to depress the brake
pedal with greater force, the brake assist
system provides braking assistance, thus
enhancing braking performance.
When the brake pedal is depressed hard or
depressed more quickly, the brakes apply
more fi rmly.
NOTE
When the brake pedal is depressed hard
or depressed more quickly, the pedal
will feel softer but the brakes will apply
more fi rmly. This is a normal effect of
the brake assist operation and does not
indicate a malfunction.
When the brake pedal is depressed
hard or depressed more quickly, a
motor/pump operation noise may be
heard. This is a normal effect of the
brake assist and does not indicate a
malfunction.
The brake assist equipment does not
supersede the functionality of the
vehicle's main braking system.
CX-5_8FN1-EA-16L_Edition1.indb 742016/12/12 10:06:00
Page 219 of 664
4–75
When Driving
Brake
AUTOHOLD
The AUTOHOLD function automatically holds the vehicle stopped, even if you take your
foot off the brake pedal. This function can be best used while stopped in traffi c or at a traf fi c
light. The brakes will automatically release when you start driving again (rel\
easing the
clutch pedal while in gear (manual transaxle) or depressing the accele\
rator pedal (automatic
transaxle)).
CX-5_8FN1-EA-16L_Edition1.indb 752016/12/12 10:06:01
Page 220 of 664
4–76
When Driving
Brake
WARNING
Do not rely completely on the AUTOHOLD function: The AUTOHOLD function is only designed to assist the brake operation while the vehicle
is stopped. Neglecting to operate the brakes and relying only on the AUTOHOLD system
is dangerous and could result in an unexpected accident if the vehicle were to suddenly
move. Operate the brakes appropriately in accordance with the road and surrounding
conditions.
Do not release your foot from the brake pedal while the vehicle is stopped on a steep
grade: Because there is a possibility of the vehicle not being held in the stopped position by the
AUTOHOLD function, the vehicle may move unexpectedly and result in an accident.
Do not use the AUTOHOLD function on slippery roads such as icy or snow-covered
roads, or unpaved roads: Even if the vehicle is held in the stopped position by the AUTOHOLD function, the vehicle
may move unexpectedly and result in an accident. Operate the accelerator pedal, brakes,
or steering wheel appropriately as necessary.
Immediately depress the brake pedal in the following cases: Because the AUTOHOLD function is canceled forcibly, the vehicle may move unexpectedly
and result in an accident.
The brake pedal operation request warning light (red) fl ashes and the warning sound is activated at the same time.
(Red) [Brake Hold Unavailable Depress Brake to Hold Position] is displayed in the multi-information display and the warning sound is activated at the same time.
Always apply the electric pa rking brake (EPB) when parking the vehicle:
Not applying the electric parking brake (EPB) when parking the vehicle is dangerous as
the vehicle may move unexpectedly and result in an accident. When parking the vehicle,
shift the selector lever to the P position (automatic transaxle vehicle) and apply the
electric parking brake (EPB).
CX-5_8FN1-EA-16L_Edition1.indb 762016/12/12 10:06:01
Page 222 of 664
4–78
When Driving
Brake
AUTOHOLD System is Turned On
Press the AUTOHOLD switch and when
the AUTOHOLD standby indicator light
turns on, the AUTOHOLD function turns
on.
AUTOHOLD standby
indicator light
NOTE
When all of the following conditions are
met, the AUTOHOLD standby indicator
light turns on when the AUTOHOLD
switch is pressed and the AUTOHOLD
function turns on.
The ignition is switched ON (engine is
running).
The driver's seat belt is fastened. The driver's door is closed. There is no problem with the
AUTOHOLD function.
To operate AUTOHOLD and hold the
brakes
1. Depress the brake pedal and bring the vehicle to a complete stop.
2. The AUTOHOLD active indicator light in the instrument cluster turns on and
the brakes are held.
3. The vehicle is held in its stopped position even with the brake pedal
released.
NOTE
When all of the following conditions are
met, the AUTOHOLD operates and the
brakes are held.
The ignition is switched ON (engine is
running).
The vehicle is stopped. The brake pedal is being depressed. The AUTOHOLD active indicator light
turns on.
The accelerator pedal is not depressed. The driver's seat belt is fastened. The driver's door is closed. There is no problem with the
AUTOHOLD function.
The electric parking brake (EPB) is
released.
There is no problem with the electric
parking brake (EPB) function.
(Automatic transaxle vehicle) The selector lever is in a position other
than R position or the vehicle tilts
forward with the selector lever in the R
position.
CX-5_8FN1-EA-16L_Edition1.indb 782016/12/12 10:06:01
Page 223 of 664
4–79
When Driving
Brake
To release AUTOHOLD and start
driving the vehicle
If you do any of the following actions
to resume driving the vehicle, the
brakes release automatically and the
AUTOHOLD active indicator light turns
off.
(Manual transaxle vehicle) You start to release the clutch pedal with
the shift lever shifted to a position other
than the neutral position
(Automatic transaxle vehicle) The accelerator pedal is depressed. The vehicle tilts rearward or the
selector lever is shifted to the R
position on level ground.
NOTE
If the electric parking brake (EPB)
switch is pulled while the AUTOHOLD
is operating, the AUTOHOLD is
released and the electric parking brake
(EPB) is applied. In addition, if the
electric parking brake (EPB) is released
under this condition, the AUTOHOLD
operates to hold the brakes.
Under the following conditions,
the electric parking brake (EPB)
is automatically applied and the
AUTOHOLD is released. The
AUTOHOLD is re-enabled when the
conditions before the AUTOHOLD is
released are restored.
The driver’s seat belt is unfastened. The driver’s door is opened. When about ten minutes or longer
have passed since the AUTOHOLD
operation started, the electric parking
brake (EPB) is automatically applied.
Because the AUTOHOLD is restored
when releasing the electric parking
brake (EPB), the hold on the brakes by
AUTOHOLD function resumes.
CX-5_8FN1-EA-16L_Edition1.indb 792016/12/12 10:06:01
Page 224 of 664
4–80
When Driving
Brake
AUTOHOLD System is Turned Off
The vehicle is driven
Press the AUTOHOLD switch to turn off
the AUTOHOLD ( AUTOHOLD standby
indicator light turns off).
Brakes are held
Depress the brake pedal and press the
AUTOHOLD switch to turn off the
AUTOHOLD (AUTOHOLD standby
indicator light and AUTOHOLD active
indicator light in instrument cluster turn
off).
AUTOHOLD standby
indicator light
NOTE
(Without multi-information display) If the AUTOHOLD switch is pressed
without depressing the brake pedal
while the AUTOHOLD is operating
(AUTOHOLD active indicator light is
turned on), the brake pedal operation
request indicator light (green) in the
instrument cluster turns on to notify the
driver that it is necessary to depress the
brake pedal.
(Green) (With multi-information display) If the AUTOHOLD switch is pressed
without depressing the brake pedal
while AUTOHOLD is operating
(AUTOHOLD active indicator light
in instrument cluster is turned on),
the message Depress Brake Pedal to
Release Parking Brake is indicated on
the multi-information display to notify
the driver to depress the brake pedal.
If any of the following conditions
occurs while the AUTOHOLD function
is operating (AUTOHOLD active
indicator light is turned on), the
electric parking brake (EPB) is applied
automatically and the AUTOHOLD
function turns off. For the electric
parking brake (EPB) operation, refer
to the electric parking brake (EPB) on
page 4-71 .
The ignition is switched OFF. There is a problem with the
AUTOHOLD function.
CX-5_8FN1-EA-16L_Edition1.indb 802016/12/12 10:06:01