2017 MAZDA MODEL CX-5 engine

6–45
Maintenance and Care
Owner Maintenance
*Some models.
CAUTION
When removing the lens or lamp unit
using a fl athead screwdriver, make
sure that the fl athead screwdriver does
not contact the interior terminal. If
the fl athead screwdriver contacts the
terminal, a short circuit may occur.

NOTE
  To replace the bulb, contact an
Authorized Mazda Dealer.
  Use the protective cover and carton for
the replacement bulb to dispose of the
old bulb promptly and out of the reach
of children.

Replacing Exterior Light Bulbs
Headlights/Daytime running lights,
Daytime running lights/Parking lights
(Type A), Front side-marker lights
(Type A), Fog lights
* , Brake lights (Type
A), Taillights (Type A), Reverse lights,
High-mount brake light, Side turn
signal lights, Rear side-marker lights
(Type A)
The LED bulb cannot be replaced as a
single unit because it is an integrated unit.
The LED bulb has to be replaced with the
unit. We recommend an Authorized Mazda
Dealer when the replacement is necessary.
Front turn signal lights/Parking lights
1. Make sure the ignition is switched off, and the headlight switch is off.
2. Lift the hood.
Refer to Hood on page 6-20 .
3. Turn the socket and bulb assembly counterclockwise and remove it.
4. Disconnect the bulb from the socket.


5. Install the new bulb in the reverse order of the removal procedure.

Front side-marker lights (Type B)
1. Make sure the ignition is switched off, and the headlight switch is off.
2. If you are changing the right bulb, start the engine, turn the steering wheel all
the way to the left, and turn off engine.
If you are changing the left bulb, turn
the steering wheel to the right.
3. Pull the center of each plastic retainer using a fl athead screwdriver and
remove the retainers, and then partially
peel back the over fender.

Removal
Installation

CX-5_8FN1-EA-16L_Edition1.indb 452016/12/12 10:07:13

6–50
Maintenance and Care
Owner Maintenance
Fuses
Your vehicle's electrical system is
protected by fuses.

If any lights, accessories, or controls do
not work, inspect the appropriate circuit
protector. If a fuse has blown, the inside
element will be melted.

If the same fuse blows again, avoid using
that system and consult an Authorized
Mazda Dealer as soon as possible.
Fuse Replacement
Replacing the fuses on the vehicle's left
side
If the electrical system does not work, fi rst
inspect the fuses on the vehicle's left side.


1. Make sure the ignition is switched off, and other switches are off.
2. Open the fuse panel cover.

3. Pull the fuse straight out with the
fuse puller provided on the fuse block
located in the engine compartment.


4. Inspect the fuse and replace it if it is blown.

Normal Blown

5. Insert a new fuse of the same amperage rating, and make sure it fi ts tightly. If
it does not fi t tightly, have an expert
install it. We recommend an Authorized
Mazda Dealer.
If you have no spare fuses, borrow one of the same rating from a circuit not
essential to vehicle operation, such as
the AUDIO or OUTLET circuit.
CAUTION
Always replace a fuse with a genuine
Mazda fuse or equivalent of the same
rating. Otherwise you may damage
the electric system.

CX-5_8FN1-EA-16L_Edition1.indb 502016/12/12 10:07:15

6–52
Maintenance and Care
Owner Maintenance
*Some models.
Fuse Panel Description
Fuse block (Engine compartment)

DESCRIPTION FUSE
RATING PROTECTED COMPONENT
1
50 A For protection of various circuits
2 IG2 30 A For protection of various circuits
3 INJECTOR
ENG.SUB 30 A Engine control system
4 SCR1
EVVT 20 A Engine control system
5 P.WINDOW1 30 A Power windows
6 R.HEATER 20 A —
7 ADD FAN DE 40 A —
8 WIPER.DEI 20 A Windshield wiper de-icer
*
9 DEFOG 40 A Rear window defogger
10 DCDC DE 40 A —
11 EPB R 20 A Electric parking brake (EPB) (RH)
12 EPB L 20 A Electric parking brake (EPB) (LH)
13 AUDIO
DCDC REG 30 A Audio system
*
CX-5_8FN1-EA-16L_Edition1.indb 522016/12/12 10:07:16

6–53
Maintenance and Care
Owner Maintenance
*Some models.
DESCRIPTION FUSE
RATING PROTECTED COMPONENT
14 FAN GE 30 A Cooling fan
15 ENG.MAIN 40 A Engine control system
16 ABS/DSC M 50 A ABS, Dynamic stability control system
17 FAN DE 40 A —
18 WIPER 20 A Front window wiper and washer
19 HEATER 40 A Air conditioner
20 ADD FAN GE 30 A Cooling fan
21 ENGINE.IG1 7.5 A Engine control system
22 C/U IG1 15 A For protection of various circuits
23 AUDIO2 7.5 A Audio system
24 METER2 7.5 A —
25 ENGINE3 15 A Engine control system
26 ENGINE2 15 A Engine control system
27 ENGINE1 15 A Engine control system
28 AT 15 A Transaxle control system
* , Ignition switch
29 H/CLEAN 20 A —
30 A/C 7.5 A Air conditioner
31 AT PUMP 15 A Transaxle control system
*
32 HORN 15 A Horn
33 R.WIPER 15 A Rear window wiper
34 H/L HI 20 A Headlight high beam
35 ST.HEATER 15 A Heated steering wheel
*
36 FOG 15 A Fog lights *
37
7.5 A Engine control system
38 H/L LOW L 15 A Headlight low beam (LH)
39 ENGINE4 15 A —
40 — — —
41 METER1 10 A Instrument cluster
42 SRS1 7.5 A Air bag
43 BOSE 25 A Bose
® Sound System-equipped model *
44 AUDIO1 15 A Audio system
45 ABS/DSC S 30 A ABS, Dynamic stability control system
46 FUEL PUMP 15 A Fuel system
47 FUEL WARM 25 A —
48 TAIL 15 A Taillights, License plate lights
49 SCR2
FUEL PUMP2 25 A
—
50 HAZARD 25 A Hazard warning
fl ashers, Turn signal lights/Front side-marker
lights, Parking lights
CX-5_8FN1-EA-16L_Edition1.indb 532016/12/12 10:07:16

6–58
Maintenance and Care
Appearance Care
Maintaining the Finish
Washing
CAUTION
 When the wiper lever is in the
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
 If the windshield above the rain sensor is touched or wiped with a
cloth.
 If the windshield is struck with a hand or other object from either outside or
inside the vehicle.
 Keep hands and scrapers clear of the windshield when the wiper lever is in the

position and the ignition is
switched ON as fi ngers could be pinched
or the wipers and wiper blades damaged
when the wipers activate automatically.
 If you are going to clean the windshield, be sure the wipers are turned off
completely (when it is most likely
that the engine is left running) this is
particularly important when clearing ice
and snow.
 Do not spray water in the engine compartment. Otherwise, it could result
in engine-starting problems or damage
to electrical parts.
 When washing and waxing the vehicle, be careful not to apply excessive force
to any single area of the vehicle roof.
Otherwise, you could dent the vehicle.

To help protect the fi nish from rust
and deterioration, wash your Mazda
thoroughly and frequently, at least once a
month, with lukewarm or cold water.
If the vehicle is washed improperly, the
paint surface could be scratched. Here are
some examples of how scratching could
occur.

Scratches occur on the paint surface when:
 
 The vehicle is washed without fi rst
rinsing off dirt and other foreign matter.
   The vehicle is washed with a rough, dry,
or dirty cloth.
   The vehicle is washed at a car wash that
uses brushes that are dirty or too stiff.
   Cleansers or wax containing abrasives
are used.

NOTE
   Mazda is not responsible for scratches
caused by automatic car washes or
improper washing.
  Scratches are more noticeable on
vehicles with darker paint fi nishes.

To minimize scratches on the vehicle's
paint fi nish:
  Rinse off any dirt or other foreign matter
using lukewarm or cold water before
washing.
   Use plenty of lukewarm or cold water
and a soft cloth when washing the
vehicle. Do not use a nylon cloth.
   Rub gently when washing or drying the
vehicle.
   Take your vehicle only to a car wash
that keeps its brushes well maintained.
   Do not use abrasive cleansers or wax
that contain abrasives.

CX-5_8FN1-EA-16L_Edition1.indb 582016/12/12 10:07:17

6–62
Maintenance and Care
Appearance Care
Plastic Part Maintenance
  When cleaning the plastic lenses of the
lights, do not use gasoline, kerosene,
recti fi ed spirit, paint, thinner, highly
acidic detergents, or strongly alkaline
detergents. Otherwise, these chemical
agents can discolor or damage the
surfaces resulting in a signi fi cant loss
in functionality. If plastic parts become
inadvertently exposed to any of these
chemical agents, fl ush with water
immediately.
   If plastic parts such as the bumpers
become inadvertently exposed to
chemical agents or fl uids such as
gasoline, oil, engine coolant, or battery
fl uid, it could cause discoloration,
staining, or paint peeling. Wipe off any
such chemical agents or fl uids using a
soft cloth immediately.
   High water temperature and high water
pressure car washers are available
depending on the type of high pressure
car washer device. If the car washer
nozzle is put too close to the vehicle or
aimed at one area for an extended period
of time, it could deform plastic parts or
damage the paint.
   Do not use wax containing compounds
(polish). Otherwise, it could result in
paint damage.
   In addition, do not use an electrical or
air tool to apply wax. Otherwise, the
frictional heat generated could result
in deformation of plastic parts or paint
damage.

Interior Care
WARNING
Do not spray water into the vehicle
cabin: Spraying water into the vehicle cabin is
dangerous as electrical devices such as
the audio and switches could get wet
resulting in a malfunction or vehicle
fi r e .

NOTE
  Do not wipe the interior using alcohol,
chlorine bleach, or organic solvents
such as thinner, benzene, and gasoline.
Otherwise, it may cause discoloration
or stains.
  Rubbing hard with a stiff brush or cloth
may cause damage.

If the vehicle interior becomes soiled
by any of the following, wipe it off
immediately using a soft cloth.
Leaving it uncleaned could cause
discoloration, stains, cracks, or peeling
of the coating, and it will make it hard to
wipe off later.
  Beverage or fragrance  Grease or oil  Soiling
CX-5_8FN1-EA-16L_Edition1.indb 622016/12/12 10:07:17

7–1*Some models.
7If Trouble Arises
Helpful information on what to do if a problem arises with the vehicle.


Parking in an Emergency .................................................................. 7-2 Parking in an Emergency .............................................................. 7-2

Flat Tire.......................................................................\
........................ 7-3 Spare Tire and Tool Storage .......................................................... 7-3
Changing a Flat Tire ...................................................................... 7-6

Battery Runs Out ........................................................................\
..... 7-14 Jump-Starting ........................................................................\
...... 7-14

Emergency Starting ........................................................................\
. 7-17 Starting a Flooded Engine ........................................................... 7-17
Push-Starting ........................................................................\
....... 7-17

Overheating ........................................................................\
.............. 7-18 Overheating ........................................................................\
......... 7-18

Emergency Towing ........................................................................\
... 7-20 Towing Description ..................................................................... 7-20
Tiedown Hooks
* ........................................................................\
.. 7-21

Warning/Indicator Lights and Warning Sounds ........................... 7-23 If a Warning Light Turns On or Flashes...................................... 7-23
Message Indicated in Multi-information Display
* ...................... 7-35
Message Indicated on Display * ................................................... 7-37
Warning Sound is Activated ........................................................ 7-39

When Liftgate Cannot be Opened .................................................. 7-44 When Liftgate Cannot be Opened ............................................... 7-44

Active Driving Display Does Not Operate ..................................... 7-45 If the Active Driving Display does not operate
* ......................... 7-45
CX-5_8FN1-EA-16L_Edition1.indb 12016/12/12 10:07:18

7–7
If Trouble Arises
Flat Tire
1. Park on a hard, level surface off the right-of-way and fi rmly set the parking
brake.
2. Put a vehicle with an automatic transaxle in Park (P), a manual
transaxle in Reverse (R) or 1, and turn
off the engine.
3. Turn on the hazard warning fl asher.
4. Have everyone get out of the vehicle and away from the vehicle and traf fi c.
5. Remove the jack, tool, and spare tire (page 7-3 ).
6. Block the wheel diagonally opposite the fl at tire. When blocking a wheel,
place a tire block both in front and
behind the tire.


NOTE
When blocking a tire, use rocks or wood
blocks of suffi cient size if possible to hold
the tire in place.

Removing a Flat Tire
WARNING
When jacking-up a vehicle, always
shift the shift lever to 1st or R (manual
transaxle vehicle) or shift the selector
lever to P (automatic transaxle vehicle),
apply the parking brake, and place
wheel blocks in the position diagonally
opposed to the jack: Changing a fl at tire without using
wheel blocks is dangerous because
the vehicle may move and fall off the
jack even with the shift lever in 1st or
R, or the select lever is in P, which could
result in an accident.

1. If your vehicle is equipped with steel wheels, pry off the center cap with the
beveled end of the jack lever.



CAUTION
Use the jack lever when removing
the center cap. Using your hands to
remove it may cause an injury. In
addition, using a tool other than the
jack lever may cause damage to the
wheel or the center cap.

CX-5_8FN1-EA-16L_Edition1.indb 72016/12/12 10:07:19