2017 MAZDA MODEL CX-3 automatic transmission

5–25
Interior Features
Audio Set [Type A (non-touchscreen)]
*Some models.
Indication Setting value Tu r n
Anticlockwise Tu r n
Clockwise
12HR
24HR
(12 HR/24 HR time
adjustment) 12HR
(Flashing) 24HR
(Flashing)
*1 With Radio Data System (RDS)
*2 Depending on the model, this function may not be
available.
NOTE
If not operated for several seconds, the
display returns to the previous display.
To reset bass, treble, fade, and balance,
press the menu button (
) for 2
seconds. The unit will beep and
“ CLEAR ” will be displayed.
AF (Setting Alternative Frequency
(AF))
*
The AF function of the Radio Data System
(RDS) can be set on or off.
Refer to Radio Data System (RDS) on
page 5-30 .
REG (Setting Regional Programme
(REG))
*
The REG function of the Radio Data
System (RDS) can be set on or off.
Refer to Radio Data System (RDS) on
page 5-30 . ALC (Automatic volume adjustment)
The automatic level control (ALC)
changes the audio volume automatically
according to the vehicle speed. The faster
the vehicle speed, the higher the volume
increases. ALC has ALC OFF and ALC
LEVEL 1 to 7 modes. At ALC LEVEL 7,
the amount that the volume can increase
is at the maximum. Select the mode
according to the driving conditions.
BEEP (Audio operation sound)
The setting for the operation sound when
pressing and holding a button can be
changed. The initial setting is ON. Set to
OFF to mute the operation sound.
BT SETUP mode
*
Music and other audio such as voice data
recorded on portable audio devices and
mobile phones available on the market
which are equipped with the Bluetooth
®
transmission function can be listened to
via wireless transmission over the vehicle's
speakers. Using the BT SETUP mode,
these devices can be programmed to the
Bluetooth
® unit or changed (page 5-48 ).
1 2 H R
24HR
(12 HR/24 HR time adjustment)
Rotating the audio control dial switches
the display between 12 and 24-hour clock
time (page 5-26 ).

7–6
If Trouble Arises
Mazda ERA-GLONASS (Russia)
NOTE
  The Mazda ERA-GLONASS can be used when the ignition is switched ON. 
 There are two ways the Mazda ERA-GLONASS makes calls; automatically or
manually.
  The Mazda ERA-GLONASS may not operate in the following cases: If the Mazda
ERA-GLONASS does not operate, make a call from another telephone such as the
nearest available public telephone.
 


 The vehicle is outside of a mobile phone network area



 The vehicle is in a weak radio wave transmission environment (such as inside
tunnels, underground parking areas, shadow of buildings, and mountain areas)
 


 The vehicle does not receive an impact of a certain level or more even if an accident
has occurred.
 


 An extremely serious collision occurs resulting in damage to the Mazda ERA-
GLONASS.
 


 Signals cannot be received from the GPS, GLONASS satellites (voice call is
possible even if position information is not obtainable)


 When a voice call is made by the Mazda ERA-GLONASS, the audio system is muted
so that it does not interfere with the call.
  It may take some time for the call centre to respond after the Mazda ERA-GLONASS
¿ rst starts operating.

 If you are unable to respond to an operator's questions after the voice call begins, the
operator may proceed with emergency procedures at their own discretion.
  Even if it is dif¿ cult for you to hear the operator's voice, your voice may be heard by
the call centre. Continue explaining your circumstances.
  If the Mazda ERA-GLONASS operates while you are making a call with your mobile
phone using Bluetooth ® Hands-Free, the call may be interrupted.   It may not be possible to receive a call using the Bluetooth ® Hands-Free normally
while the Mazda ERA-GLONASS is operating.
  A voice call with an operator may not be possible if the speaker or microphone is
broken. If the speaker or microphone is broken, always have the vehicle inspected at
an Authorised Mazda Repairer.
  The Mazda ERA-GLONASS may not operate normally outside of the following
temperature range: If the Mazda ERA-GLONASS does not operate normally, make a
call from another telephone such as the nearest available public telephone.
 Operation temperature range: -40 °C (-40 °F) to 85 °C (185 °F)   There may be a difference between the position information sent to the call centre and
the actual position of the vehicle where the call was made. Indicate landmarks around
the position of the vehicle where the call is being made to the operator during the voice
call.

7–7
If Trouble Arises
Mazda ERA-GLONASS (Russia)
Automatic emergency calls
If the vehicle receives an impact of a certain level or more in a collision, vehicle information
is automatically sent to the call centre.
When the transmission of the vehicle information is completed or about 20 seconds have
elapsed since the transmission began, the voice call with the call centre starts.
CAUTION
If an automatic call is made, the built-in battery power may be depleted and emergency
calls may not be possible in the event that an emergency occurs again. After an automatic
emergency call has been made, have the built-in battery replaced by an Authorised Mazda
Repairer.
NOTE
  Automatic emergency calls cannot be cancelled by the user. 
 The call centre will end an emergency call. The user cannot end the emergency call. 
 If the vehicle receives an impact of a certain level or more in a collision, an automatic
call is made even if the air bags do not deploy.
1. If the vehicle receives an impact of a certain level or more in a collision, the Mazda
ERA-GLONASS begins operating automatically.
2. The indicator light (green) on the Mazda ERA-GLONASS switch À ashes slowly (0.5
second intervals) and the call is made to the call centre.


Green

3. When the connection is established with the call centre, the indicator light (green) À ashes
somewhat quickly (0.3 second intervals) and the beep sounds simultaneously, and the
transmission of the vehicle information begins.

7–8
If Trouble Arises
Mazda ERA-GLONASS (Russia)
4. When the transmission of the vehicle information is completed or about 20 seconds have
elapsed since the transmission began, the beep sounds and the voice call with the call
centre starts.
5. If the connection fails, the indicator light (red) turns on and the indicator light (green)
À ashes quickly (0.15 second intervals) and the beep sounds simultaneously.
In this case, make a manual connection using the Mazda ERA-GLONASS switch
because an automatic connection is not possible.


Green
(Flashes)Red
(Turns
on)

7–9
If Trouble Arises
Mazda ERA-GLONASS (Russia)
Manual emergency calls
With the ignition switched ON, long-press the Mazda ERA-GLONASS switch and after
releasing your ¿ nger from the switch, the vehicle information is automatically transmitted to
the call centre.
When the transmission of the vehicle information is completed or about 20 seconds have
elapsed since the transmission began, the voice call with the call centre starts.
NOTE
  Only make calls manually for conditions requiring urgent treatment such as illness or
serious injury.
  When making emergency calls manually, stop the vehicle in a safe location before
making the call.
  A manual emergency call can be cancelled even after the Mazda ERA-GLONASS
switch has been pressed by pressing the switch again, as long as the call with the call
centre has not begun. If the call cannot be cancelled and the call with the call centre
has begun, tell the operator that the call is mistaken.
  The call centre will end an emergency call. The user cannot end the emergency call.
1. Make sure that the ignition is switched ON.
2. Long-press the Mazda ERA-GLONASS switch on the overhead console and then release
your ¿ nger from the switch.


Mazda ERA-GLONASS switch