2017 KIA OPTIMA PLUG-IN HYBRID inflation pressure

(Continued)
system be inspected by an author‐ized Kia dealer.•The light does not turn on brieflywhen you turn the engine start/stop button is ON.
•The light stays on after illuminat‐ing for approximately 6 seconds.
•The light comes on while the vehi‐cle is in motion.
•The light blinks when the enginestart/stop button to the ON posi‐tion.
%SJWFSLÓT
GSPOU
BJS
CBH


##-
The front air bag modules are located
in the center of the steering wheel, in the front passenger's panel above the
glove box and/or in the driver’s side
knee bolster. When the SRSCM detects a sufficiently severe impact to the
front of the vehicle, it will automatically
deploy the front air bags.
%SJWFSLÓT
GSPOU
BJS
CBH


##-
Upon deployment, tear seams molded
directly into the pad covers will sepa‐ rate under pressure from the expan‐
sion of the air bags. Further opening of
the covers then allows full inflation of the air bags.

4-49
4
Safety features of your vehicle

Driving off-road
Drive carefully off-road because your
vehicle may be damaged by rocks or roots of trees. Become familiar with
the off-road conditions where you are
going to drive before you begin driving.
Highway driving
Tires
Adjust the tire inflation pressures to
specification. Low tire inflation pres‐ sures will result in overheating and pos‐
sible failure of the tires.
Avoid using worn or damaged tires
which may result in reduced traction or tire failure.
NOTICE
Never exceed the maximum tire in‐
flation pressure shown on the tires.
WARNING
•Underinflated or overinflated tirescan cause poor handling, loss ofvehicle control, and sudden tirefailure leading to accidents, inju‐ries, and even death. Always checkthe tires for proper inflation be‐fore driving. For proper tire pres‐sures, refer to L

Road warning............................................................................. 8-02Hazard warning flasher........................................................8-02
In case of an emergency while driving.................................. 8-03 If the engine stalls at a crossroad or crossing................. 8-03
If you have a flat tire while driving.................................... 8-03
If engine stalls while driving................................................ 8-03
If the engine will not start....................................................... 8-04 If engine doesn't turn over or turns over slowly............. 8-04
If engine turns over normally but does not start........... 8-04
Emergency starting.................................................................. 8-05 Jump starting.........................................................................8-05
Push-starting........................................................................ 8-06
If the engine overheats............................................................ 8-07
Tire Pressure Monitoring System (TPMS) ........................... 8-09 Check tire pressure............................................................... 8-09
Low tire pressure position telltale..................................... 8-10
TPMS (Tire Pressure Monitoring System) mal‐
function indicator.................................................................. 8-11
Changing a tire with TPMS.................................................. 8-12
If you have a flat tire (with Tire Mobility Kit).......................8-14 Introduction............................................................................8-14
Components of the Tire Mobility Kit (TMK)......................8-16
Using the TMK....................................................................... 8-17
Distributing the sealant....................................................... 8-19
Checking the tire inflation pressure...................................8-19
Notes on the safe use of the Tire Mobility Kit ............... 8-20
Technical data........................................................................ 8-20
Towing......................................................................................... 8-21 Towing service....................................................................... 8-21
Removable towing hook ..................................................... 8-22 Emergency towing................................................................ 8-22
If an accident occurs................................................................. 8-25
Emergency commodity ........................................................... 8-27 First aid kit............................................................................. 8-27
Triangle reflector.................................................................. 8-27
Tire pressure gauge .............................................................8-27
What to do in an emergency

8

Please note that the TPMS is not a
substitute for proper tire maintenance, and it is the driver’s responsibility to
maintain correct tire pressure, even if
under-inflation has not reached the level to trigger illumination of the TPMS
low tire pressure telltale.
Your vehicle has also been equipped
with a TPMS malfunction indicator to indicate when the system is not oper‐
ating properly. The TPMS malfunction
indicator is combined with the low tire pressure telltale. When the system de‐
tects a malfunction, the telltale will
flash for approximately 1 minute and then remain continuously illuminated.
This sequence will continue upon sub‐
sequent vehicle start-ups as long as the malfunction exists. When the TPMS
malfunction indicator remains illumina‐
ted after blinking for approximately 1 minute, the system may not be able to
detect or signal low tire pressure as in‐
tended. TPMS malfunctions may occur for a va‐
riety of reasons, including the installa‐
tion of replacement or alternate tires
or wheels on the vehicle that prevent the TPMS from functioning properly.
Always check the TPMS malfunction
telltale after replacing one or more tires or wheels on your vehicle to en‐
sure that the replacement or alternate
tires and wheels allow the TPMS to continue to function properly.
NOTICE
If any of the below happens, we rec‐
ommend that the system be
checked by an authorized Kia dealer.
1.The low tire pressure telltale/
TPMS malfunction indicator do
not illuminate for 3 seconds
when the ignition switch is
turned to the ON position or en‐
gine is running.
2.The TPMS malfunction indicator
remains illuminated after blink‐
ing for approximately 1 minute.
3.The Low tire pressure position
telltale remains illuminated.
Low tire pressure position
telltale
-PX
UJSF
QSFTTVSF
UFMMUBMF
8#)
0+'-#
¥
-PX
UJSF
QSFTTVSF
QPTJUJPO
JOGPSNBUJPO
What to do in an emergency
8-10

When the tire pressure monitoring sys‐
tem warning indicators are illuminated and warning massage displayed on the
cluster LCD display, one or more of
your tires is significantly under-infla‐ ted. The low tire pressure position tell‐
tale light will indicate which tire is sig‐
nificantly under-inflated by illuminating the corresponding position light.
If either telltale illuminates, immediate‐
ly reduce your speed, avoid hard cor‐
nering and anticipate increased stop‐ ping distances. You should stop and
check your tires as soon as possible. In‐
flate the tires to the proper pressure as
indicated on the vehicle’s placard or tire inflation pressure label located on the
driver’s side center pillar outer panel. If
you cannot reach a service station or if the tire cannot hold the newly added
air, replace the low pressure tire with a
spare tire.
If you drive the vehicle for about 10 mi‐ nutes at speeds above 25 km/h after
replacing the low pressure tire with the
spare tire, one of the following will hap‐ pen: • The TPMS malfunction indicator may
blink for approximately 1 minute and
then remain continuously illuminated
because the TPMS sensor is not
mounted on the spare wheel. (changed tire equipped with a sensor
not in the vehicle)
• The TPMS malfunction indicator will remain continuously illuminated while
driving because the TPMS sensor is
not mounted on the spare wheel. (changed tire equipped with a sensor
in the vehicle)
CAUTION
In winter or cold weather, the lowtire pressure telltale may illuminateif the tire pressure was adjusted tothe recommended tire inflation pres‐sure in warm weather. It does notmean your TPMS is malfunctioningbecause the decreased temperatureleads to a lowering of tire pressure.When you drive your vehicle from awarm area to a cold area or from acold area to a warm area, or theoutside temperature is higher orlower, you should check the tire in‐flation pressure and adjust the tires
(Continued)
(Continued)
to the recommended tire inflationpressure.
WARNING
nLow pressure damage
Significantly low tire pressure makesthe vehicle unstable and can contrib‐ute to loss of vehicle control and in‐creased braking distances.Continued driving on low pressuretires can cause the tires to overheatand fail.
TPMS (Tire Pressure
Monitoring System)
malfunction indicator
The TPMS malfunction indi‐ cator will illuminate after it blinks for
approximately one minute when there is a problem with the Tire Pressure
Monitoring System.
We recommend that the system be
checked by an authorized Kia dealer to determine the cause of the problem.

8-11
8
What to do in an emergency

You may not be able to identify a low
tire by simply looking at it. Always use a good quality tire pressure gauge to
measure the tire's inflation pressure.
Please note that a tire that is hot (from being driven) will have a higher pres‐
sure measurement than a tire that is
cold (from sitting stationary for at least 3 hours and driven less than
1.6 km (1 mile) during that 3 hour peri‐
od).
Allow the tire to cool before measuring the inflation pressure. Always be sure
the tire is cold before inflating to the
recommended pressure.
A cold tire means the vehicle has been sitting for 3 hours and driven for less
than 1.6 km (1 mile) in that 3 hour peri‐od.
CAUTION
We recommend that you use thesealant approved by Kia if your vehi‐cle is equipped with a Tire PressureMonitoring System. The liquid seal‐ant can damage the tire pressuresensors.
WARNING
nTPMS
•The TPMS cannot alert you to se‐vere and sudden tire damagecaused by external factors such asnails or road debris.
•If you feel any vehicle instability,immediately take your foot off theaccelerator, apply the brakes grad‐ually and with light force, andslowly move to a safe position offthe road.
WARNING
nProtecting TPMS
Tampering with, modifying, or disa‐bling the Tire Pressure MonitoringSystem (TPMS) components may in‐terfere with the system's ability towarn the driver of low tire pressureconditions and/or TPMS malfunc‐tions. Tampering with, modifying, ordisabling the Tire Pressure Monitor‐ing System (TPMS) components mayvoid the warranty for that portion ofthe vehicle.
WARNING
nFor EUROPE
•Do not modify the vehicle, it mayinterfere with the TPMS function.
•The wheels on the market do nothave a TPMS sensor.For your safety, we recommendthat you use parts for replace‐ment from an authorized Kia deal‐er.
•If you use the wheels on the mar‐ket, use a TPMS sensor approvedby a Kia dealer.If your vehicle is not equipped witha TPMS sensor or TPMS does notwork properly, you may fail theperiodic vehicle inspection conduc‐ted in your country.❈All vehicles sold in the EUROPEmarket during below periodmust be equipped with TPMS.-New model vehicle:Nov. 1, 2012 ~
-Current model vehicle:Nov. 1, 2014 ~ (Based on vehi‐cle registrations)

8-13
8
What to do in an emergency

Components of the Tire Mobility Kit (TMK)
0+'
1. Speed restriction label
2. Sealant bottle and label with speedrestriction
3. Filling hose from sealant bottle to wheel
4. Connectors and cable for the bat‐ tery direct connection
5. Holder for the sealant bottle
6. Compressor
7. On/off switch
8. Pressure gauge for displaying the tire inflation pressure
9. Button for reducing tire inflation pressure
10. Hose to connect compressor and sealant bottle or compressor and
wheel
Connectors, cable and connection hose
are stored in the compressor housing.
WARNING
nExpired sealant
(Continued)
What to do in an emergency
8-16

WARNING
nCarbon monoxide
Carbon monoxide poisoning and suf‐focation is possible if the engine isleft running in a poorly ventilated orunventilated location (such as insidea building).
Distributing the sealant
11. Immediately drive approximately7~10 km (4~6 miles or, about 10
min) to evenly distribute the seal‐
ant in the tire.
CAUTION
Do not exceed a speed of 80 km/h(50 mph). If possible, do not fall be‐low a speed of 20 km/h (12 mph).While driving, if you experience anyunusual vibration, ride disturbanceor noise, reduce your speed anddrive with caution until you cansafely pull off of the side of theroad. Call for road side service ortowing.
(Continued)
(Continued)
When you use the Tire Mobility Kit,the tire pressure sensors and wheelmay be stained by sealant. There‐fore, remove the tire pressure sen‐sors and wheel stained by sealantand we recommend to have it in‐spected by an authorized Kia dealer.
Checking the tire inflation
pressure
0+')
1. After driving approximately 7~10 km (4~6 miles, or about 10
minutes), stop at a suitable loca‐
tion. 2. Connect connection hose (10) of
the compressor directly to the tire
valve.
3. Connect between compressor and the vehicle battery using the cable
and connectors.
4. Adjust the tire inflation pressure to 200 kPa (29 psi). With the ignition
switched on, proceed as follows. -
To increase the inflation pres‐sure: Switch on the compressor,
position I. To check the current
inflation pressure setting, briefly switch off the compressor.
WARNING
Do not let the compressor run formore than 10 minutes, otherwisethe device will overheat and may bedamaged.
-To reduce the inflation pressure:
Press the button (9) on the com‐
pressor.

8-19
8
What to do in an emergency