2017 CITROEN RELAY length

86
LOAd SPAcE FIttInGSSupport for stowing rail
Supports for securing a stowing rail are
available above the trims, on each side of
the vehicle.
Maximum load: 200 kg.
12 volt socket
Maximum power: 180 W.Lashing rings
Lashing rings are provided on the floor to
secure and make safe your loads: 8 for L1
and L2 length vehicles, 10 for L3 and
L4 length vehicles.
Two additional rings are located on the
partition behind the cab.
Maximum load: 500 kg.
Side trim
The lower parts of the sides are fitted with
load protection trims.
As a safety precaution in case of sharp
braking, you are advised to place
heavy objects as far forwards towards the
cab as possible.
Practical information

119
rEAr SEAt BELt S
The rear seats/bench seats are fitted with
three-point seat belts and inertia reels.
The centre seat has a seat belt guide and
inertia reel, solid with the seat back.
A carrier is provided at each outer seat to
allow the seat belt buckle to be secured
when not in use.
Good practice
The driver must ensure that passengers use
the seat belts correctly and that they are all
strapped in securely before moving off.
Wherever you are seated in the vehicle,
always fasten your seat belt, even for short
journeys.
The seat belts are fitted with an inertia reel
which automatically adjusts the length of the
strap to your size.
Do not use accessories (clothes pegs, clips,
safety pins, etc.) which allow the seat belt
straps to fit loosely.
You can unfasten the seat belt by pressing
the red button on the buckle. Guide the seat
belt after unfastening.
Ensure that the seat belt has reeled in
correctly after use.
After folding or moving a seat or a rear
bench seat, ensure that the seat belt has
reeled in correctly and that the buckle is
ready to accommodate the tongue.
The airbag warning lamp also
comes on if the pretensioners are
deployed. Contact a CITROËN
dealer or a qualified workshop.
In the event of an impact
Only for the front seats, and depending on
the nature and seriousness of the impact,
the pretensioning device may be deployed
before and independently of inflation of the
airbags. It instantly tightens the seat belts
against the body of the occupants.
Deployment of the pretensioners is
accompanied by a slight discharge of
harmless smoke and a noise, due to the
activation of the pyrotechnic cartridge
incorporated in the system.
The force limiter reduces the pressure of the
seat belt against the body of the occupants.
The pyrotechnic pretensioners are active
when the ignition is switched on and the
seat belt fastened.
The inertia reels are fitted with a device
which automatically locks the strap in the
event of a collision or emergency braking or
if the vehicle rolls over.
5
SAFEtY
Seat belts

135
rOOF cArrYIn G SYS t EMS
Refer to the "Technical data -
Dimensions" section for more
information on the length (L1 to L4) and the
height (H1 to H3) of the vehicle. Maximum load on the roof, evenly
distributed: 150 kg, for all versions,
within the vehicle's weight limit (Gross
Vehicle Weight).
For reasons of safety and to avoid damaging
the roof, it is essential to use a carrying
system (roof bars or roof rack) that is
approved for your vehicle.
Roof bars can only be fitted to an H1 or
H2

height van, combi and minibus versions.
On a minibus, check for the presence of roof
air conditioning units. The carrying system must always be
secured to the fitting points provided on the
vehicle's roof: 6, 8 or 10, depending on the
wheelbase of the vehicle.
Observe the instructions for fitting and use
provided with the carrying system.
On all H3 height versions, the roof
cannot be fitted with a carrying system.
Observe in full the legal requirements
related to carrying outsized loads.
6
transport solutions
AccESSOrIES

187
dIMEnSIOnS
The dimensions are given in millimetres.
This model is available in 4 lengths (L1...) and 3 heights (H1...); refer to the corresponding tables:VA
n
L1L2L3L4
H1 H2 H1 H2 H2 H3 H2 H3
L Overall length 4

9635
4135
9986
363
H Overall height 2
254 2 524 2 254 2 524 2 524 2 764 2 524 2 764
A Wheelbase 3
0003
4504
035
B Front overhang 948
cRear overhang1

0151
380
dOverall width (incl./excl. mirrors)2 508 / 2

050
E Width of front track 1
810
F Width of rear track 1
790
G Height of load floor 535 to 565
I Length of interior floor 2
6703
1203
7054
070
jMaximum interior load height1

662 1 932 1 662 1 932 1 932 2 172 1 932 2 172
K Maximum interior width 1
870
M Interior width between wheel arches 1
422
Volume (m
3) 89.5 10 11.5 13 15 15 17
9
TECHNICAL DATA
Dimensions

200
dIMEnSIOnS
The dimensions are given in millimetres.
c
HASSIS c AB
L1 L2L2S L3L4
L Overall length 4
9085
3585
7085
9436
308
A Wheelbase 3
0003
4503
8004
0354
035
B Front overhang 948
cRear overhang9601 325
dOverall width (incl./excl. mirrors) 2 508 / 2

050
- Body width 2
207
- Max permitted body width 2
350
E Front track 1
810
- Rear track 1
790
- Increased rear track 1
980
F Overall height 2
254
- Max permitted body height 3
500
chassis cab / Floor cab

202
dIMEnSIOnS
The dimensions are given in millimetres.FLOO r c AB
L1 L2L2S L3L4
L Overall length 5 2935 7436 0936 3286 693
A Wheelbase 3 0003 4503 8004 0354 035
B Front overhang 948
cRear overhang1 3451 710
dOverall width (incl./excl. mirrors) - / 2 100
- Body width -
- Max permitted body width -
E Front track 1 810
- Rear track 1 790
- Max permitted body width 1 980
F Overall height 2 153
- Max permitted body height -
chassis cab / Floor cab

206
dIMEnSIOnS
The dimensions are given in millimetres.
c
HASSIS cr EW c ABFLOO
r cr EW c AB
L3 L4L2L3L4
L Overall length 5 8436 2085 7386 2286 678
A Wheelbase 4 0353 4504 035
B Front overhang 948948
cRear overhang 8601 225 1 3401 2451 695
dWidth (with / without mirrors) 2 508 / 2 050- / 2 100
- Body width --
- Max permitted body width --
E Front track 1 8101 810
- Rear track 1 7901 790
- Increased rear track 1 9801 980
F Overall height 2 2542 153
- Max permitted body height --
double cab

211
tipper (in mm)
Load length 3 200
Overall length 3
248
Load width 2 000
Overall width 2 100
Height of body sides 350
Overall height 550
dIMEnSIOnS
This conversion is only available on the L2 single chassis-cab; refer to the table below for the characteristics of the tipper.
For information on the characteristics of the L2 chassis cab, refer to the "Dimensions" section for the floor cab version.
SPEcIAL FEAturES
10
tipper body