2017 BMW X5M Owners Manual

Transporting
children
safelyVehicle
features
and
optionsThis chapter describes all standard, country-specific and optional features offered with theseries. It also describes features that are notnecessarily available in your vehicle, e. g., dueto the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and systems, the applicable laws and regulations
must be observed.
The
right
place
for
children
Safety
information
WARNING
Unattended children or animals can
cause the vehicle to move and endanger themj selves and traffic, e.g., due to the following acj
tions:'yPressing the Start/Stop button.'yReleasing the parking brake.'yOpening and closing the doors or winj
dows.'yEngaging selector lever position N.'yUsing vehicle equipment.
There is a risk of accidents or injuries. Do not leave children or animals unattended in the vej
hicle. Take the remote control with you when exiting and lock the vehicle.'

Safety
informationWARNING
Active front-seat passenger airbags can
injure a child in a child restraint system when
the airbags are activated. There is a risk of inj
jury. Make sure that the front-seat passenger
airbags are deactivated and that the PASSENj GER AIRBAG OFF indicator lamp lights up.'

til the best possible belt guide position isreached.
Backrest
width Adjustable backrest width: before installing a
child restraint system in the front passenger
seat, open the backrest width completely. Do
not change the backrest width again and do
not call up a memory position.
Child
seat
security
The rear safety belts and the front passenger safety belt can be permanently locked to fasj
ten child restraint systems.
Locking
the
safety
belt1.Pull out the belt strap completely.2.Secure the child restraint system with the
safety belt.3.Allow the belt strap to be pulled in and pull it tight against the child restraint system.
The safety belt is locked.
Unlocking
the
safety
belt
1.Unbuckle the belt buckle.2.Remove the child restraint system.3.Allow the belt strap to be pulled in comj
pletely.
LATCH
child
restraint
fixing
system
General
information
LATCH: Lower Anchors and Tether for Chilj
dren.
Pay attention to the operating and safety inforj mation of the child restraint system manufacjturer when installing and using LATCH child
restraint fixing systems.
Mounts
for
the
lower
LATCH
anchors The lower anchors may be used to attach the
CRS to the vehicle seat up to a combined child and CRS weight of 65 lb/30 kg when the child
is restrained by the internal harnesses.Safety
information
WARNING
If the LATCH child restraint fixing sysj
tems are not correctly engaged, the protective
effect of the LATCH child restraint fixing sysj
tem can be limited. There is a risk of injuries or
danger to life. Make sure that the lower anj
chors are securely engaged and that the
LATCH child restraint fixing system fits sej curely against the backrest.'

bols. It is not recommended to use the innerlower anchors of standard outer LATCH posij
tions to fasten a child restraint system on the middle seat. Use the vehicle seat belt instead
for the middle seat.BMW X5 M:
Mounts for the lower LATCH anchors are loj
cated in the gap between the seat and backj
rest.
BMW X6 M:
Mounts for the lower LATCH anchors are loj
cated behind the seat cover between the backj
rest and the seat cushion.
Open the zipper to access the anchors.
Before
installing
LATCH
child
restraint
fixing
systems
Pull the safety belt away from the area of the
child restraint system.
Assembly
of
LATCH
child
restraint
fixing
systems
1.Install child restraint system, see manufacj
turer's information.2.Ensure that both LATCH anchors are propj erly connected.
Child
restraint
systems
with
tether
strap
Mounting
points The respective symbol shows the anjchor for the upper retaining strap.
Seats with an upper top tether are
marked with this symbol. It can be found on
the rear seat backrest or the rear window shelf.
Safety
information NOTE
The mounting points for the upper rej
taining straps of child restraint systems are only provided for these retaining straps. Whenother objects are mounted, the anchors can bedamaged. There is a risk of property damage.
Only mount child restraint systems to the upj per retaining straps.'

3Hook for upper retaining strap4Anchor5Seat backrest6Upper retaining strap
Attaching
the
upper
retaining
strap
to
the
anchor
1.Raise the head restraint, if needed.2.Guide the upper retaining strap between
the supports of the head restraint.3.If there is a retaining strap, run it between the backrest and the cargo cover.4.Attach the hook of the retaining strap tothe anchor.5.Tighten the retaining strap by pulling itdown.6.Lower and lock head restraints as needed.
BMW
X6
M:
retaining
strap
guide
WARNING
If the upper retaining strap is incorrectly
used for the child restraint system, the protecj tive effect can be reduced. There is a risk of injjury. Make sure that the upper retaining strap isnot guided across sharp edges and without
twisting to the upper retaining strap.'

Safety
switch
for
the
rearPress button on the driver's door.
The LED lights up if the safety funcj
tion is switched on.
This locks various functions so that they canj
not be operated from the rear.Seite 70ControlsTransporting
children
safely70
Online Edition for Part no. 01402978527 - II/17

DrivingVehicle
features
and
options
This chapter describes all standard, country- specific and optional features offered with theseries. It also describes features that are notnecessarily available in your vehicle, e. g., due
to the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and systems, the applicable laws and regulations
must be observed.
Start/Stop
buttonConcept Pressing the Start/Stop button
switches the ignition on or off
and starts the engine.
The engine starts with the brake
pedal pressed when you press
the Start/Stop button.
Ignition
on Press the Start/Stop button, and do not press
on the brake pedal at the same time.
All vehicle systems are ready for operation.
Most of the indicator/warning lights in the inj
strument cluster light up for a varied length of
time.
To save battery power when the engine is off,
switch off the ignition and any unnecessary
electronic systems/power consumers.
Ignition
off
Press the Start/Stop button again without
stepping on the brake.
All indicator lights in the instrument cluster go
out.To save battery power when the engine is off,
switch off the ignition and any unnecessary
electronic systems/power consumers.
Safety
measures
When switching off the ignition, the transmisj
sion position P is selected automatically if the
selector lever position D or R is selected.
The ignition is switched off automatically in the
following situations while the vehicle is stationj
ary and the engine is off:'yWhen locking the vehicle, and when the
low beams are switched on.'yShortly before the battery is discharged completely, so that the engine can still be
started.'yWhen opening or closing the driver door, if
the driver's safety belt is unbuckled and
the low beams are switched off.'yWhile the driver's safety belt is unbuckled with driver's door open and low beams off.'yWhen the front doors are opened if there is
no other person sitting in the front seats.
The low beams switch to parking lights after
some minutes of no use.
Radio-ready
state
General
information
In the radio-ready state, certain power conj sumers remain ready for operation.
ActivatingWith the engine running, press the Start/Stop
button.
If the engine is not running and the ignition is switched on: the system automatically actijvates radio-ready state when the door is
opened if the lights are switched off or the dayj
time running lights are switched on.
Seite 71DrivingControls71
Online Edition for Part no. 01402978527 - II/17

The radio-ready state remains active if, for inj
stance the ignition is automatically switched
off for the following reasons:'yOpening or closing the driver's door.'yUnfastening of the driver's safety belt.'yWhen automatically switching from low
beams to parking lights.
Switching
off
automatically
The radio-ready state is switched off automatijcally in the following situations:
'yIf the driver's or front passenger door isopened when exiting the vehicle, with the
engine switched off manually.'yIf the ignition is switched off manually with
the Start/Stop button.'yAfter approx. 8 minutes.'yWhen the vehicle is locked using the cenj
tral locking system.'yShortly before the battery is discharged completely, so that the engine can still be
started.
Starting
the
engine
Safety
information DANGER
If the exhaust pipe is blocked or ventilaj
tion is insufficient, harmful exhaust gases can enter into the vehicle. The exhaust gases conjtain pollutants which are colorless and odorj
less. In enclosed areas, exhaust gases can also
accumulate outside of the vehicle. There is
danger to life. Keep the exhaust pipe free and ensure sufficient ventilation.'