co
co
.... N
" N .... 0
00
\.J '
General information
Breaking in
A new vehicle must be broken in, and the break
in distance should be 1,000 mi les ( 1,500 km). Do
not drive at speeds that w ill exceed
2/3 of the
maximum permitted engine speed
(RPM) for the
first 600 miles (1,000 km) , and avoid full accel
eration during this period . You may gradually
start increasing the
RPM and the speed between
600 miles (1,000 km) and 1,000 miles (1,500 km).
During the first hours of use, the engine has a
higher internal friction than later on when all
moving parts have settled into place with each
other.
How the vehicle is driven during the first 1,000
miles (1,500 km) also affects the engine quality.
Drive at moderate engine speeds after the initial
break-in per iod, part icularly when running a cold
engine . This will reduce engine wear and improve
the mileage .
Do not drive at too
low of an engine speed (rpm).
Shift down if the engine stops running "smooth ly" . Extremely high eng ine speeds are automati
cally reduced .
New tires
If your vehicle is running on new tires, drive pa r
ticularly careful for the first 350 miles (500 kilo
meters) after fitting .
.&_ WARNING
-
New tires tend to be slippery and must also
be "broken-in". Be sure to remember this dur
ing the first 350 miles (500 kilometers).
Brake gently . Avo id following closely behind
other vehicles or other situations that might
require sudden, hard brak ing.
Avoid damaging the vehicle
When you are driving on poor roads, or over
curbs, steep ramps, etc., make certain that low-
D riving
lying parts such as spoilers and exhaust system
parts do not bottom out and get damaged .
T h is is espec ially true for veh icles with low-slung
chass is (sports chassis)* and fully loaded
vehicles.
Warming up/cooling down
Appl ies to: Sand RS models
By warming up/cooling down the engine careful
ly, you can he lp reduce unnecessary strain on
your vehicle when driving in a sporty style.
The engine speed is limited when the engine is
cold -the full engine output is not available.
When the engine is at operat ing temperature,
the engine speed limitation moves to a higher
RPM range. The tires also only reach their full
road holding capab ility once they have warmed
up .
Your vehicle also has an after-run cooling fea
ture . However, cooling down is still important.
The engine and the brakes as well as the exhaust
system and the transmission become very hot
when driving in a spo rty style . Before you shut
the vehicle off, you should cool down the vehicle
by driving a few miles at low speeds with light ac
celeration.
Driving through water on roads
Note the following to reduce the risk of vehicle
damage when driving through water, for example
on flooded roads:
- The water must not be any higher than the bot
tom of the vehicle body .
- Do not drive faste r than walking speed.
.&_ WARNING
= -
After driving through water or mud, the effec-
tiveness of the brakes may be reduced due to
moisture on the brake rotors and brake pads.
A few careful brake applications should dry
off the brakes .
(D Note
-Vehicle components such as the engine,
transmission, suspens ion or electrical
65
co
co
.... N
" N .... 0
00
\.J '
functionality and s ervice life of the engine. Your
engine was factory-filled with a high -quality oil
which can usually be used throughout the entire
yea r.
Note
Your Limited New Vehicle Warranty does not
cover damage or malfunctions d ue to failure
to follow rec ommended maintenance and use
requireme nts as s et forth in the Audi Owner's
Manual and Warranty & Maintenance booklet .
- Use only a high quality engine oi l that ex-
pressly complies with the Au di oil quality
standard specified for your vehicle's engine.
Using any o ther oil can cause serious engine
damage.
- Do not mix any lubricants o r other additives
into the engine oil. Doing so can cause en
gine damage.
@ Tips
If you need to add oil and there is none availa
ble that meets the Audi o il quality standard
your eng ine requ ires, you may add a total of
no more than 0 .5 qt (0.5 l) of a h igh-quali ty
"synthet ic"oil that meets the following speci
fications.
- Applies to: gaso line engine: ACEA A3 or
API SM with a viscosity grade of SAE OW-30,
SAE 5W-30 or SAE 5W-40.
- Applies to: diesel engine: ACEA C3 or API CF
with a viscosity grade of SAE OW-30 o r
SAE 5W-30 .
- For more information about engine oil that
has been approved for your vehicle, please
contact e ither your authori zed Audi dea ler
or Audi Customer Relat ions at
1 (800) 822-2834 or visit our web site at
www .audiusa .com or www .aud ica nada.ca.
Engine oil consumption
The engine in your vehicle depends on an ade
quate amount of oil to lubricate and cool all of
its moving parts .
In order to provide effective lub rication and cool
ing of in ternal engine componen ts, all internal
Ch eck ing and Filling
combustion engines consume a certain amo unt
of oil. Oil consumption vari es from engin e to en
gine and may change s ignificantly over the life of
the engine . Typ ically, engines w ith a specified
break-in period (see¢
page 65) consume mo re
o il during the break -in per iod than they consume
after o il consumption has stab il ized .
Under normal cond itions, the rate of oil con
sump tion depends on the qu ality and viscos ity of
the oil, the RPM (revolutions per minute) at
wh ich the engine is operated, the amb ient tem
perature and road co ndit ions. Further facto rs a re
the amount of oi l di lution from wate r condensa
tion or fuel resid ue and the oxidat ion level of the
o il. As any engine is subject to wear as mileage
builds up, the oil consumption may increase over
time unti l replac ement of worn components may
become necessary.
With a ll these variab les coming into play, no
standard rate of oil consumption can be estab
li sh ed or sp ecified . There is no alternative to reg
u lar and frequent checking of the oi l level, see
Note .
If the yellow engine oil leve l warning symbo l in
the instr ument cluster
Ill lights up, yo u should
check the oi l level as soon as possible
¢
page 204. Top off the o il at your earliest con
venience ¢
page 204 .
A WARNING
-Before you check anyt hing in the engine com -
partment, always read and heed all WARN
INGS
¢ .&. in Working in the engine compart
ment on page 199.
{(D Note
Driving w it h an insufficient oil level is likely to
cause severe damage to the eng ine .
(D Tips
-The oil pressure wa rn ing display. is not
an indicator of the o il leve l. Do not rely on
i t . Instead, check th e oil level in your en
gine at regular interval s, preferably each
time you refuel, and alway s before going
on a long trip .
203