Universal Garage Door Opener (HomeLink)
Programming HomeLink........220, 221, 223, 225
Unleaded Gasoline........................674
Untwisting Procedure, Seat Belt................60
Utility Rails, Rear Cargo Area................270
Vehicle Identification Number (VIN).............6
Vehicle Loading.......................643, 686
Vehicle Modifications/Alterations...............7
Vehicle Storage........................442, 848
Viscosity, Engine Oil....................797, 798
Voice Recognition System (VR)................445
Warnings And Cautions......................6
Warranty Information......................885
Washers, Windshield....................186, 811
Washing Vehicle..........................831
Water
Driving Through........................589Wheel And Wheel Trim.....................833
Wheel And Wheel Trim Care.................833
Wheel Cover............................768
Winch.................................593
Accessories............................597
Operation.............................598
Rigging Techniques......................611
Usage...............................593
Wind Buffeting........................51, 231
Window Fogging.........................442
Windows................................48
Power................................48
Rear Sliding...........................251
Reset Auto-Up..........................50
Wind Buffeting..........................51
Windshield Defroster.......................119
Windshield Washers.................185, 186, 811
Fluid.............................185, 811
Windshield Wiper Blades....................808
10
INDEX 911
Windshield Wipers........................185
Wiper Blade Replacement...................808
Wipers, Intermittent.......................185
Wipers, Rain Sensitive......................187
912 INDEX
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.