Page 326 of 607

324
Traveller-VP_en_Chap09_caracteristiques-techniques_ed01-2016
engines
Engine characteristics
The engine characteristics (capacity, 
maximum power, maximum power speed, fuel, 
Co
2 emissions...) for your vehicle are given in 
t
he registration document, as well as in sales 
brochures.
These characteristics correspond to the 
values type-approved on a test bed, under 
conditions defined in 
e
u
 ropean legislation 
(Directive
 
1999/99/
eC
 ).
For more information, contact a P
e
ugeo
T 
d
ealer or a qualified workshop.
Weights
The kerb weight is equal to the unladen 
weight   + driver (75 kg).
The 
g
T
 W and towed load values indicated 
apply up to a maximum altitude of  
1 000
  metres; the towed load mentioned must 
be reduced by 10 % for every additional  
1 000 metres.
The weight of the braked trailer can be 
increased, within the 
g
T
 W limit, on condition 
that the 
g
V
 W of the towing vehicle is reduced 
by the same amount.
The recommended nose weight is the vertical 
load on the towbar ball (removable with or 
without tools). High ambient temperatures may result 
in a reduction in the per formance of the 
vehicle to protect the engine; when the 
ambient temperature is higher than  
37 °C, limit the towed weight.
If the ambient temperature is high, it 
is recommended that the engine be 
allowed to idle for 1 to 2 minutes after 
the vehicle comes to a stop, to facilitate 
its cooling. Towing with a lightly loaded vehicle can 
adversely affect roadholding.
Braking distances are increased when 
towing a trailer.
Never exceed 60 mph (100 km/h) when 
towing (comply with the legislation in 
force in your country).
GV W :
 gross vehicle weight, the maximum authorised vehicle weight.
GTW : gross train weight, the maximum authorised weight of vehicle 
plus trailer.
Weights and towed  
loads
The maximum weights and towed loads for your 
vehicle are given are given in the registration 
document, as well as in sales brochures.
These values are also present on the 
manufacturer's plate or label.
For more information, contact a P
e
ugeo
T 
d
ealer or a qualified workshop. 
Technical data  
         
        
        
     
        
        Page 327 of 607
325
Traveller-VP_en_Chap09_caracteristiques-techniques_ed01-2016
euRo 6 Diesel engines
* Increased payload.Engine
Engine 
code Gearbox Engine oil capacity with 
filter replacement   (litres) LengthUnbraked trailer 
weight (kg)  
 8-9 seats Trailer nose  
weight (kg)  
 8-9 seats
1.6 litre 
BlueHDi 95 BHV 
(DV6FD
u) M
 anual
(5-speed) 5.6L1, L2, L3
75072
L 2 *, L 3 * 80
1.6 litre 
BlueHDi 95  S&S BHS 
(DV6FD
u)
eTg6
  
electronic (6-speed) 5.6L1, L2, L3
72
L 2 *, L 3 * 80
1.6 litre 
BlueHDi 115  S&S BHX
(DV6FC
u
 )
Manual
(6-speed) 5.6L1, L2, L3
72
L 2 *, L 3 * 80
9 
Technical data  
         
        
        
     
        
        Page 328 of 607
326
Traveller-VP_en_Chap09_caracteristiques-techniques_ed01-2016
* Increased payload.Engine
Engine 
code Gearbox Engine oil capacity with 
filter replacement   (litres) LengthUnbraked trailer 
weigt (kg)  
 8-9 seats Trailer nose
 
weight  (kg) 
 8-9 seats
2 litre BlueHDi   
150 S&SAHX
(DW10FD) Manual
(6-speed) 6 .1L1, L2, L3
75092
L 2 *, L 3 * 10 0
2 litre BlueHDi 
180 S&SAHH
(DW10 FC)eAT 6  
automatic (6-speed) 5 .1L1, L2, L3
80
L 2 *, L 3 * 88 
Technical data  
         
        
        
     
        
        Page 334 of 607
332
FM/87.5 MHz
87.5MHz12:13
23 °C 87.5 MHz
Traveller-VP_en_Chap10b_NAC-1_ed01-2016
First steps
With the engine running, a press 
mutes the sound.
With the ignition off, a press turns the 
system on.
Volume.us e the buttons either side of the touch screen 
for access to the menus, then press the virtual 
buttons in the touch screen. All of the touch 
areas of the screen are white.
ea
ch menu is displayed in one or two pages 
(primary page and secondary page).
Secondary page
Primary page The touch screen is of the "capacitive" 
type.
To clean the screen, use a soft,  
non-abrasive cloth (spectacles cloth) 
with no additional product.
Do not use sharp objects on the 
screen.
Do not touch the screen with wet 
hands. 
Audio and Telematics  
         
        
        
     
        
        Page 420 of 607

418
Traveller-VP_en_Chap10b_NAC-1_ed01-2016
QUESTIONANSWER SOLUTION
There is a difference in 
sound quality between the 
different audio sources. For optimum sound quality, the audio settings for Loudness, 
Ambience, Treble, Bass and Volume can be adapted to the different 
sound sources, which may result in audible differences when 
changing source. Check that the audio settings for Loudness, 
Ambience, Treble, Bass and Volume are adapted 
to the sources listened to. Adjust the Balance, 
Treble and Bass to the middle position, select the 
"None" musical ambience and set the loudness 
correction to the "Active" position in CD mode or 
to the "Inactive" position in radio mode.
With the engine off, the 
system switches off after a 
few minutes of use. When the engine is switched off, the system's operating time 
depends on the state of charge of the battery.
The switch-off is normal: the system switches to economy mode 
and switches off to prevent discharging of the vehicle's battery. Start the vehicle's engine to increase the battery 
charge. 
Audio and Telematics  
         
        
        
     
        
        Page 422 of 607
420
Traveller-VP_en_Chap10c_RCC-1_ed01-2016
First steps
With the engine running, a press 
mutes the sound.
With the ignition off, a press turns the 
system on.
Volume.use the buttons either side of the touch screen 
for access to the menus, then press the virtual 
buttons in the touch screen. All of the touch 
areas of the screen are white.
ea
ch menu is displayed in one or two pages 
(primary page and secondary page).
Secondary page
Primary page The touch screen is of the "capacitive" 
type.
To clean the screen, use a soft, non-
abrasive cloth (spectacles cloth) with 
no additional product.
Do not use sharp objects on the 
screen.
Do not touch the screen with wet 
hands. 
Audio and Telematics  
         
        
        
     
        
        Page 474 of 607

472
Traveller-VP_en_Chap10c_RCC-1_ed01-2016
QUESTIONANSWER SOLUTION
There is a difference in 
sound quality between the 
different audio sources. For optimum sound quality, the audio settings for Loudness, 
Ambience, Treble, Bass and Volume can be adapted to the different 
sound sources, which may result in audible differences when 
changing source. Check that the audio settings for Loudness, 
Ambience, Treble, Bass and Volume are adapted 
to the sources listened to. Adjust the Balance, 
Treble and Bass to the middle position, select the 
"None" musical ambience and set the loudness 
correction to the "Active" position in CD mode or 
to the "Inactive" position in radio mode.
With the engine off, the 
system switches off after a 
few minutes of use. When the engine is switched off, the system's operating time 
depends on the state of charge of the battery.
The switch-off is normal: the system switches to economy mode 
and switches off to prevent discharging of the vehicle's battery. Start the vehicle's engine to increase the battery 
charge. 
Audio and Telematics  
         
        
        
     
        
        Page 475 of 607
473
Traveller-VP_en_Chap10d_RD6_ed01-2016
Bluetooth® audio system
Contents
First steps
 4 74
Steering mounted controls - Type 1
 
4
 75
Steering mounted controls - Type 2
 
4
 76
Menus
 47
7
Radio
 
478
DAB (Digital Audio Broadcasting) radio
 
4
 80
Media
 4
82
Telephone
 
487
Frequently asked questions
 49
2
Your audio system is coded in such a way that it will only operate 
in your vehicle. The different functions and adjustments described vary 
according to the version and configuration of your vehicle. As a safety measure and because it requires the sustained 
attention of the driver, the pairing of your Bluetooth telephone to 
the Bluetooth hands-free audio system must only be carried out 
with the vehicle stationary
 and the ignition on.
To avoid discharging the battery, the audio system may switch 
off after a few minutes if the engine is not running.
. 
Audio and Telematics