2016 Peugeot 508 battery

258
508_en_Chap08_en-cas-de-pannes_ed01-2016
Removal
- Disconnect the positive (+) terminal from
the battery. -
R emove the battery cover 1.- Release 2 then disconnect the negative ( -)
terminal from the battery.
-


u
nc
lip the wiring harnesses 3.
-
u
n
clip and move aside the wiring
harness


4.
-

R
emove the nut 5 from the positive (+)
cable.
-

M
ove aside wiring harness 6.
In the event of a breakdown

259
508_en_Chap08_en-cas-de-pannes_ed01-2016
- using a screwdriver, unclip the clips 7 and 8.
-

R
aise the power shut-off unit 9 .
-

M
ove this unit for ward out of the way. -
un clip the clips.
- R emove the battery cover 10.-
us ing a screwdriver, lever the fixing 11

aside and remove the battery.
8
In the event of a breakdown

260
508_en_Chap08_en-cas-de-pannes_ed01-2016
Refitting
to reassemble, carry out the removal
operations in reverse order, connecting the
positive (+) terminal last.
After refitting
- Check that the battery terminals are secure.
-

S
witch on the ignition, without starting the
engine.
-

C
heck that there are no error messages or
warning lamps on. If necessary contact a
P
e

uge
Ot
dealer or a qualified workshop
to have the system reset.
-

C
heck the correct operation of all doors
and windows.
-

A
fter refitting, wait around 1 minute (or
2
minutes for an automatic gearbox).
-

S
tart the engine.
-

C
heck the correct operation of anti-pinch
systems: electric windows, opening roof,
panoramic sunroof. -

I
f the vehicle has an electric parking
brake, check that it is working correctly by
releasing and applying it.
-
S
witch the ignition off.
- g
e
t out of the vehicle then check that the
remote control works correctly.
-
S
et: the time, the preset radio stations and
the audio settings.
After refitting the battery, some systems
may be temporarily unavailable:
Stop (Stop & Start), Air conditioning,
Navigation.
In all cases, contact a P
e

uge
Ot
dealer
or a qualified workshop if there are any
faults after refitting the battery.
In the event of a breakdown

261
508_en_Chap08_en-cas-de-pannes_ed01-2016
System which manages the duration of use of certain functions to conserve a sufficient level of
charge in the battery.
After the engine has stopped, you can still use functions such as the audio and telematics
system, windscreen wipers, dipped beam headlamps, courtesy lamps, etc. for a maximum
combined duration of about forty minutes.
energy economy mode
Switching to economy
mode
A message then appears in the instrument
panel screen indicating that the vehicle has
switched to economy mode and the active
functions are put on standby.
If a telephone call is being made at this time, it
will be maintained for around 10 minutes with
the Bluetooth hands-free system of your audio
system.
Exiting economy mode
these functions are reactivated automatically
next time the vehicle is driven.
In order to restore the use of these functions
immediately, start the engine and let it run:
-

f
or less than ten minutes, to use the
equipment for approximately five minutes,
-

f
or more than ten minutes, to use the
equipment for up to approximately
thirty


minutes.
Let the engine run for the duration specified to
ensure that the battery charge is sufficient.
Do not repeatedly and continuously restart the
engine in order to charge the battery.
A flat battery prevents the engine from starting.
For more information on the battery, refer to the
corresponding section.
Load reduction mode
System which manages the use of certain
functions according to the level of charge
remaining in the battery.
When the vehicle is being driven, the load
reduction function temporarily deactivates
certain functions, such as the air conditioning,
the heated rear screen...
th

e deactivated functions are reactivated
automatically as soon as conditions permit.
8
In the event of a breakdown

275
508_en_Chap10a_BtA_ed01-2016
PEUGEOT Connect Assistance
If you purchased your vehicle outside
the Pe
ugeOt dealer network, we
invite you to have a dealer check the
configuration of these services and, if
desired, modified to suit your wishes.
In a multi-lingual country, configuration
is possible in the official national
language of your choice.
For technical reasons and in particular
to improve the quality of "P
e

uge
Ot

CONN
eCt

services" services to
customers, the manufacturer reserves
the right to carry out updates to the
vehicle's on-board telematic system.
A fault with the system does not
prevent the vehicle being driven. Press this button for more than
2

seconds to request assistance
if the vehicle breaks down.
A voice message confirms that
the call has been made**.
Pressing this button again immediately cancels
the request.
th

e cancellation is confirmed by a voice
message.
th

e orange L
eD i

s on continuously: the backup
battery must be replaced.
In either case, the emergency and assistance
calls may not function.
Contact a qualified repairer as soon as
possible.
Operation of the system
When the ignition is switched
on, the green LeD c omes on for
3 seconds indicating that the
system is operating correctly.
If the orange L
eD f

lashes then
goes off: there is a system fault.
**
Depending on the geographical cover of
"PeugeOt Connect SOS", "Pe ugeOt
Connect Assistance" and the official national
language selected by the owner of the vehicle.
the list of countries covered and Pe ugeOt
CONNeCt services is available from dealers
or at www.peugeot.co.uk.
.
Audio and telematics

334
508_en_Chap10c_SMegplus_ed01-2016
QUESTIONANSWER SOLUTION
th

ere is a difference in
sound quality between the
different audio sources. For optimum sound quality, the audio settings for Loudness,
Ambience,
t
r
eble, Bass, Volume can be adapted to the different
sound sources, which may result in audible differences when
changing source. Check that the audio settings (Loudness,
Ambience,
t
r
eble, Bass, Volume) are adapted to
the sources listened to. Adjust Balance,
t
r
eble
and Bass to the middle position, select the
"None" musical ambience and set the loudness
correction to the "Active" position in CD mode or
to the "Inactive" position in radio mode.
With the engine off, the
system switches off after a
few minutes of use. When the engine is switched off, the system's operating time
depends on the state of charge of the battery.
th

e switch-off is normal: the system switches to economy mode and
switches off to prevent discharging of the vehicle's battery. Start the vehicle's engine to increase the battery
charge.
Audio and telematics

337
508_en_Chap10d_RD5_ed01-2016
Audio system
Contents
First steps
3 38
Steering mounted controls

3
39
Menus

3
40
Audio
340
Media
343
Audio settings
3

47
Screen menu map(s)

3
48
Frequently asked questions
3

49
As a safety measure, the driver must only carry out operations
which require sustained attention with the vehicle is stationary.
th

e audio system may switch off a few minutes after switching
off the engine, to avoid discharging the battery.
th

e system is coded in such a way that it will only operate in your
vehicle.
.
Audio and telematics

352
508_en_Chap10d_RD5_ed01-2016
QUESTIONANSWER SOLUTION
th

e hard disk or device
is not recognised when
connecting to the
u
S
B
port. Some hard disks and devices need a power supply greater than is
provided by the audio system.
Connect the device to the 230 V socket, the 12 V
socket or an external power supply.
Caution:
ensure that the device does not transmit
a voltage greater than 5 V (risk of destruction of
the system).
In "Random all" play, not all
of the tracks are played. In "Random all" play, the system can only take into account up to
999 tracks.
With the engine off, the
audio system switches off
after a few minutes of use. When the engine is switched off, the audio system operating time
depends on the battery charge.
th

e switch-off is normal: the audio system switches to economy
mode and switches off to prevent discharging the vehicle's battery. Start the vehicle's engine to increase the battery
charge.
th

e message "the audio
system is overheated"
appears on the display. In order to protect the installation if the surrounding temperature
is too high, the audio system switches to an automatic thermal
protection mode leading to a reduction of the volume or stopping of
the playing of the CD. Switch the audio system off for a few minutes to
allow the system to cool.
Audio and telematics