2016 Peugeot 508 Hybrid ignition

32
Driving
508HY-comp _en_Chap06_conduite_ed01-2016
Engagement of reverse gear is accompanied by an audible signal.
If the HYbrid4 system does not activate: - If N is flashing in the instrument panel, move the gear selector to position A then to position N . - If the message "Foot on brake" is displayed, press the brake pedal f i r m l y.
For optimum acceleration, for example when overtaking another vehicle, press the accelerator pedal firmly past the point of resistance.
Displays in the instrument panel
N Neutral R Reverse 1, 2, 3, 4, 5, 6 Gears in manual mode A This comes on when automated mode is selected. It goes off on changing to manual mode.
 Place your foot on the brakewhen a message appears in the instrument panel screen.
M o v i n g o f f
 To start the engine, place the gear selector in position N .
 Select a drive mode (position A or M ) or reverse (position R ). R ). R
 Release the parking brake by pulling the control lever, if automatic operation has been deactivated.  Progressively release the brake pedal.  If the parking brake is released, the vehicle moves off. If the parking brake is applied and automatic mode is activated, accelerate progressively.
A appears in the instrument panel screen.
The gearbox is then operating in auto-active mode, without any action on the part of the driver. It continuously selects the most suitable gear, depending on the: - style of driving, - profile of the road.
Before leaving the vehicle, place the gear selector in position N and then you must stop the HYbrid4 system by switching off the ignition ( RE ADY lamp RE ADY lamp RE ADY
off).
 Press the brake pedal down fully.  Start the HYbrid4 system.
Automated mode
 After starting the vehicle, select position Afor enter automated mode.
A or M1 or R appears in the instrument panel screen.

34
Driving
508HY-comp _en_Chap06_conduite_ed01-2016
To immobilise the vehicle without applying the parking brake, before switching off the ignition, place the gear selector in position A or R . If the battery is flat, it is essential to place a chock against one of the wheels to immobilise the vehicle.
Stopping the vehicle
Before switching off the HYbrid4 system, place the gear selector in position N. When switching off the HYbrid4 system, the electric parking brake is applied automatically. If the automatic function is deactivated, apply the parking brake manually to immobilise the vehicle.
Operating fault
Creep function
This function facilitates manoeuvring of the vehicle at low speed (when parking, in traffic jams, …). With the HYbrid4 hybrid system active, the vehicle stationary and the parking brake released:  press the brake pedal,  place the gear selector in position A , Ror M ,  gradually release the brake pedal. The vehicle moves off immediately and gradually reaches a speed of approximately 6 mph (10 km/h), with pressing the accelerator pedal.
Never leave children unsupervised in the vehicle with the HYbrid4 system active.
For your safety, this function will only be activated if you press the brake pedal when engaging forward drive or reverse. This function is deactivated if the driver's door is opened. To reactivate it, close the door and then press the brake or accelerator pedal.
Have it checked by a PEUGEOT dealer or a qualified workshop.
With the ignition on, the flashing of this warning lamp, accompanied by an audible signal and a message in the instrument panel screen, indicates a malfunction of the gearbox.
Before leaving the vehicle, check that the parking brake lamps are on (not flashing) in the instrument panel and in the control lever.

35
7
Practical information
508HY-comp _en_Chap07_info-pratiques_ed01-2016
Car washing machine or tunnel
With the HYbrid4 system active, RE ADY lamp on, parking brake RE ADY lamp on, parking brake RE ADYreleased:  Place the gear selector in position N .  Switch off the engine (press the START/STOP button or with the vehicle's key if it does not have Keyless Entry and Starting). The parking brake is applied automatically and the RE ADY lamp goes off in the instrument panel. RE ADY lamp goes off in the instrument panel. RE ADY Switch on the ignition again (press the START/STOP button
or with the key in the intermediate position) without your foot on the brake pedal. The RE ADY lamp remains off. RE ADY lamp remains off. RE ADY Release the parking brake using the manual control on the centre console, while keeping your foot on the brake pedal.  Switch off the ignition (press the START/STOP button without your foot on the brake pedal, or using the key) after checking that the parking brake remains released.
With the HYbrid4 system active, RE ADY lamp on, parking brake RE ADY lamp on, parking brake RE ADYreleased:  Place the gear selector in position N ( AUTO m o d e).  Press the brake pedal then the ECO OFF button.
If the HDI Diesel engine was on standby, it then restarts. If the HDi Diesel engine is running, its operation is maintained without time limit.
Car washing machines or tunnels in which the HDi Diesel engine must be switched off. Car washing machines or tunnels in which the HDi Diesel engine must not be switched off.
Some car washing machines or tunnels (where the vehicle is moved for wards on a travelling track) require that the parking brake be "released" during the wash. If possible on your vehicle, deactivate the automatic operation of the electric parking brake via the vehicle equipment configuration menu.

38
In the event of a breakdown
508HY-comp _en_Chap08_en-cas-de-pannes_ed01-2016
Recovery of the vehicle on a fl at-bed
Never recover the vehicle by towing it with two or four wheels on the ground, as there is a risk of damage to the transmission. However, if necessary because access to the vehicle is difficult, the vehicle can be moved a few dozen metres, at a speed of less than 6 mph (10 km/h). Before doing any work, with the ignition on, press the brake pedal and place the gear selector at position N , then switch off the HYbrid4 system ( RE ADY lamp off). RE ADY lamp off). RE ADY Always call on professionals for recovery of the vehicle on a flat-bed lorry or trailer.
Use the towing eye only to pull the vehicle out or to lash it for recovery on a flat-bed lorry or t r a i l e r.
The towing eye is stowed in the storage well behind the rear seats.  Fold the 2/3 part of the rear seat for access to it.  Raise the cover of the storage well.
Access to the tools

39
8
In the event of a breakdown
508HY-comp _en_Chap08_en-cas-de-pannes_ed01-2016
Removing / Refi tting the 12 V battery
This procedure allows you to safely remove the 12 V battery, when needed to change a left hand headlamp bulb.
You can contact a PEUGEOT dealer or a qualified workshop to have this done.
Before removing
 Place the vehicle in a ventilated area, with free access and preferably on level ground.  Apply the parking brake.  Place the gear selector in position N .  If the vehicle has an alarm, leave the bonnet open to avoid triggering the alarm.  Leave at least one window open if parking in a secure area, other wise lock all doors and the boot.  If your vehicle has a motorised tailgate, it will not be possible to open it after disconnecting the battery.  Switch of the ignition and remove the key.  If your vehicle has Keyless Entry and Starting, place the remote control at least 3 metres away.  Wait around 6 minutes before disconnecting the battery.
R e m o v i n g
 Disconnect the positive ( + ) terminal of the + ) terminal of the +battery.

42
In the event of a breakdown
508HY-comp _en_Chap08_en-cas-de-pannes_ed01-2016
R e f i t t i n g
To refit the battery, carry out the removal operations in reverse order and connect the positive (+) terminal last.
After refitting
 Check that the battery terminals are secure.  Switch on the ignition, without starting the engine.  Check that there are no error messages or warning lamps on. If there is any problem, contact a PEUGEOT dealer or a qualified
workshop to have the system reset.  Check the correct operation of all openings: doors, boot and windows.  After refitting, wait for about 2 minutes.  Start the engine.
 Check the correct operation of the anti-pinch systems: electric windows and panoramic sunroof.  Check the correct operation of the electric parking brake by releasing and applying it again.  Switch off the ignition.  Get out of the vehicle and check the operation of the remote control.  Set: the time, the radio preset stations and the audio settings.
After reconnecting the battery, certain functions may be temporarily
unavailable: air conditioning, navigation.
In all cases, if there is a problem, contact a PEUGEOT dealer or a
qualified workshop.

51
.
Alphabetical index
508HY-comp_en_Chap14_index-alpha_ed01-2016
Accessory position .........................................16Advice on driving ............................................22Air conditioning .........................................21, 24
Battery, 12 V ................................................5, 39Battery, high voltage .......................5, 26 -28, 43
Cable, high voltage .........................................27Car wash .........................................................35Cooling, high voltage battery ..........................28
Demisting/defrosting .......................................24Dimensions .....................................................46Display screen, instrument panel ...........7, 9, 12Driving economically.......................................23
Filter, particle ..............................................5, 25Fittings, boot ...................................................30Flat bed (recovery) ..........................................38Four-wheel drive (4WD) ......................18, 22, 36Fuel consumption ..................................8, 11, 23
AE
B
C
D
F
Gearbox, electronic ...................5, 14, 22-24, 31Gear lever, electronic gearbox .......................31Ground clearance ...........................................46
Head-up display ..............................................15Heating ......................................................21, 24High voltage ..............................................26, 27Histogramme, fuel consumption .....................11
G
H
Ignition on........................................................16Ignition switch .................................................14Instrument panel ...............................................7
I
Key, electronic ...........................................14, 18Keyless Entry and Starting .................14, 16, 18Key not recognised .........................................18Key with remote control ..................................14Kit, temporary puncture repair ........................Kit, temporary puncture repair ........................Kit, temporary puncture repair37
K
Eco-driving .....................................................23ECO OFF (switch) ...........................................21Electric running (ZEV) ............10, 18, 21, 23, 24Emergency switching off .................................Emergency switching off .................................Emergency switching off17Energy flows ...............................................9, 10Energy recovery ....................................8, 10, 23Engine compartment ......................................29Engine, Diesel .....................5, 18, 21, 24, 35, 44Environment ....................................................23