2016 NISSAN NOTE drain bolt

OIL PAN, CONTROL VALVETM-243
< REMOVAL AND INSTALLATION > [CVT: RE0F11A]
C
EF
G H
I
J
K L
M A
B
TM
N
O P
2. Disconnect the CVT unit harness connector.
3. Remove the drain plug and overflow tube, and then drain the CVT fluid. CAUTION:
Use caution when looking into the drain hole as there is the risk of fluid entering the eye.
4. Remove the drain plug gasket from the drain plug.
5. Remove the oil pan mounting bolts ( ), and then remove the oil pan and oil pan gasket.
6. Remove the magnets from the oil pan.
7. Remove the strainer bolts , and then remove the strainer from the control valve.
8. Remove the nut and washer , and then remove manual plate .
CAUTION:
To remove nut, fix manual plat e with flat-blade screwdriver
(B).
9. Press the CVT unit harness connector into the transaxle case. CAUTION:
Never damage the CVT unit harness connector.
NOTE:
Clean around the CVT unit harness connector to prevent foreign
materials from entering into the transaxle case.
10. Remove the control valve bolts , and then remove the control valve from the transaxle case.
CAUTION:
• Never drop the control valve and manual valve.
:Vehicle front
JSDIA1874ZZ
JSDIA6594ZZ
JSDIA6595ZZ
JSDIA6598ZZ
Revision: August 2015 2016 Versa Note

cardiagn.com

OIL PAN, CONTROL VALVETM-245
< REMOVAL AND INSTALLATION > [CVT: RE0F11A]
C
EF
G H
I
J
K L
M A
B
TM
N
O P
4. Install the strainer , and then tighten the strainer bolts to the specitied torque.
5. Install oil pan (with oil pan gasket) to transaxle case and tempo- rarily tighten oil pan bolts ( ).
CAUTION:
Never reuse oil pan gasket.
6. Tighten the oil pan bolts to specification in the order shown.
7. Tighten the overflow tube to the specitied torque. CAUTION:
If it is not tightened to the specified torque, the tube may be
damaged.
8. Connect the CVT unit harness connector.
9. Connect battery negative terminal.
10. Fill with CVT fluid from overflow tube to the specified level. Refer to TM-228, "
Replacement".
11. Install the drain plug and drain plug gasket to oil pan. CAUTION:
Never reuse drain plug gasket.
Inspection and AdjustmentINFOID:0000000012431194
INSPECTION AFTER REMOVAL
Check oil pan for foreign material.
• If a large amount of worn material is found, clutch plate may be worn.
• If iron powder is found, bearings, gears, or clutch plates may be worn.
• If aluminum powder is found, bushing may be worn, or ch ips or burrs of aluminum casting parts may enter.
Check points where wear is found in all cases.
ADJUSTMENT AFTER INSTALLATION
Erase the CVT fluid deterioration data.
INSPECTION AFTER INSTALLATION
• When replacing control valve, perform "ADDITION AL SERVICE WHEN REPLACING CONTROL VALVE OR
TRANSAXLE ASSEMBLY". Refer to TM-127, "
Work Procedure".
• Check the CVT fluid level, condition and leakage.
JSDIA6594ZZ
: Vehicle front
JSDIA1874ZZ
: Vehicle front
JSDIA1884ZZ
Revision: August 2015 2016 Versa Note

cardiagn.com