2016 JEEP WRANGLER lock

[x] Cancel search: lock

Page 218 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual 7. Release the red locking tab by pulling outward to theright. 8. To remove the wiring harness push the tab and pull
downward to disconnect.
Red Locking TabPush Tab To Disconnect
216 UNDERSTANDING THE

Page 232 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual 4. Release the sail panel retainers from the body sidechannel at the rear corners of the vehicle.
NOTE: When releasing the sail panel retainers, it is
helpful to pull down on the rear roof bow. 5. Mak

Page 246 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual 15. Make sure the plastic sleeves are slid rearward overthe Sunrider link to lock in the link (Sunrider Models
only). 16. Unlatch the side bows from both door rails (Sunrider
Models only).
244 UNDERST

Page 258 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual Opening The Sunrider
1. Unclip and move the sun visors to the side.
2. Release the header latches from the loops on thewindshield frame.
3. Make sure to slide the plastic sleeves forward to unlock the

Page 285 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual 6. Ensure that the top locks into the Sunrider lockingmechanisms that are located above the front of the rear
doors. 7. Unclip and move the sun visors to the side.
3
UNDERSTANDING THE FEATURES OF YOUR

Page 294 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual Opening The Sunrider
1. Unclip and move the sun visors to the side.
2. Release the header latches from the loops on thewindshield frame. 3. Make sure to slide the plastic sleeves forward to
unlock the

Page 297 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual Closing The Sunrider
Perform the above steps in the opposite order.
NOTE:Failure to fold the fabric rearward will allow the
material to sag and may block the rearview mirror.
FOLDING WINDSHIELD
The fo

Page 300 of 705

JEEP WRANGLER 2016 JK / 3.G Owners Manual CAUTION!
Do not remove the head impact foam from the side
bars, as damage to the foam may result.
NOTE: Store all of the mounting bolts in their original
threaded holes and tighten for safekeeping.
8.