8
In the event of a breakdown7
C4-2-additif_en_Chap08_en-cas-de-panne_ed02-2015
Turn the sealant cartridge and secure it in the cut-out provided on the compressor.
Remove the valve cap from the tyre to be repaired, and place it in a clean area.
Connect the hose from the sealant cartridge to the valve of the tyre to be repaired and tighten firmly.
Check that the compressor switch is at the" O " position. Uncoil fully the electric cable, stowed under the compressor.
Connect the compressor's plug to the vehicle's 12 V socket. Switch on the ignition.
8
In the event of a breakdown9
C4-2-additif_en_Chap08_en-cas-de-panne_ed02-2015
Connect the compressor's plug to the vehicle's 12 V socket. Switch on the ignition.
Check that the compressor switch is at the " O " position. Uncoil fully the electric cable, stowed under the compressor.
You can also use the compressor, without injecting sealant, to check and if necessary adjust the tyre pressures
Start the compressor by placing the switch at the " I " position and adjust the pressure to the value shown on the vehicle's tyre pressure label. To deflate: press the black button on the compressor pipe, at the valve connector. Once the correct pressure is reached, put the switch to the " O " position. Remove the kit then stow it.
Checking / adjusting tyre pressures
Remove the valve cap from the tyre and place it in a clean area. Uncoil the pipe stowed under the compressor.
Screw the pipe onto the valve and tighten f i r m l y.
